Ercol Teramo 2610 User manual

ercol
Pre-assembly preparation
Please ensure instructions are read in full before attempting to assemble this product
Necessary Tools
This item is HEAVY
Please check the pack contents before attempting to assemble this product. A full checklist of components
is given in this leaflet. If any components are missing, please contact the retailer from whom you bought
this product.
This product is HEAVY, it should be assembled as near as possible to the point of use. TAKE CARE
WHEN LIFTING to avoid personal injury and (or) damage to the product.
This product takes approximately 30 MINUTES to assemble with 2 PEOPLE.
The fittings pack contains SMALL ITEMS which should be KEPT AWAY FROM YOUNG
CHILDREN.
teramo 2610 Dressing Table
Thank you for purchasing this teramo dressing table. Please read the instructions carefully before use to ensure safe
and satisfactory operation of this product. Installation shall be carried out exactly according to the manufacturers
instructions, otherwise a safety risk can occur if incorrectly installed.
WARNING: In order to prevent overturning this product must be used with the wall attachment device provided.

Fittings and parts checklist
A Top & Drawer box x 1
H B Left leg x 1
I
C Right leg x 1
J
Brackets x 2
D Left mirror support x 1
K
Strap x 1
E
Screws x 1
F Mirror x 1
Wedge x 2
G
M6*30 Bolt x 12
Allen key x 1
Right mirror support x 1
L

1. Take the drawer out of the drawer box(A) unit as shown below.
t(A)inuxobrewardehte left leg(B) and right leg(C) ontohthcattA.2 using M6*30 bolt(K) 8pcs as shown
Step by step assembly instructions
below.

3. Attach the left mirror support(D) and right mirror support(E) onto the drawer box unit(A) using the 4pcs
M6*30 bolt(K) as shown below.
Put the mirror(F) onto the mirror supports(D&E) as shown below.
.
4
Rotate the dials on the support rial to adjust the mirror angle.

5. Put back 2pcs drawers into the drawer box unit (A) and assembly steps finished.

Wall fixing - if in doubt seek professional advice
Wood
If fixing to wood
make sure that it
isn’t chipboard as
screws can easily pull
away from the core
structure
Brick or Masonry
Use an appropriate
wall plug provided you
are sure your wall is
sound
Cavity wall
Special toggle
wall plugs are
needed. Seek
expert advice
.6
7. Attach the wall bracket using screws suitable for your type of wall, see Wall fixings above.
8. Place the dressing table back against the wall so the two brackets match up and tie them together with
the plastic strap provided. The plates need not match exactly, but the plastic tie must go through
each plate. Close the strap, but do not over tighten it. See diagrams below.
See fig 1 below. Screw one of the brackets on to the back of the table in the middle, using the short
screws provided. Make sure the TOP OF THE BRACKET IS BELOW the top of the table . Position the
table against the wall where you want it to go, place the second bracket onto the wall below the one
fixed to the table and mark where the holes come on the wall. Move the table away from the wall.

9. If the dressing table is not level on your floor, use the wedges provided. Snap them off so they do not
protrude out from the table legs. You can also snap them lengthways.
.
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
Ercol Furniture Ltd, Summerleys Road, Princes Risborough, Buckinghamshire. HP27 9PX www.ercol.com