ETEKCITY EKS-L221-SUS User manual

1
Luminary Kitchen Scale
Model: EKS-L221-SUS
User Manual
Questions or Concerns?
Mon–Fri, 9:00 am–5:00 pm PST/PDT
[e-mail] • [phone]

2
Thank you for purchasing the
Luminary Kitchen Scale by Etekcity.
If you have any questions or concerns, please reach out to our
helpful Customer Support Team at [e-mail].
We hope you enjoy your new kitchen scale!

3
Package Contents
Specications
Important Safety Information
Function Diagram
Display Diagram
Using Your Scale
Troubleshooting
Warranty Information
Customer Support
Table of Contents
Package Contents
1 x Luminary Kitchen Scale
1 x USB Charging Cable
1 x Quick Start Guide
3
4
5
7
8
9
12
14
16

4
Specications
Weight Capacity 353 oz / 22 lb / 10 kg / 10000 mL
Units oz / lb:oz / g / mL (water/milk) /
’oz (water/milk)
Increments 0.05 oz / 1 g
Auto-Off 180 seconds
Battery 300mAh Li-ion Battery
Input 5.0V 500mA (USB Type-C Charging)
Dimensions 9.1 x 6.7 x 1.1 in / 230 x 170 x 27 mm

5
Scale
Important Safety Information
• Do not exceed the 22 lb / 10 kg weight capacity, as it will damage
the scale. An error indicator will appear on the LED display if the
limit is exceeded.
• Do not immerse the scale in water or any liquid. If liquid is spilled
on the digital display or buttons, immediately wipe the scale dry
with a soft cloth to avoid internal damage.
• Handle with care. This scale is not intended for commercial or
heavy-duty use.
• Keep the scale in a cool, dry place. Avoid exposure to damp
environments or extreme temperatures.
• Household use only.
To avoid damage to this scale, please read and follow all
instructions and safety guidelines in this manual.
READ AND SAVE THESE INSTRUCTIONS

6
Batteries
• The Display will show “LO” when the battery needs to be charged.
• Insert the USB charging cable into the USB charging socket.
• Plug the USB charging cable into a DC 5V adapter and plug into an
outlet. You can also plug the cable into a powered USB outlet.
• When charging, the battery symbol ( ) on the display will light up.

7
Function Diagram
A. LED Display
B. Unit Selection Button
C. Power/Zero Button
D. Locking Key (Hold Button)
E. USB Charging Port
F. Anti-Skid Pads
BF
E
CD
A
Top Bottom

8
Display Diagram
A. Battery Charging Indicator
B. Milk
C. Water (Liquid)
D. Tare Indicator
E. Weight Value
F. Measurement Unit
G. Hold Indicator
A
B
C
D
G
F
E

9
Using Your Scale
General Operation
1. Place the scale on a hard, at, level surface.
2. Tap to turn on the scale. Make sure the display reads
“0.00”.
3. Tap UNIT to select your desired measuring unit, which will
show on the right of the display.
4. Place your item on the scale.
5. Wait for the reading on the display to stabilize.
Note:
• For accurate results, always place the scale on a hard, dry, at surface,
and keep the scale away from dirt, dust, vibrations, wind, air currents,
and electromagnetic interference.
• When you turn on the scale, choose units, or use the tare function, wait
for the display to read “0.00” before measuring.

10
1. Tap to turn on the scale. Make sure the display reads
“0.00”. If the screen does not display “0.00” automatically, tap
to auto-adjust to zero.
2. Place the container on the center of the scale.
3. Wait for the reading on the display to stabilize. The display will
show the container’s weight.
4. Tap to tare the weight of the container. The screen will
now display “0.00”.
5. Place the liquid or items into the container. The scale will
measure the contents without including the weight of the
container.
6. When you’re done, reset the scale by removing all weight and
tapping again.
Whenever you measure items inside a container, you can use
the tare function to remove the container’s weight from the nal
measurement.
Zero / Tare Function

11
Unit Conversion
Hold Function
Automatic Power Off
Manual Power Off
To change the unit of measurement, tap UNIT until the display
shows your desired unit of measurement.
Tap HOLD to lock the measurement data on the display. Tap
HOLD again to unlock the display.
To save battery power, the scale will automatically power off after
180 seconds of inactivity.
Tap and hold for 2 seconds to turn off the scale.
Note: In hold mode, will not work. You can still use UNIT to switch
between units.

