ElectrIQ eiQ-AM09 User manual

USER MANUAL
BLADELESS HEATER WITH AMBIENT LIGHT
eiQ-AM09
White
eiQ-AM09B
Black
Thank you for choosing electriQ
Please read this user manual before using this heater and keep it safe for future
reference.
Visit our page www.electriQ.co.uk for our entire range of Intelligent Electricals
THIS PRODUCT IS ONLY SUITABLE FOR WELL INSULATED SPACES OR
OCCASIONAL USE

Page 2of 10
CONTENTS
SAFETY INSTRUCTIONS
3
FEATURES
5
DIAGRAM
5
OPERATION
6
CONTROL PANEL AND SETTINGS
6
REMOTE CONTROL
7
MAINTENANCE
8
TROUBLE SHOOTING
TECHNICAL DATA
8
9 6
SUPPORT
PRODUCT FICHE
9
10

Page 3of 10
SAFETY INSTRUCTIONS
Important!
Carefully read the instructions before operating the unit
This appliance is for indoor use only.
Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet.
Installation must be in accordance with regulations of the country where the unit is
used.
If you are in any doubt about the suitability of your electrical supply have it
checked and, if necessary, modified by a qualified electrician.
This heater has been tested and is safe to use. However, as with any electrical
appliance - use it with care.
Disconnect the power from the unit before dismantling, assembling or cleaning.
Avoid touching any moving parts within the appliance.
Never insert fingers, pencils or any other objects though the guard
This appliance can be used by Children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be carried out by children.
Children aged from 3 years and less than 8 years shall only switch on/off the
appliance provided that it has been placed or installed in its intended normal
operating position and they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards involved.
Children aged from 3 years and less than 8 years shall not plug in, regulate, or
clean the appliance or perform user maintenance
Children under 3 years should be kept away unless continuously supervised.
Some parts of this product can become very hot and cause burns. Particular
attention has to be given where children and vulnerable people are present.
Do not clean the unit by spraying it or immersing it in water.
Never connect the unit to an electrical outlet using an extension cord. If an outlet
is not available, one should be installed by a qualified electrician.
Never operate this appliance if the unit, cord or plug is damaged. Ensure the
power cord is not stretched, exposed to sharp object/edges, or routed under the
unit.
Any service other than regular cleaning should be performed by an authorised
service representative. Failure to comply could result in a voided warranty.
Never use the plug as a switch to start and turn off the heater. Use the provided
power button located on the control panel.
Do not use an external timer.
Do not cover the air inlet or outlet, or place items close to the unit which may
restrict airflow, as this may present a fire risk.
The heater must not be located immediately below a socket outlet.
Always place the unit on a dry and stable surface. Do not move or tilt the unit
Avoid keeping the unit in direct sunlight for a long period of time.

Page 4of 10
The heater is designed to be used at temperatures above -20°C. If it is exposed
to temperatures below this, it must be allowed to warm above this level before
operation.
Do not attempt to repair, disassemble or modify the appliance. This unit contains
no user-serviceable parts.
Always unplug or disconnect the appliance from the mains power supply when not
in use, or when moving or cleaning it. Do not pull the cord to unplug the heater.
Keep the heater clean. Do not allow any object to enter the ventilation or
exhaust opening as this may cause electric shock, fire, or damage to the heater.
Do not use the appliance for anything other than its intended use. It is designed
for domestic indoor use only.
There may be a trace of odour during the first few minutes of initial use, or after a
period of storage. This is normal and will quickly disappear.
This appliance has hot and arching or sparking parts inside. Do not use it in
areas where gasoline, paint, or any flammable liquids are used or stored.
This appliance is not intended for use in bathrooms, laundry areas and similar
humid locations. Never locate this appliance where it may fall into a bathtub or
otherwise become exposed to water.
The remote contains a lithium battery, keep out of reach of small children. Seek
Medical advice if swallowed.
To prevent battery leakage: Remove the battery from the remote if exhausted or
before long periods of storage.
ENERGY SAVING AND UNIT SAFETY PROTECTION TIPS
Do not cover or restrict the airflow. Do not use in dusty environment.
For safety and maximum performance the minimum distance from a wall or
objects should be 50cm.
WARNING: To reduce the risk of fire or electrical shock, DO NOT use this appliance
with any solid state Speed Control Device or any variable speed controllers.

Page 5of 10
eiQ-AM09 BLADELESS HEATER
FEATURES
Slim design takes minimal space
High Speed Motor with Fan mode and 2 Heat settings
Swing Function
12 hour standby timer.
Remote Control allowing all functions to be changed.
Built in ambient light.
DIAGRAM
Air Outlet
Power Switch
Control
Panel
Base
Air Inlet
Filter Panel
Lamp

Page 6of 10
OPERATION
Your heater may be operated by using either the manual controls located on the front of the fan or by
your remote control.
POWER SWITCH ON THE BACK OF THE UNIT
Used to turn the bladeless heater ON and OFF. This should be used to turn off the appliance before
leaving unattended.
CONTROL PANEL AND SETTINGS
ON/OFF BUTTON
Used to turn the bladeless heater ON and OFF.
SWING BUTTON
Press to turn the Swing function on and off. When it is operational the horizontal direction of the airflow
is slowly moved from side to side and the Swing indicator will be illuminated
MODE BUTTON
Press to cycle through the three available modes: Fan , Low Heating and High Heating
TEMP BUTTON
Press repeatedly to increase the desired room temperature. After pressing the temp button the desired
temperature will flash for 3 seconds, before the unit reverts to showing the room temperature. When the
desired temperature has been reached the unit will change into fan mode. The temperature range is
16°C - 40°C
TIMER BUTTON
Press repeatedly to increase the running time in 1 hour intervals. The timer can be set between 1 hour
and 12 hours. The display will show the duration currently set. When the display is showing the timer
duration the symbol will illuminate next to the timer. To cancel the timer repeatedly press the timer
button until 00 is shown.
COLOUR BUTTON
Press to cycle through the options for the ambient light –Off, White, Green, Purple or Blue. The light
can be operated independently to the fan.

