emerio FH-121976 User manual

- 1 -
Content –Inhalt –Contenu –Contenuto
Instruction manual –English ......................................................................................- 2 -
Bedienungsanleitung –German ...............................................................................- 10 -
Mode d'emploi –French ..........................................................................................- 20 -
Manuale d'istruzioni –Italian...................................................................................- 29 -

- 2 -
Instruction manual –English
Thank you very much for purchasing our products. In order to
ensure correct operation, please read this manual and
instruction carefully before use.
This product is only suitable for well insulated spaces or
occasional use.
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock,
burns and other injuries.
1. Read and save these instructions. Attention: pictures in the
IM are for reference only.
2. This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the
hazards involved.
3. Children shall not play with the appliance.
4. Cleaning and user maintenance shall not be made by
children without supervision.
5. Children of less than 3 years should be kept away unless
continuously supervised.
6. Children aged from 3 years and less than 8 years shall only
switch on/off the appliance provided that it has been placed
or installed in its intended normal operating position and
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the
hazards involved. Children aged from 3 years and less than
8 years shall not plug in, regulate and clean the appliance or
perform user maintenance.
7. CAUTION —Some parts of this product can become very
hot and cause burns. Particular attention has to be given

- 3 -
where children and vulnerable people are present.
8. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.
9. This appliance is intended to be used in household and
similar applications.
10.WARNING: In order to avoid overheating, do not cover the
heater.
11.The heater must not be located immediately below a socket
outlet.
12.Do not use this heater in the immediate surroundings of a
bath, a shower or a swimming pool.
13.Make sure the appliance is in good condition after remove
it from the package.
14.Check your mains voltage; it must match the specification of
this heater.
15.Check the power cord and plug carefully before use to
ensure that they are not damaged.
16.Be sure the power is turned off before unplugging the heater.
Do not touch the plug with wet hands.
17.Don't cover the heater.
18.Don't allow moisture and dust to enter the appliance. Don't
use this heater in bathrooms or laundries. Store it in dry
areas.
19.Don't put the heater on soft surfaces such as beds or sofas.
20.Keep children away from the package. Polyethylene bags
can be dangerous.
21.Avoid using extension cords, as they may cause a fire hazard
due to overheating.
22.Indoor use only.
23.Do not allow the power cord to hang (e.g over the edge of
a table or counter) or place/run the power cord under rugs,
carpeting, or in high-traffic areas where it may be tripped
over or pulled.
24.Do not plug or unplug the appliance from the electrical
outlet with a wet hand.

- 4 -
25.Do not put any stress on the power cord where it connects
to the appliance, as the power cord could fray and break.
26.Keep the power cord and product always away from heated
surfaces.
27.Do not insert any other objects into the heater, as it may
cause an electric shock, fire or damage to this appliance.
28.Do not use this appliance to dry or heat clothing, shoes,
pipes or any other items.
29.Use the appliance in a well-ventilated area, this heater is hot
when in use, to avoid burns, do not let bare skin touch a hot
surface, if provided, use handle when moving this heater,
keep combustible materials, such as furniture pillows,
bedding, paper, clothes, and curtains at least 4 feet ( 1.2
meters) from all sides of the heater.
30.Use this heater only as described in the manual, any other
use not recommended by the manufacturer may cause fire,
electric shock or personal injury.
31.The appliance should not be operated by means of an
external timer-switch or by means of a separate system with
remote control not originally belonging to this appliance.
32.This heating device is not suitable for assembling in vehicles
and machines.
33.This appliance is not a toy.
34.Do not immerse the unit in water.
35.To avoid the risk of fire or electric shock do not remove the
housing.
36.Any servicing other than cleaning and user maintenance
should be performed by an authorized service
representative only.
37. Means “DO NOT COVER “.

- 5 -
FH-121976 EN
PARTS DESCRIPTION
1. Control panel
2. Digital display
3. Remote control
4. Air outlet
5. Base
6. Air inlet
7. Indicator light
8. Power switch
Control panel
1. On/off button
2. Power setting button
3. Oscillation button
4. Timer setting button
5. Temperature adjustment button (for increase)
6. Temperature adjustment button (for decrease)
OPERATION
Plug in the appliance into an appropriate electrical outlet. Turn on the appliance by pressing the power switch.
A beep sound will be heard. The appliance is standby with the current room temrature illuminating on the digital
display. Press the on/off button on the control panel to start setting your heater.
1. On/off button
Press the button “ ” to run your heater in ventilation mode with icon “ ” illuminating on digital display.
The digital display shows the room temperature. Press the button “ ” again, the appliance will enter into
standby condition. If the appliance is heating, it will count down 30 seconds before turned into standby mode,
in order to cool the inside off and protect the components. (If you press into the ventilation mode during this
count-down and then press the button “ ” again, the appliance will resume the count-down unfinished last
time before the appliance goes into standby.)
2. Adjustment button
You can press the button “ ” or “ ” to adjust temperature setting. The default is 25℃and you can set your
desired temperature from 10℃to 49℃. The set temperature flashes for several seconds and then the display
shows again the room temperature. The heater will automatically stop working when the set temperature is
reached and resume working when the room temperature is lower than the set temperature.

