Elite Screens Tab-Tension Series User manual

V06202023DT (DS0263)
www.elitescreens.com
1
ezCinema 2 / ezCinema Tab-Tension Series
Portable Floor Pull-Up Projector Screen
USER’S GUIDE –E/H Type
V1.0
Product Description
Thank you for purchasing the ezCinema 2 / ezCinema Tab-Tension portable free-standing projector
screen. The ezCinema 2 / ezCinema Tab-Tension is a pull-up screen that conveniently raises and
retracts using a scissor-back mechanism which allows the screen to promptly be setup and taken down
in seconds.
Precautions:
Warning! Screen damage can result from product mishandling if the following
precautions are not followed.
•In accordance with practicing home fire safety and avoiding screen damage, do not place the
screen near or beside a fireplace or high temperature objects such as a gas stove, BBQ or
heater.
•Place the screen beyond the reach of children.
•Do not use the screen in a very strong windy environment.
•Do not use on uneven surfaces.
•The screen must be placed in horizontal position on a level ground, avoid placement screen
upright.

V06202023DT (DS0263)
www.elitescreens.com
2
Lock Buckle
Front
Black Masking
Border
Feet
Housing
Upper Scroll bar
Projection
Viewing Area
Back
Box Cover (Lid)
Bottom Black
Masking
Pull-up Handle
Pull-up handle
cross-spring riser
PARTS IDENTIFICATION
IMPORTANT:
- Do not keep the screen open during strong wind.
- The screen must be placed in a horizontal position on a level ground.
SETTING UP THE SCREEN
ezCinema is designed to be used as an easy-to-operate portable screen for a variety of presentation
environments. Its design makes itversatile enough to be used in classrooms, conference rooms, homes,
or courtyard presentations. When packed, the unit can be easily carried and opened for projection
presentations in seconds. As a rule, the portable projector screen should be installed in an area
free of wind and sources of heat or open flame (such as heaters, grills or firework displays).
Extend base feet:
Locate the base feet on the bottom of the box at each end and rotate them clockwise until they form
right angles.
Open the box cover:
Unlatch the buckles on both ends of the box and open the box cover.

V06202023DT (DS0263)
www.elitescreens.com
3
PULLING UP THE SCREEN
CORRECT USE
• PULL UP THE SCREEN BY THE HANDLE UNTIL IT IS FULLY
EXTENDED
INCORRECT USE
• NEVER USE THE SCREEN UNLESS IT IS FULLY
EXTENDED PASSED THE VIEWING AREA SO IT DOES NOT
RETRACT ON ITS OWN.
• THE SCREEN IS SUSCEPTIBLE TO RETRACTING ON ITS
OWN AND CAN CAUSE INJURY.
• PRODUCT DAMAGE CAN ALSO OCCUR WHICH IS NOT
COVERED BY OUR STANDARD WARRANTY.
Flexible Upright Support
The ezCinema 2 / ezCinema Tab-Tension utilizes a cross-
spring riser that facilitates its free-standing operation. When
the mechanism expands to its full height, the screen may
develop a slight forward tilt. This is a natural feature to
enhance surface tension and stability. The best results are
achieved with a tabletop-mounted projector and a flat, level
floor for the screen.
Hold the rod handle with both hands and slowly pull up the
screen vertically; you can decide the size of the lower black
border according to your needs, such as the need to raise
the curtain to the highest position to allow the audience to
see the screen from afar, and then hold both sides of the
support rod with both hands, and push upward with
both hands at the same time to the highest.
The screen can be positioned as shown below as long
as it is passed the viewing area.
up
up

V06202023DT (DS0263)
www.elitescreens.com
4
PUTTING SCREEN AWAY
Retract the screen into case:
Hold the top handle of the screen with your hand and slowly press the screen vertically downward.
Keep your hand on the top handle until the screen is fully engaged in the housing.
Closing it up:
Cover the top cover of the outer cover back to the buckle cover, both sides of the latch lock.
Draw the base feet back:
Rotate the feet so that it is parallel to the outer cover.
The following points should be noted to assure the sound performance of the screen:
1. Never use your hand to touch the screen surface.
2. Never write on the screen with pens, pencils, markers, etc.
3. Don't touch the screen with hard or sharp objects.
4. Please use a clean cotton cloth or soft dust brush to remove any dust particles on the screen.
5. The screen material may be cleaned with mild soap and water on a soft cloth.
6. Avoid using or storing the screen in extreme temperatures and direct sunlight.
7. The screen must be placed in horizontal position on a level ground, avoid placement screen upright.
For more information, technical support or your local Elite Screens
contact, please visit www.elitescreens.com