Fisher-Price 2-Sided Steady Speed Walker HGM28 User manual

1
ASSEMBLY GUIDE
HGM28
2-Sided Steady Speed™Walker

2
Before You Begin
Three AA batteries are required (not included).
Alkaline batteries make this toy work longer before you
need to change them.
Clean with a damp cloth. Do not immerse.
Keep these instructions for future reference as they contain
important information.
1,5V
AA
(LR6)
x3
Plan on about 10 minutes for assembly.
You’ll need a Phillips screwdriver (not included) for assembly
and battery installation. Do not over-tighten assembled
screws or the screw in the battery door.
Adult assembly is required (because we needed to fit this toy
in the box).
10

3
Assembled Parts
M4,5 x 16 mm
CAUTION
This package contains small parts.
For adult assembly only.
x3

4
Assembly
1
Assembled Parts

5
Assembly
2
3
x1

6
Assembly
4
5
x1
x1

7
Assembly
6
7

8
Assembly
8
9Pull up on the
handle to be sure
it’s secure.

9
Install Batteries
Loosen the screw in the battery
door and remove the door.
Insert three, new AA (LR6) alkaline
batteries. Make sure you insert the
batteries correctly!
Replace the battery door and
tighten the screw.
You may need to reset the
electronics if this toy begins to
operate erratically. Slide the
power-mode switch off and
back on.
When sound or lights become faint
or stop, it’s time for an adult to
change the batteries.
Toggle the shifter
Press the button
Press the
horn
Turn the
wheel
Power & Modes
Explore – Enjoy fun sounds, music, first
words and phrases that introduce opposite
and colors!
Encourage – Along with sounds, phrases
and songs about the alphabet and counting,
listen for a fun prompt followed by a reward!
Pretend – Listen to engaging music and
phrases that inspire imaginative play!
Off

10
Walk along for more music,
phrases and sound effects.
If motion doesn’t activate
the toy, be sure to press any
button or toggle the shifter
to wake the toy up.

11
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes :
(1) il ne doit pas produire de brouillage et (2) il doit pouvoir tolérer tout
brouillage radioélectrique reçu, même si ce brouillage est susceptible de
compromettre son fonctionnement.
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause
a chemical burn injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable.
• Insert batteries as indicated inside the battery compartment (+ and -).
• Remove batteries during long periods of non-use. Always remove exhausted
batteries from the product. Dispose of batteries safely. Do not dispose of this
product in a fire. The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be charged
under adult supervision.
Protect the environment by not disposing of this product or any
batteries with household waste. This symbol indicates that this product
shall not be treated as household waste. Check your local authority for
recycling advice and facilities.
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.However, there is no guarantee that
interference will not occur in a particular installation.If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.

HGM28-0970-G1
1102758735-DOM
©2022 Mael.
PRINTED IN CHINA
UNITED STATES
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Consumer Services: 1-800-432-5437.
CANADA
Mattel Canada Inc., 6155 Freemont Blvd., Mississauga,
Ontario L5R 3W2 Consumer Services/Service à la clientèle :
1-800-432-5437. www.service.mattel.com.
GREAT BRITAIN
Mattel U.K. Limited, The Porter Building, 1 Brunel Way, Slough SL1 1FQ, UK.
www.service.mattel.com/uk.
NEDERLAND
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
AUSTRALIA
Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond,
Victoria 3121 Australia. Consumer Advisory Service 1300 135 312.
NEW ZEALAND
16-18 William Pickering Drive, Albany 1331, Auckland.
SOUTH AFRICA
Mattel South Africa (PTY) LTD, Office 102 I3, 30 Melrose Boulevard,
Johannesburg 2196.