FingerTec Q2 User manual

IMPORTANT:
READ CAREFULLY BEFORE DOING ANY INSTALLATION
1. O nly qualified FingerTec installers are recommended to handle
F ingerTec® door lock products installations.
2. Kindly refer to the correct wiring diagram, as the diagrams vary
according to models.
3. It is strongly recommended to use electronic door lock with DC12V.
P lease consult electronic door lock supplier if using different
current or voltage.
4. C ontact us at [email protected] for assistance.
INSTALLATION
GUIDE

DIAGRAM 1
NC
GND
NO
BUT
SENSOR
Door Lock Type NC • Normally Close
DOOR LOCK INSTALLATION
Model Q2
+ DC12V Electronic
-- Door Lock (Type NC)
2 Emergency Break
3Glass (Type NC)
A Overwrite Keyswitch
C
( Type NC)
Push Release Button
Front of Controller
AC110~240V
Power Supply
To Q2
Back of Controller
DIAGRAM 2
Door Lock Type NO • Normally Open
Other Accessories • Alarm, Doorbell
NC
GND
NO
BUT
SENSOR

+ DC12V Electronic
-- Door Lock (Type NO)
1 Emergency Break

3 Glass (Type NO)
B Overwrite Keyswitch
D (Type NO)
Push Release Button
Front of Controller
AC110~240V
Power Supply
To Q2
Back of Controller
DIAGRAM 3
DC12V
GND
NO
COM
NC
B+
B-
Door Bell DC12V
Power
Supply
Alarm
Device