Page 7of 10
REMOTE CONTROL
Your bladeless heater is supplied with a remote,
which allows full control of all the unit’s functions.
ON/OFF: Turns the fan On and Off
MODE: Cycles between Fan, Low Heat and High
Heat.
TIMER: Press repeatedly to set the Off timer in 1
hour intervals. The time set will be displayed on the
unit.
SWING: Press to turn the Swing Function On and
Off.
LIGHT: Press to change the ambient light between
Off, Green, Purple and Blue.
TEM+: Press to increase the desired room
temperature.
TEM-: Press to decrease the desired room
temperature.
REPLACING THE BATTERIES
The remote control is powered by a Lithium Button Cell Battery (CR2025). Should
the remote become unresponsive, replace the battery following the instructions
below:
1. Turn over the remote and press tab A to the right.
2. Slide out the battery tray B
3. Replace the battery with the same type, ensuring the positive side is facing
upwards.

Page 8of 10
MAINTENANCE
CLEANING AND STORAGE
ATTENTION: Please shut off the unit and unplug from the mains before
cleaning or performing any maintenance.
Cleaning the surface
Clean the heater with a duster or a soft wet cloth.
Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may
cause irreversible damage. Make sure no water enters the control panel or gaps in the
casing.
Do not run the unit until completely dry.
Place the heater in its original box or cover to protect it from dust when not in use.
Store it in a cool dry place.
TROUBLESHOOTING
Do not repair or disassemble the unit by yourself, unauthorized repair attempts will
invalidate the warranty and may cause bodily harm.
Issue
Possible Reason
Solution
No power
1. Power cord is unconnected
2. There is no power from socket
3. The power switch on the rear of the unit
is turned off.
1. Connect the power cord
2. Check socket is turned on
3. Ensure the power switch on
the rear of the unit is in the On
position
Odour
emission
from unit
1. New unit. When the unit is used for the
first time the fan motor may produce and
odour which will dissipate within a week of
use
1. No action required
Strong
vibrations
and noise
1. Unit is not places on a flat surface
2. Unit may be damaged
1. Place on a flat surface. May
put an anti-vibration mat
underneath
2. If the heater is damaged
discontinue use and contact
the service centre.
If the above solutions do not resolve the problem please contact the service centre.

Page 9of 10
TECHNICAL DATA
electriQ UK SUPPORT
www.electriQ.co.uk/support
Please, for your own convenience, make these simple checks before calling the
service line.
If the unit still fails to operate call: 0871 620 1057 or complete the online form
1. Is the unit plugged into the mains?
2. Is the fuse OK?
3. Switch the unit off and wait three minutes to see if the issue is resolved. Restart
the unit.
Office hours: 9AM - 5PM Monday to Friday
www.electriQ.co.uk
Unit J6, Lowfields Business Park
Lowfields Way, Elland
West Yorkshire, HX5 9DA
APPENDIX
Disposal: Do not dispose this product as unsorted municipal waste. Collection of such
waste must be handled separately as special treatment is necessary.
Recycling facilities are now available for all customers at which you can
deposit your old electrical products. Customers will be able to take any old
electrical equipment to participating civic amenity sites run by their local
councils. Please remember that this equipment will be further handled during
the recycling process, so please be considerate when depositing your
equipment. Please contact the local council for details of your local
household waste recycling centres.
Model
eiQ-AM09 / eiQ-AM09B
Cable length
1.5 meters
Rated Input
2 KW
Power Supply
220-240V/50Hz
Net Weight
3.0Kg
Dimensions
570mm x 290mm x 170mm

Page 10 of 10
PRODUCT FICHE
Model Identifier: eiQ-AM09 / eiQAM09B
Item
Symbol
Value
Unit
Item
Unit
Heat Output
Type of heat input, for electric storage local space
heaters only (select one)
Nominal heat
output
Pnom
2.0
kW
manual heat charge control, with integrated
thermostat
No
Minimal heat
output
Pmin
1.0
kW
manual heat charge control with room and/or
outdoor temperature feedback
No
Maximum
continuous
heat output
Pmax
2.0
kW
electronic heat charge control with room
and/or outdoor temperature feedback
No
Auxiliary electricity consumption
fan assisted heat output
No
At nominal
heat output
elmax
2.09
kW
Type of heat output/room temperature control
(select one)
At minimum
heat output
elmin
0.89
kW
single stage heat output and no room
temperature control
No
In standby
mode
elSB
0.329
W
two or more manual stages, no room
temperature control
No
with mechanical thermostat room
temperature control
No
with electronic room temperature control
Yes
with electronic room temperature control plus
day timer
No
with electronic room temperature control plus
week timer
No
Other control options (multiple selections
possible)
room temperature control with presence
detection
No
room temperature control, with open window
detection
No
with distance control option
No
with adaptive start control
No
with working time limitation
No
with black bulb sensor
No
Contact
Details
electriQ, Unit J6, Lowfields Business Park, Lowfields Way, Elland,
West Yorkshire, HX5 9DA
V20190508