Ercol Ancona 5155 User manual

5155 Ancona Medium Side Table
Thank you for purchasing this Ancona side table. Please read the instructions carefully before use to ensure
safe and satisfactory operation of this product.
Pre- assembly preparation
Please ensure instructions are read in full before attempting to assemble this product
This item is HEAVY
Please check the pack contents before attempting to assemble this product.A full checklist of components is
given in this leaflet. If any components are missing, please contact the retailer from whom you purchased this
product.
This product is HEAVY, it should be assembled as near as possible to the point of use. TAKE CARE
WHEN LIFTING to avoid personal injury and (or) damage to the product.
This product takes approximately 20 MINUTES to assemble with 2 PEOPLE.
The fittings pack contains SMALL ITEMS which should be KEPT AWAY FROM YOUNG
CHILDREN.
Ref: 00237/5155,5156
5156 Ancona Tall Side Table

Fittings and parts checklist
ATop Panel x 1 Allen key x 1
Column x 1
Base panel x 1
65mm Bolt x 1
B
C
D
E
B
C
A

1. Insert the column(B) into the base panel (C) as shown below. Please be aware the dowels are different sizes
and need to be matched to the correct size hole in the base. No fittings are required for this step.
Step by step assembly instructions
Use the allen key(D) to fix the the 65mm bolt (E) onto the base panel C as shown below.
Tighten the bolt to make sure they are held in place well.
.2
Fittings
B
Cφ6φ8
Fittings
E * 1
D*1 E

PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
Ercol Furniture Ltd, Summerleys Road, Princes Risborough, Buckinghamshire. HP27 9PX www.ercol.com
3. Attach the top panel (A) onto the column (B) using the pre-drilled bolt in the column.
Twist the top panel onto the column until they are securely connected.
Please see the illustration below.
If the table is not level on your floor use the wedges provided, and snap them off so that they do not protrude
out from the base panel. you can also snap them lengthways if desired.
Fittings
A