- 6 -
3. Power setting button
Under working condition, you can press button “ ” to switch the power setting between low heating power
and high heating power.
-Low heating power: Icon “ ” will be shown on the digital display.
-High heating power: Icon “ ” will be shown on the digital display.
The heater works on low heating power when the room temperature is 0-2℃lower than the set temperature.
The heater works on high heating power when the room temperature is 4-5℃lower than the set temperature.
4. Oscillation button
Under working condition, you can press button “ ” to activate or deactivate the swing function. The digital
display will show icon “ ” lighted on when swing function is activated.
5. Timer button
Under working condition, you can press button “ ” to set timer.
Press the button “ ” once, the appliance enters the timer setting mode. You can press “ ” to adjust the
timer from 0 –8H (each press changes the value of one hour and “0H” means no timer). The corresponding timer
value will be shown on the digital display. The set timer will be activated in 5 seconds without any other operation
and then the digital display will show back the room temperature. The icon “ ” on the display indicates the
timer has been set. When the timer is counting down to 0 (not shown on the display), the appliance will stop
working automatically (a beep sound will be sent out) and enter standby mode.
Note:
If no operation for 10 minutes, the digital display and indicator light will go out. Press once any one of the
buttons can make the display and indicator light come back.
The heater will remain hot for some time after it is turned off; handle it with care.
REMOTE CONTROL
This unit has a remote control. One piece of CR2025 battery should be used for it. The functions of the remote
control buttons are the same as of the buttons on the control panel. Follow the illustration on the back of the
remote control to place or remove battery. Pay attention to the battery polarity when placing the battery.
SAFETY SYSTEM
The appliance has a safety system which automatically switches off the unit when overheated.
If overheating occurs, switch off the appliance, remove the plug from the socket, and let it cool down for at
least 30 minutes. Put the plug in the socket and switch on the heater.
This heater is equipped with a tilt protection safety device. For safety reasons, the unit will automatically
switch off the power if it is put on unstable or uneven surfaces or if it is tilted accidentally.

- 7 -
CLEANING AND MAINTENANCE
Before maintaining, please unplug the appliance and make sure the heater has cooled down completely.
Please use soft cloth to wipe the dust on the appliance’s surface.
Do not use gasoline, thinner and any other abrasive cleaners to clean the appliance, as these can damage
the surface of appliance.
Make sure the appliance is cooled and dried before packaging. Store it in dry and ventilated places.
TECHNICAL DATA
Operation voltage: 220-240V ~ 50Hz
Power: 2200W
GUARANTEE AND CUSTOMER SERVICE
Before delivery our devices are subjected to rigorous quality control. If, despite all care, damage has occurred
during production or transportation, please return the device to your dealer. In addition to statutory legal rights,
the purchaser has an option to claim under the terms of the following guarantee:
For the purchased device we provide 2 years guarantee, commencing from the day of sale. If you have a defective
product, you can directly go back to the point of purchase.
Defects which arise due to improper handling of the device and malfunctions due to interventions and repairs
by third parties or the fitting of non-original parts are not covered by this guarantee. Always keep your receipt,
without the receipt you can’t claim any form of warranty. Damage caused by not following the instruction manual,
will lead to a void of warranty, if this results in consequential damages then we will not be liable. Neither can we
hold responsible for material damage or personal injury caused by improper use if the instruction manual is not
properly executed. Damage to accessories does not mean free replacement of the whole appliance. In such case
please contact our service department. Broken glass or breakage of plastic parts is always subject to a charge.
Defects to consumables or parts subjected to wearing, as well as cleaning, maintenance, replacement of said
parts or shipping and transportation costs to and from any place of repair are not covered by the warranty and
are to be paid.
ENVIRONMENT FRIENDLY DISPOSAL
Recycling –European Directive 2012/19/EU
This marking indicates that this product should not be disposed with other household wastes. To
prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle
it responsibly to promote the sustainable reuse of material resources. To return your used device,
please use the return and collection systems or contact the retailer where the product was purchased. They can
take this product for environmentally safe recycling.
BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY. DO NOT OPEN. DO NOT DISPOSE
OR IN FIRE OR SHORT CIRCUIT.
Emerio Switzerland AG
Sihlbruggstrasse 107
6340 Baar
Switzerland

- 8 -
ERP information (EN)
Supplier: Emerio Switzerland AG
Sihlbruggstrasse 107
6340 Baar
Switzerland
Declare that the product detailed below:
Information requirements for electric local space heaters
Model identifier(s):
Item
Symbol
Value
Unit
Item
Unit
Heat output
Type of heat input, for electric
storage local space heaters only
(select one)
Nominal heat
output
Pnom
2,2
kW
manual heat charge control, with
integrated thermostat
[no]
Minimum heat
output
(indicative)
Pmin
0
kW
manual heat charge control with
room and/or outdoor temperature
feedback
[no]
Maximum
continuous heat
output
Pmax,c
2,2
kW
electronic heat charge control with
room and/or outdoor temperature
feedback
[no]
Auxiliary
electricity
consumption
fan assisted heat output
[no]
At nominal heat
output
elmax
0
kW
Type of heat output/room temperature
control (select one)
At minimum heat
output
elmin
0
kW
single stage heat output and no
room temperature control
[no]
In standby mode
elSB
0,000
kW
Two or more manual stages, no
room temperature control
[no]
with mechanic thermostat room
temperature control
[no]
with electronic room temperature
control
[yes]
electronic room temperature
control plus day timer
[no]
electronic room temperature
control plus week timer
[no]
Other control options (multiple selections
possible)
room temperature control, with
presence detection
[no]
room temperature control, with
open window detection
[no]

- 9 -
with distance control option
[no]
with adaptive start control
[no]
with working time limitation
[yes]
with black bulb sensor
[no]
Contact details
Emerio Switzerland AG
Sihlbruggstrasse 107
6340 Baar
Switzerland
Satisfies the requirement of the Council Directives:
COMMISSION REGULATION (EU) No 2015/1188 of 28 April 2015 and Amending COMMISSION
REGULATION (EU) 2016/2282 implementing Directive 2009/125/EC of the European Parliament and of
the Council with regard to ecodesign requirements for local space heaters
Regarding information for consumers on how to install, use and maintain the product, WEEE
information, please check the instruction manual provided with packaging.