Felton DESIGNER III D3SHCGDA User manual

INSTALLATION GUIDE - AUSTRALIA
DESIGNER III SHOWER HEAD CHROME GREY DELUXE D3SHCGDA
WHAT IS IN THE PACK
Wall Flange
D3 Shower Head
Shower Head Stem
Oxijet Water Saving Product
(Optional)
Female Threaded
Ball Joint Fitting
D3 Screw Cap
CLEANING THE SHOWER HEAD DESIGNER III SHOWER HEAD
1. 2.
Hot Water
Vinegar
1:1
15 - 20 mins
Your Feltonmix shower head is manufactured
from self-cleaning plastic materials but if cleaning
is required use a combination of vinegar and
water and by following the steps below is usually
sucient.
1. Remove shower rose from the shower
head stem.
2. Place shower rose in a mixed solution of
vinegar and hot water for between
15 – 20 min. (Note: the face of the
shower rose cannot be removed for
cleaning purposes.)
If extra cleaning is still required use a soft brush.

HOW TO INSTALL
Screw shower head stem with
wall flange fitted into outlet.
Fit the Oxijet™ to the shower head
stem then fit female threaded ball
joint fitting with screw cap to the
end of the Oxijet™ and hand
tighten.
Check that there is no leak at
this connection if so tighten
nut until the leak ceases.
1. 2. 3. Screw shower head to the
shower cap and hand tighten. 4.
Warranty, Maintenance and Care YOUR COPY TO KEEP
Felton Australia Pty Limited guarantees these mixers to be free from defects in materials and workmanship for a period of five (5) years from the date of purchase.
Fair wear and tear is expressly excluded. This warranty is eective for five (5) years from the date of purchase and covers the supply of replacement parts only, not
including installation. You must retain proof of purchase of the Mixer (such as an invoice or receipt) and provide this to Felton on request. This warranty is for
manufacturing defects only and does not cover any damage to the product due to abuse, negligence or improper installation. This warranty is given on the
understanding that the product is installed and operated according to Felton’s installation guide and the Australian/New Zealand standard AS/NZS3500. This
warranty is provided to persons who are defined as a “consumer” under the Australian Consumer Law only and for use in domestic/residential dwellings only (not
for commercial use).
At no stage should any surface coatings be cleaned with cleaning agents that contain a corrosive acid or a scouring additive. Surface coatings should
be cleaned with liquid detergent or soap and water. Any damage caused through the use of an unsuitable cleaner will not be covered by this
warranty. This warranty is subject to any other rights or remedies that you may have under the Australian Consumer Law (or any other applicable
legislation) and to Felton’s Terms of Trade.
Please fill in the details below, attach your receipt to this installation guide and keep as your proof of purchase.
Purchased at: ................................................................................................................................................................................................................................................................
Date of purchase: ........................................................................................................................................................................................................................................................
Installed by: ....................................................................................................................................................................................................................................................................
www.feltontapware.com.auPO Box 4191 Burwood East Victoria 3151, Australia
210716HM
For technical assistance please ring: 1800 792 760
Felton Australia Pty Ltd