Fisher-Price Classical Chorus 74120 User manual

74120
www.fisher-price.com
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required.
Requires four “C” (LR14) alkaline batteries for the mobile
and two “AA” (LR6) alkaline batteries for the remote control
(batteries not included).
Tool required for battery installation:
Phillips screwdriver (not included).

2
Possible entanglement injury.
• Keep out of baby’s reach.
• Remove mobile from crib or playpen when baby begins
to push up on hands and knees.
• This product will not attach to all crib designs. Do not add
additional strings or straps to attach to crib or playpen.
• The mobile may be used from birth until 5 months.
• A crib mobile is intended for visual stimulation and is not to be grasped by a child.
• Always attach with all provided fasteners (clamp) tightly to a crib or playpen according
to the instructions. Check frequently.
Consumer Information
WARNING

3
Parts
Clamp
Spiral
Upper Arm
Remote Control
#6 x ½" Screw -1
Shown Actual Size
Star
Retainer
3 Soft Toys
Lower Arm
This toy contains small parts in its unassembled state.
Adult assembly is required.
CAUTION

Battery Installation
4
Mobile
• Locate the battery compartment door on the mobile’s lower arm.
• Loosen the screws in the battery compartment door with a Phillips
screwdriver. Remove the battery compartment door.
• Insert four “C” (LR14) alkaline batteries.
• Replace the battery compartment door and tighten the screws with a
Phillips screwdriver. Do not over-tighten.
IMPORTANT! Under normal use conditions, the batteries in the mobile will require
replacement more often than the batteries in the remote control. When sounds or light
become faint, it’s time for an adult to replace the batteries in the mobile lower arm.
Battery Compartment Door

Remote Control
• Locate the battery compartment door on the back of the remote control.
• Loosen the screw in the battery compartment door with a Phillips screwdriver.
Remove the battery compartment door.
• Insert two “AA” (LR6) alkaline batteries, as indicated inside the battery
compartment.
• Replace the battery compartment door and tighten the screw with a Phillips
screwdriver. Do not over-tighten.
IMPORTANT! If the mobile does not respond to the remote control, it does not
mean that the battery power in the remote control is low. Replace the batteries in
the remote control if the LED signal indicator on the remote control is dim when the
start button is pressed. If the LED signal indicator does not light after installing new
batteries in the remote control, check the orientation of the batteries in the
battery compartment to make sure they are properly installed.
Battery Installation
5
Battery Compartment Door

In exceptional circumstances, batteries may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted
batteries from the product. Dispose of batteries safely. Do not dispose of this
product in a fire. The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be charged under
adult supervision.
Battery Safety Information
1.5V x 2
“AA” (LR6)
1.5V x 4
“C” (LR14) +
-
-
+
Battery Installation
Hint: We recommend using alkaline batteries for longer battery life.
PRINTED IN CHINA 74120b-0920
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2007 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
6

• Fit the upper arm into in the lower arm.
Assembly
7
Lower Arm
• Insert the star retainer into the hole in the lower arm on the side opposite the
battery compartment.
• Insert the #6 x ½" screw into the lower arm as shown. Tighten the screw with a
Phillips screwdriver. Do not over-tighten.
Star Retainer
Upper Arm
1
2
1
1
Battery Compartment

Threaded Peg
Crib Top Rail
Clamp
• Note that the spiral has a wide clamp on one end and a narrow clamp on the
other end.
• “Snap” the spiral wide clamp onto the post above the star on the upper arm.
• “Snap” the spiral narrow clamp onto the post below the star on the upper arm.
• Fit the mobile against the crib top rail so that the threaded peg extends out of
the crib.
• Fit the clamp onto the threaded peg and turn the clamp clockwise to secure the
mobile to the crib. Do not over-tighten the clamp.
Assembly
8
Upper Arm
Wide Clamp
Narrow- Clamp
Spiral
1
4
1
3

• The switch has three positions: off ; on with low
volume and on with high
• Slide the power/volume switch to the off position
when not in use.
• Press the button to choose from four different light modes:
1 Twinkling lights around baby's room
2 Glowing star light gently fading in and out
3 Twinkling and glowing lights
4 No lights (music only)
• Each time you press the light select button the
mobile will switch to the next of the four modes
until it returns back again to the first.
• Press the button to choose from seven different
tunes or no music (lights only).
• Each time you press the song select button the
mobile will switch to the next of the selections
until it returns back again to the first.
• Press the start button to activate the mobile.
• The mobile will play for about six minutes.
• To restart or pause the mobile, press the start button
on the remote control or the start button on the mobile.
Notes:
-The remote control will activate the mobile from one foot
to as far as 20 feet away.
-After approximately two hours without activation, the
mobile shuts down. Press the start button on the mobile
to restart the mobile and reactivate the remote.
Use
9
Power/Volume Switch
Light Select Button
Song Select Button
Start Button
Start
Button
volume .

Use
10
IMPORTANT!
• In the unlikely event that use of the remote interferes with normal use of other
remote controlled equipment, such as televisions and stereos, or use of other
electric or battery powered appliances interfere with operation of the mobile, do
not use both appliances at the same time.
• For best performance between the mobile and the remote, avoid using the
remote in areas of bright light. In bright natural or artificial light, you may notice
loss of range. Move the mobile or otherwise reduce the amount of light to
improve performance.
• When using the remote, make sure that the arrow on the mobile’s dome is
pointing towards the transmitter window on the remote. For best results, the
path between the transmitter window on the remote and the dome on the
mobile are in a direct line and free of obstacles. Rotate the mobile dome
so that the arrow points to the area from which you’re most likely to use the
remote. For example, if you’ll most often be using the remote from the doorway
of the nursery, make sure that the arrow on the mobile dome is pointing towards
the doorway and that the path between the mobile dome and the doorway is free
from obstructions.
Mobile Dome

• Wipe the toy with a clean cloth dampened with a mild soap and
water solution.
• Do not immerse the toy.
Care
11
Protect the environment by not disposing of this product with household
waste (2002/96/EC). Check your local authority for recycling advice and
facilities (Europe only).

This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user’s authority to operate
the equipment.
FCC Statement (United States Only)
12