Elgento E19019N User manual

CAN & BOTTLE OPENER
WITH INTEGRATED
KNIFE SHARPENER
MODEL E19019N
YOUR SAFETY &
INSTRUCTION MANUAL
PLEASE READ CAREFULLY
www.elgento.co

2
CUSTOMER SUPPORT TEAM: [phone]
TECHNICAL DATA
Description: Can & Bottle Opener with Integrated Knife Sharpener
Model: E19019N
Rated Voltage: 220 - 240V
Frequency: ~ 50/60Hz
Power consumption: 80W
DOCUMENTATION
We declare that this product conforms to the following product legislation in accordance with the
following directive(s):
2004/108/EC Electromagnetic Compatibility Directive.
2006/95/EC Low Voltage Directive.
2011/65/EU Restriction of Hazardous Substances Directive.
1935/2004/EC Materials & Articles in Contact With Food (LFGB section 30 & 31).
RKW Quality Assurance, United Kingdom
WARRANTY
This product is guaranteed for 12 months from the date of original purchase. If any defect arises due
to faulty materials of workmanship, the faulty products must be returned to the place of purchase.
Refund or replacement is at the discretion of the retailer.
The following conditions apply:
• The product must be returned to the retailer with proof of purchase.
• The product must be installed and used in accordance with the instructions contained in this
instruction guide.
• It must be used only for domestic purposes.
• It does not cover wear and tear, damage, misuse or consumable parts.
• RKW has limited liability for incidental or consequential loss or damage.
• This guarantee is only Valid in the UK and Eire Only.
An extended warranty is available for this appliance.
See back page for details.

3
www.elgento.co
WIRING SAFETY FOR UK USE ONLY
IMPORTANT
As the colours in the
mains lead of this
appliance may not
correspond with the
coloured markings
identifying the terminals
in your plug, please
proceed as follows:
The wires in the mains lead are coloured in
accordance with the following code:
Blue neutral [N] Brown live [L]
Plug Fitting Details (Where Applicable).
The wire coloured blue is the neutral and must be
connected to the terminal marked [N] or coloured
black.
The wire coloured brown is the live wire and
must be connected to the terminal marked [L] or
coloured red.
On no account must either the brown or the blue
wire be connected to the [EARTH] terminal .
Always ensure that the cord grip is fastened
correctly.
The plug must be tted with a fuse of the same
rating already tted and conforming to BS 1362
and be ASTA approved.
If in doubt consult a qualied electrician who will
be pleased to do this for you.
Non-Rewireable Mains Plug
If your appliance is supplied with a non-rewireable
plug tted to the mains lead and should the fuse
need replacing, you must use an ASTA approved
one (conforming to BS 1362 of the same rating).
If in doubt, consult a qualied electrician who will
be pleased to do this for you.
If you need to remove the plug - disconnect it
from the mains - and then cut it o the mains
lead and immediately dispose of its safely. Never
attempt to reuse the plug or insert it into a socket
outlet as there is a danger of an electric shock.
WARNING:
This appliance is double insulated. Do not connect any wire to the earth terminal.

4
CUSTOMER SUPPORT TEAM: [phone]
PRODUCT SAFETY
When using any electrical appliance, basic safety precautions should
always be followed including the following:
• Check that the voltage of the
main circuit corresponds with
the rating of the appliance
before operating.
• Please ensure that the
appliance is used on a stable,
level, and heat resistant
surface.
• Do not immerse cords, plugs
or any part of the appliance in
water or any other liquid.
• Do not leave the appliance
unattended while it is operating.
• Close supervision is necessary
when any appliance is used by
or near children or pets.
• This appliance can be used
by children aged from 8 years
and above and persons with
reduced physical, sensory or
mental capabilities or lack of
experience and knowledge
if they have been given
supervision or instruction
concerning use of the appliance
in a safe way and understand
the hazards involved.
• Children shall not play with the
appliance.
• Cleaning and user maintenance
shall not be made by children
without supervision.
• Switch o at the wall socket
then remove the plug from
the socket when not in use or
before cleaning.
• If the supply cord or appliance
is damaged, stop using the
appliance immediately and seek
advice from the manufacturer
or its service agent or a similarly
qualied person.
• Do not let the cord hang over
the edge of a table or counter
or let it come into contact with
any hot surfaces.
• The use of accessory
attachments is not
recommended by the appliance
manufacturer, apart from those
supplied with this product.
• Do not pull the plug out by the
cord as this may damage the
plug and/or the cable.
• Do not use this product for
anything other than its intended
use.
• This appliance is for household
use only.
• Do not carry the appliance by
the power cord.
• Do not use the appliance
outdoors.

