Ercol Romana 2642 User manual

2642 large romana extending table
Thank you for purchasing this large romana extending table. Please read the instructions carefully before use
to ensure safe and satisfactory operation of this product
Please check the pack contents before attempting to assemble this product. A full checklist of
components is given in this leaflet. If any components are missing, please contact the retailer from
whom you bought this product.
This product is HEAVY, it should be assembled as near as possible to the point of use.
TAKE CARE WHEN LIFTING to avoid personal injury and (or) damage to the product.
The fittings pack contains SMALL ITEMS which should be KEPT AWAY FROMYOUNG
CHILDREN.
Read this leaflet in full before commencing assembly.
Necessary Tools
Pre-assembly preparation
Please ensure instructions are read in full before attempting to assemble this product
ercol

Fittings and parts checklist
A Washers x 16
B Bolts x 12
C Allen key x 1
Step by step assembly instructions
1. With the help of another person, Lay
the table top face down on to a soft
surface such as carpet or a blanket
which is free from sharp objects.
2. Each leg and corner bracket is
numbered 1 to 4, slot each of the four
legs into their matching corners
as shown below.

3. Put a washer onto each of four bolts
and using the Allen key provided
screw them into the pre bored holes
as shown below. Repeat with the
other three legs.

Please lift the table off the ground to turn over.
DO NOT pivot on the legs to turn the table over.
4. With the help of another person, carefully lift the table up and place on it’s legs, taking care not to pivot the table
on two legs as you do this.
Closed Open
Please lift the table off the ground to turn over.
DO NOT pivot on the legs to turn the table over.
Please lift the table off the ground to turn over.
DO NOT pivot on the legs to turn the table over.

PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
Ercol Furniture Ltd, Summerleys Road, Princes Risborough, Buckinghamshire. HP27 9PX www.ercol.com
7. Close all four keepers to secure the
leaves.
5. The two leaves are held closed by two
keepers (above), one on either side of
the underside of the table where the
join is.Turn the bar on them to release
the leaves then, as they are reciprocal,
gently pull open one leaf, as far as it
will go and the other will automatically
open with it.
6. Lift the top flap of the butterfly
extension leaves and pull it up and back
over the table top as shown in the
following 3 stages. As you open it the
lower leaf will glide over the ramp and
up into place.