Fisher & Paykel CG365CWACX1 Parts list manual

1.888.96.7872
Product dimensions and specifications are listed as a guide only. For complete installation instructions and specifications, refer to the product Use & Care Guide/Installation Instructions available at www.fisherpaykel.com
DIMENSIONS INCHES (MM)
CG65DWACX1 CG65CWACX1
A Overall width of cooktop 6” (914) 6” (914)
B Overall depth of cooktop 21½” (546) 21½” (546)
C Height of chassis below top of counter (including height of conduit junction) ” (76) ” (76)
36” 5 BURNER GAS COOKTOP DIMENSIONS
CG65DWACX1, CG65CWACX1
A
B
C

1.888.96.7872
Product dimensions and specifications are listed as a guide only. For complete installation instructions and specifications, refer to the product Use & Care Guide/Installation Instructions available at www.fisherpaykel.com
DIMENSIONS INCHES (MM)
CG65DWACX1 CG65CWACX1
A Overall width of cutout 4¼” (870) 4¼” (870)
B Overall depth of cutout 19¼” (494) 19¼” (494)
C Corner radius of cutout R⅜”(10) R⅜”(10)
D Distance from right edge of cutout to manifold center line 1” (25) 1” (25)
E Ddistance from rear edge of cutout to gas inlet on cooktop ¾” (20) ¾” (20)
G Min. clearance from left edge of product to nearest vertical surface 1½” (8) 1½” (8)
H Min. vertical distance between counter and cabinet extending above the counter 18” (457) 18” (457)
I Maximum overall depth of overhead cabinetry 1” (0) 1” (0)
J Min. distance between overhead cabinets installed to either side of product 6” (915) 6” (915)
K Minimum clearance from rear edge of product to:
nearest combustible surface
nearest non-combustible surface*
1¼” (2) 1¼” (2)
Less than 1¼” (2) Less than 1¼” (2)
L Min. clearance from cooking surface to combustible surface centered above the cooking surface 0” (762) 0” (762)
M Min. clearance from front edge of counter to front edge of product 1¼” (2) 1¼” (2)
N Min. clearance below top of countertop to:
nearest combustible surface
F&P oven or nearest non-combustible surface
⁄”(84) ⁄”(84)
⁄”(84) ⁄”(84)
O Mmaximum distance from the center of the product to the nearest grounded power outlet.
The power supply cable must not touch any hot metal surfaces. 0” (762) 0” (762)
P Min. clearance from right edge of product to nearest vertical surface 1” (25) 1” (25)
* Recommended non-combustible materials are: ¼” (6 mm) flame retardant millboard covered with not less than No. 28 MSG sheet steel,
0.015” (0.4 mm) stainless steel, 0.024” (0.6 mm) aluminum or 0.020” (0.5 mm) copper.
36” 5 BURNER GAS COOKTOP DIMENSIONS
CG65DWACX1, CG65CWACX1
Clearance and cabinetry dimensions
J
K
L
O
P
GM
N
H
I
B
A
D
C
Cutout dimensions
E
F