5
www.elgento.co
• Do not let the cord hang over
edge of table or counter-top to
touch hot surfaces.
• Do not open pressurized
(aerosol-type) cans.
• Do not open cans of ammable
liquid such as lighter uids.
• Do not use can opener for other
than intended use or leave
unattended while in use.
• In the unlikely event the
appliance develops a fault,
stop using it immediately and
seek advice from the service
department.
HIGH VOLTAGE ROTATING PARTS

6
CUSTOMER SUPPORT TEAM: [phone]
5
6
2
4
1
3
WHAT’S IN THE BOX
Instruction Manual
Can & Bottle Opener
1. Lever
2. Magnetic Lid Holder
3. Drive Wheel
4. Bottle Opener
5. Knife Sharpener (not shown)
6. Cord Storage (not shown)
Knife Sharpener Bottle Opener Cord Storage
BEFORE YOUR FIRST USE:
1. Remove your appliance from the packaging.
2. Your appliance is now ready for normal use.
3. Dispose of the packaging in a responsible manner.
Dispose of the packaging in a responsible manner.

7
www.elgento.co
USING YOUR APPLIANCE:
1. Plug the Can Opener in.
2. Raise the lever into the upright position.
3. Insert the can so that the lower edge of
the can lip rests on top of the drive wheel.
Ensure that the cutting edge is on the
inside of the can lip.
4. Push the can opener lever down rmly
until the can is fully open. When the
can is fully open, the cutting action will
automatically stop. The can will remain in
position until the lever is raised.
5. To release the can, grasp the can rmly
in one hand and raise the lever with the
other hand. The magnetic lid holder will
retain the lid.
CAUTION! When removing the lid there
may be some sharp edges. Do not touch
them to avoid injury.
Dented Cans:
Dented cans may cause the can opener to
stall. If this happens, grasp the dented can and
guide it through the cutting action manually until
the damaged areas are passed.
Jammed Cans:
To open a can that has become jammed, raise
the can opener lever and release the can. Begin
the cutting action again in a new place on the
can lip.
USING AS A KNIFE SHARPENER:
1. Ensure the knife is clean and free of
grease.
2. Place heel of knife into the guide slot
located on the back of can opener.
Note: It may help for the can opener to placed
sideways while using the knife sharpener.
3. Press the lever down and lightly draw
the blade towards you, applying slight
downward pressure.
Note: Do not let the knife cut into the body of
the can opener.
4. Repeat this procedure six to seven times
to sharpen the knife.
Do not attempt to sharpen hollow ground
blades or those with serrated edges.
The grinding wheel may jam if too much
pressure is applied on the knife. Lift the knife
slightly to release the wheel.
USING AS A BOTTLE OPENER:
1. Ensure the bottle cap is clean.
2. Hold the bottle and put the cap in to the
metal hooks.
3. Pull bottle down to remove the cap.
Note: The bottle opener will only remove metal
bottle caps.
When opening tall bottles, the unit should
be used towards the edge of a work top.

8
CUSTOMER SUPPORT TEAM: [phone]
CLEANING & CARE
• Before cleaning, unplug the cord from
outlet.
• All removable parts on the can opener
should be detached and cleaned
thoroughly in warm, soapy water.
• Do not immerse the motor housing in
water.
• Clean the drive wheel by wiping it with a
damp cloth.
HOW TO CLEAN THE BLADE ASSEMBLY:
1. Unplug cord from outlet. Lift the lever to
the vertical position. Hold the can opener
and ease the cutting assembly out of the
case. Wash in hot, soapy water. Rinse
and dry.
2. To replace blade assembly, hold the
lever in vertical position. Insert shaft
into keyhole. Push the lever in all the
way. Rotate the lever clockwise until it
is horizontal. If the lever is in the correct
position, it cannot be removed from can
opener when in the horizontal position.
Hint: The cutting mechanism may collect
food or paper from can labels and should be
washed frequently.
WARNING:
DO NOT IMMERSE ANY PART OF THE
APPLIANCE IN WATER
DISPOSAL OF THE UNIT
Appliances bearing the symbol shown here
may not be disposed of in domestic rubbish.
You are required to dispose of old electrical
and electronic appliances like this separately.
Please visit www.recycle-more.co.uk or
www.recyclenow.co.uk
for access to information about the recycling
of electrical items.
Please visit www.weeeireland.ie for access to
information about the recycling of electrical
items purchased in Ireland.
The WEEE directive, introduced in August
2006, states that all electrical items must be
recycled, rather than taken to landll.
Please arrange to take this appliance to your
local Civic Amenity site for recycling, once it
has reached the end of its life.

9
www.elgento.co
NOTES

10
CUSTOMER SUPPORT TEAM: [phone]
NOTES

11
www.elgento.co
NOTES

We hope you enjoy your appliance for many years.
As a thank you for purchasing one of our fantastic products,
we are giving you an extra years peace of mind.
To receive your extra years guarantee, register your appliance online by visiting
www.elgento.co
Should you have a problem
with your appliance or need any spare parts please call our
Customer Support Team on:
[phone]
Distributed throughout the UK by RKW LTD
0717.V2