12
Troubleshooting
If your problem is not listed, please contact Customer Support
(see page 16).
Problem Possible Solution
Scale does not turn on. The scale may need to be charged. Plug in the USB
power cord and charge for 2 hours.
Reading is inaccurate.
Place scale on a level surface.
Keep scale away from dirt, dust, vibrations, wind, air
currents, and electromagnetic interference.
Make sure the screen displays “0.00” before measuring
(see Zero / Tare Function, page 10).
Display shows “Err”
Item is too heavy. Remove item from scale to protect
its weight sensors. Use a different scale with a higher
weight range.
Display shows “Lo” Battery power is low. Plug in the USB power cord to
charge the scale.

13
Federal Communication Commission
Interference Statement – Part 15
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.

14
Warranty Information
Product Luminary Kitchen Scale
Model EKS-L221-SUS
Default Warranty Period 2 years
For your own reference, we strongly recommend that you record your order ID and
date of purchase.
TERMS & POLICY
Etekcity Corporation (“Etekcity”) warrants this product to the original
purchaser to be free from defects in material and workmanship, under
normal use and conditions, for a period of 2 years from the date of original
purchase.
Etekcity agrees, at our option during the warranty period, to repair any
defect in material or workmanship or furnish an equal product in exchange
without charge, subject to verication of the defect or malfunction and
proof of the date of purchase.
There is no other express warranty. This warranty does not apply:
• If the product has been modied from its original condition;
• If the product has not been used in accordance with directions and
instructions in the user manual;
• To damages or defects caused by accident, abuse, misuse or
improper or inadequate maintenance;
• To damages or defects caused by service or repair of the product
performed by an unauthorized service provider or by anyone other
than Etekcity;
• To damages or defects occurring during commercial use, rental use,
or any use for which the product is not intended;
• To damages or defects exceeding the cost of the product.

15
Etekcity will not be liable for indirect, incidental, or consequential damages
in connection with the use of the product covered by this warranty.
This warranty extends only to the original consumer purchaser of the
product and is not transferable to any subsequent owner of the product
regardless of whether the product is transferred during the specied term
of the warranty.
This warranty does not extend to products purchased from unauthorized
sellers. Etekcity’s warranty extends only to products purchased from
authorized sellers that are subject to Etekcity’s quality controls and have
agreed to follow its quality controls.
All implied warranties are limited to the period of this limited warranty.
This warranty gives you specic legal rights and you may also have
other rights which vary from state to state. Some states do not allow the
exclusion or limitation of incidental or consequential damages, so the
above limitation or exclusion may not apply to you.
If you discover that your product is defective within the specied warranty
period, please contact Customer Support via [e-mail].
DO NOT dispose of your product before contacting us. Once our Customer
Support Team has approved your request, please return the product with a
copy of the invoice and order ID.
Every Etekcity product automatically includes a 2-year warranty. To make
the customer support process quick and easy, register your product online
at www.etekcity.com/warranty.
This warranty is made by:
Etekcity Corporation
1202 N. Miller St., Suite A
Anaheim, CA 92806

16
Customer Support
If you have any questions or concerns about your new product,
please contact our helpful Customer Support Team.
Etekcity Corporation
1202 N. Miller St., Suite A
Anaheim, CA 92806
Email: [e-mail]
Toll-Free: [phone]
Support Hours
Mon–Fri, 9:00 am–5:00 pm PST/PDT
*Please have your order invoice and order ID ready before contacting
Customer Support.

17
Connect with us @Etekcity
HS090721AC-M1_0821EKS-L221-SUS