Ergotron LearnFit 24-756-003 User manual

1 of 7
888-24-404-G-00 rev. A • 03/19
< 15lbs. (6.8kg)
16"406mm
www.ergotron.com | USA: 1-800-888-8458 | Europe: [phone] | China: 400-120-3051 | Japan: [email protected]
English, Español, Français, Deutsch, Nederlands, Italiano, Svenska, 日本語, 汉语
LearnFit
with Whiteboard Worksurface
™
CAUTION: DO NOT EXCEED
MAXIMUM LISTED WEIGHT
CAPACITY. SERIOUS INJURY
OR PROPERTY DAMAGE MAY
OCCUR!
English
For the latest User Installation Guide please visit: www.ergotron.com
User's Guide

2 of 7
888-24-404-G-00 rev. A • 03/19
ABC
1
1x 1x 1x
Tools Needed
Components

3 of 7
888-24-404-G-00 rev. A • 03/19
1
2
3°- 7°
c
< 10lbs. (4.5kg)
ab
Remove base orientation
indicator from base.
Partially insert riser into base.
Indicator arrows will
remain visible.
Rock riser from
side to side while
inserting.
Front
Back
Front
Front

4 of 7
888-24-404-G-00 rev. A • 03/19
34
5
Remove cap. Attach work surface and press down.
Lift up on the work surface to make sure it is
securely attached to the base.
Indicator arrows should
be completely hidden.

5 of 7
888-24-404-G-00 rev. A • 03/19
8
180˚
76
Loosen, but do not remove 2 screws to lift
and lower hook to desired height.
Lift brake release lever to raise and
lower riser.

6 of 7
888-24-404-G-00 rev. A • 03/19
How to Disassemble
To remove worksurface,
push tab with a tool
while removing.
(Hex wrench suggested,
max diameter 4mm)
NOTE: Requires two
people.
Attach cap.

7 of 7
888-24-404-G-00 rev. A • 03/19
© 2019 Ergotron, Inc. All rights reserved. LearnFit™ is a registered trademarks of Ergotron, Inc.
www.ergotron.com | USA: 1-800-888-8458 | Europe: [phone] | China: 400-120-3051 | Japan: [email protected]
Warranty Exceptions for LearnFit Whiteboard:
One-year limited warranty on whiteboard worksurface.
Ten-year warranty on all non-whiteboard components including base and lift engine.
Warranty does not include: service programs or damage caused by inappropriate writing markers or writing pads.
Further Exclusions and Limitations:
Proper cleaners must be used or permanent staining may occur.
Only use dry erase markers on the whiteboard surface. Any other markers will stain the worksurface.
Whiteboard surfaces are subject to denting, scratching, staining and/or gouging if not properly used and cared for.
Whiteboard surfaces are subject to scratches caused by abrasion, metal and/or sharp objects.
Whiteboard surfaces are subject to discoloration, staining and/or breakdown of material if exposed to heat or chemicals.
Mouse pads must be used on the whiteboard worksurface when using a mouse for navigation.
NOTE: When contacting customer
service, reference the serial number.
For local customer care phone numbers visit: http://contact.ergotron.com
For Service visit: www.ergotron.com
For Warranty visit: www.ergotron.com/warranty
Learn more about ergonomic computer use at:
www.computingcomfort.org