Fisher-Price T6338 User manual

www.fisher-price.com
T6338
T6338

2
Consumer Information
WARNING
Prevent Entanglement Injury
This product may not attach to all crib designs. Do not add
additional strings or straps to attach to a crib or playpen.
Please keep this instruction sheet for future reference, as it contains•
important information.
Requires four “C” (LR14)• alkaline batteries (not included) for operation.
Adult assembly is required for battery installation.•
Tool required for battery installation: Phillips screwdriver (not included).•

3
Battery Installation
Locate the battery compartment on the back of the soother.•
Loosen the screws in the battery compart-ment door and remove the door.•
Insert four, new “C” (LR14)• alkaline batteries.
Hint: We recommend alkaline batteries for longer battery life.
Replace the battery compartment door and tighten the screws.•
If the soother begins to operate erratically, you may need to reset the electronics.•
Slide the power/volume switch off and then back on.
1,5V x 4
"C" (LR14)
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause
a chemical burn injury or ruin your product. To avoid battery leakage:
Do not mix old and new batteries or batteries of different types: alkaline,•
standard (carbon-zinc) or rechargeable (nickel-cadmium).
Insert batteries as indicated inside the battery compartment.•
Remove batteries during long periods of non-use. Always remove exhausted•
batteries from the product. Dispose of batteries safely. Do not dispose of this
product in a fire. The batteries inside may explode or leak.
Never short-circuit the battery terminals.•
Use only batteries of the same or equivalent type as recommended.•
Do not charge non-rechargeable batteries.•
Remove rechargeable batteries from the product before charging.•
If removable, rechargeable batteries are used, they are only to be charged under•
adult supervision.

4
Protect the environment by not disposing of this product with•
household waste (2002/96/EC). Check your local authority for
recycling advice and facilities (Europe only).
Consumer Information
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2010 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA T6338pr-0920
Care
Wipe this toy with a clean cloth dampened with a mild soap and water solution.•
Do not immerse this toy.
This toy has no consumer serviceable parts. Do not take this toy apart.•
CO
N
S
UMER
ASS
I
S
T
A
N
CE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.

5
Crib Attachment
IMPORTANT! Always attach all provided fasteners (strings, straps, clamps,
etc.) tightly to a crib or playpen according to the instructions. Do not add
additional strings or straps to attach to a crib. Check frequently.
IMPORTANT! If you are attaching this toy to a crib side rail that can be lowered
and raised, make sure the crib side rail is in the raised (locked) position whenever
a child is in the crib.
Position the toy inside the crib.•
Wrap the attachment strap around the top of the crib rail.•
Slide the end of the attachment strap under the tabs on the back of the toy.•
Fasten the attachment strap slot to the peg on the back of the toy.•
NOTE: This toy should be snug against the crib rail and spindles. Use the strap
slot that provides the tightest fit.
Slot
t
t
t
t
t
1
1
Peg
Peg
Attachment Strap
Attachment Strap
Crib Rail

6
Crib Attachment
Make sure the distance between the bottom of the product and the crib•
mattress is at least 7 inches (18cm).
If the distance is less than 7 inches (18cm), readjust the attachment strap to lift•
the product; or lower the crib mattress.
7" (18cm)
7" (18cm)
1
3
Tie the toy’s strings to a crib spindle.•
NOTE: It is better to tie the strings in a knot than a bow, since a bow may be
easily untied.
Crib Spindle
1
2
n
d
le

7
Soothing Sounds
Music
Selection
Activation Night LightPower/
Volume
Mode
Slide the power/volume switch to ON with low volume• or ON with high
volume . When you are finished using this product, slide the power/volume
switch OFF .
Slide the mode switch to:• sounds and light show; turns on sounds only.
Slide the music selection switch to• classical, lullabies or
nature sounds.
Press the activation• button to start and stop the song.
Press the night light• button to turn ON or OFF.
Take Along Fun
Slide the release switch on the soother and lift the sound unit.•
To replace, slide the sound unit back onto the soother base. Make sure you hear•
a “click”.
Release Switch
Release Switch

8
FCC Statement (United States Only)
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.•
Increase the separation between the equipment and receiver.•
Consult the dealer or an experienced radio/TV technician for help.•
Note: Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
ICES-003
This Class B digital apparatus complies with Canadian ICES-003.•
Operation is subject to the following two conditions: (1) this device may not•
cause harmful interference and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NMB-003
Cet appareil numérique de la classe B est conforme à la norme NMB-003•
du Canada.
L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes :•
(1) il ne doit pas produire de brouillage et (2) l’utilisateur du dispositif doit être
prêt à accepter tout brouillage radioélectrique reçu, même si ce brouillage est
susceptible de compromettre le fonctionnement du dispositif.
Consumer Information