Fisher-Price BHX87 User manual

1
BHX87
fisher-price.com
Keep this instruction sheet for future reference, as it contains important information.
Vehicle requires four AA (LR6) alkaline and
remote control requires two AA (LR6) alkaline batteries. Batteries are not included.
Battery installation is required. Only adults should install batteries.
Tool required for battery installation: Phillips screwdriver (not included).
Frequency: 27.145MHz
Field Strength: 80dBuV/m @ 3m or 10,000uV/m @ 3m

2
Battery Installation
• Loosen the screw in the battery compartment
door and remove the door.
• Insert four AA (LR6) alkaline batteries.
• Replace the battery compartment door and
tighten the screw.
• Loosen the screw in the battery compartment
door and remove the door.
• Insert two AA (LR6) alkaline batteries.
• Replace the battery compartment door and
tighten the screw.
1,5V x 6
AA (LR6)
• For longer life, use alkaline batteries.
• If the vehicle or remote control begins to operate
erratically, you may need to reset the electronics.
Remove and reinstall the batteries.
Vehicle
Remote Control
Battery Safety
Information
In exceptional circumstances, batteries may leak
fluids that can cause a chemical burn injury or
ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of
different types: alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of non-
use. Always remove exhausted batteries from
the product. Dispose of batteries safely. Do not
dispose of this product in a fire. The batteries
inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are used,
they are only to be charged under
adult supervision.

3
To prevent entanglement, keep hair away from wheels.
CAUTION
Let’s Go!
• Slide the speed switch on the bottom of
the vehicle to low speed (beginner) or
high speed (expert).
Hint: If the speed switch does not move easily,
rotate the rear wheels on the vehicle.
• Press the button on the top of the vehicle.
The ready light turns ON.
• We do not recommend using the vehicle on
carpets. For best performance, use on hard,
flat surfaces.
• Operating multiple vehicles with the same
frequency in close proximity will cause
interference and poor performance. Works
best away from high voltage power lines, large
buildings and walls.
SPEED SWITCH
SPEED SWITCH
PRESS
PRESS

4
• Point the antenna of the remote control toward
the vehicle and press a button.
Beginner “Drivers”
-Press top arrow to drive forward.
-Press bottom arrow to drive in reverse.
-Press the left button to turn left.
-Press the right button to turn right.
Expert “Drivers”
-While pressing the bottom arrow, press the
left arrow to drive in reverse to the left.
-While pressing the bottom arrow, press the
right arrow to drive in reverse to the right.
• For best performance, be sure the remote
control antenna is pointing towards the vehicle.
• If you do not operate the remote control for
approximately 5 minutes, the vehicle will shut
OFF. Press the button on top of the vehicle to
turn power ON again.
• Maximum range of the remote control to the
vehicle is approximately 50 feet (15,24 meters).
Easy to Use Remote ControlEas
y
to Use Remote Contro
l
Beginner
Beginner
Expert
Expert

5
• If vehicle does not move forward or backward
in a straight line, you may want to adjust the
front wheels. Adjust the drift position dial to
either the right or left.
• When movement from the vehicle slows or stops,
it is time for an adult to change the batteries.
• If the vehicle does not respond to the remote
controller, it is time for an adult to change
the batteries.
Troubleshooting Care
• Protect the environment by not disposing of this
product with household waste (2002/96/EC).
Check your local authority for recycling advice
and facilities.
• If the remote control or vehicle are accidentally
dropped in the water, remove the batteries
and allow them to air dry. Replace with fresh
batteries before operation.
• Wipe toy with a clean, damp cloth. Do not
immerse. This toy has no consumer serviceable
parts. Do not take apart.