Ercol Novoli 4351 User manual

Novoli 4351 medium pedestal
extending dining table
Thank you for purchasing this Novoli medium dining table. Please read the instructions carefully before use to en-
sure safe and satisfactory operation of this product.
This item is HEAVY
Pre-assembly preparation
Please ensure instructions are read in full before assembling this product.
Please check the pack contents before assembling this product. A full checklist of components is given in this leaflet.
If any components are missing, please contact the retailer from whom you bought this product.
This product is HEAVY, it should be assembled as near as possible to the point of use. TAKE CARE WHEN
LIFTING to avoid personal injury and (or) damage to the product.
This product takes approximately 20 minutes to assemble with 2 PEOPLE.
The fittings pack contains SMALL ITEMS which should be KEPT AWAY FROM YOUNG CHILDREN.

Fittingsandpartschecklist
1
allen key 6mm
2
allen key 4mm
3
60mm connector bolts x 4
4
40mm connector bolts x 8
5
connector bolts x 4
6
cams x 4
Stepby stepinstructions
Connector bolts to be screwed into the 2 inserts in
the leg assemblies
The connector cams need to be inserted into the
underside of both rails.
Ensure that the marks on the outer casing of the cam
and the arrow on the central part of the cam are
pointing to the end of the rails. This lines the fitting
up correctly to allow the connector bolt to meet
with the cam during assembly.

Fix the first leg assembly to the under frame with 6 of the
bolts provided. Tighten all the way with the allen key.
The 60mm bolts are to be used on the inside face of leg
assemblies and the closet to the middle.
The 40mm bolts are to be used everywhere else.
Offer the rails up to the leg assembly. With the table
upside down, the rails have the cam fitting facing the
ceiling.
When the rails are in place tighten the cams with the
allen key clockwise. This will pull the rails into the leg and
make them secure.
Offer the second leg assembly to the other end of the
rail. This time you will need to tighten the cams on the
rails first. When doing so alternate tightening the top and
bottom rail by doing half a turn on each.
Once they are both tight you may attach the leg assembly
to the table top with the remaining 6 bolts.
The table is now secure and may be turned upright.
40mm bolt
40mm bolt
60mm bolt

✗
Please lift the table off the ground to turn over.
DO NOT pivot on the legs to turn the table over.
With the help of another person, carefully lift the table up and place on it’s legs, taking care not to pivot the table on
two legs as you do this.
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
Ercol Furniture Ltd, Summerleys Road, Princes Risborough, Buckinghamshire. HP27 9PX ercol.com
✓