EefaCo.Store HOME STAR MET806 User manual

MET806 PARSONS CHAIR
OPERATING INSTRUCTIONS
WARNING
1. Do not use this product unless all screws and bolts are
securely tightened.
2. Check that all screws and bolts are tight every three months or
as needed.
3. Dispose of packing material properly. Do not use plastic cover
as head covering. It may cause suffocation.
4. Do not use this product as a stepladder.
5. Use this product for its intended purpose only.
6. This product has a 250lb weight limit.
LIMITED WARRANTY
Home Star Products Warrants, to the original purchaser its products to be free from defects in material and workmanship for a period of 90 days.
Defects and damage from misuse, abuse, negligence, alteration, accident, vandalism, rusting, acts of nature or any other event beyond the control
of Home Star Products is not covered. The warranty does not cover cosmetic damage that may result from normal use. Liability for incidental or
consequential damages is excluded. The user assumes all risk of injury resulting from use of this product. This warranty gives you specific legal
rights, and you may also have other rights which vary from state to state.
To make a warranty claim, contact Customer Service, provide model number, sales receipt and description of the problem. It is the customer’s
responsibility to prepay freight on any components returned to the factory. Home Star Products will pay return freight on components covered
under terms of warranty.
Our quality standards are among the highest in the industry. Sometimes, no matter how hard we try, there are times when hardware is missing.
Our Parts Department will do everything possible to promptly remedy the problem.

MET806 PARSONS CHAIR
ASSEMBLY INSTRUCTIONS
© Office Star Products August 2007
PART QTY
1.ª#HAIRª"ACKª
2. 3EATª&RAMEª
3.ª&RONTª,EGª,ªª2ª
4. 3HORTª3CREWª
5. -EDIUMª3CREWª
6. ,ONGª3CREWª
7. ,OCKª7ASHERª
8. &LATª7ASHERª
9. $USTª"ARRIERª
10. !LLENª7RENCHªNOTªSHOWNª
Remove all parts from carton, separate by part numbers indicated on parts list, and
verify part quantities.
STEP 1 Place Chair Back (1) down on a soft surface, Align Seat Frame (2) and secure to
Chair Back (1) using two Long Screws (6), two Flat Washers (8) and two Lock Washers (7) for each corner
block, SEE DETAIL A. Use three Short Screws (4), three Flat Washers (8) and three Lock Washers (7)
to secure center of Seat Frame (2), SEE DETAIL B.
STEP 2 Attach each Front Leg (3L & 3R) inside Seat Frame (2) and secure to corner blocks using two
Medium Screws (5), two Flat Washers (8) and two Lock Washers (7) for each Front Leg (3)
SEE DETAIL C.
STEP 3 Secure Dust Barrier (9) to bottom of Seat Frame (2) using pre-installed hook and loop material.
Turn chair to the upright position, apply firm pressure to align and
FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH (10).
ATTENTION: MAKE SURE ALL SCREWS ARE FULLY
TIGHTENED BEFORE USING CHAIR.
IMPORTANT NOTE:
1. Use hand tools only for assembly as power tools may cause damage
2. Carefully remove any staples used for packaging.
34%0ª
$%4!),ª!



,

2



34%0ªªª
$%4!),ª" $%4!),ª#


