Fisher-Price CGM17 User manual

fisher-price.com
CGM17
Open the fasteners on the
back of the puppy. Slide
the power/volume to ON
with low volume or
ON with high volume
to turn off try-me
demonstration mode.
Please keep this instruction sheet for future reference,
as it contains important information.
Table requires adult assembly.
Requires six AA batteries for table and puppy. Batteries are included.
Batteries included are for demonstration purposes only.
Tool required for battery replacement: Phillips screwdriver (not included).
SLIDE SWITCH
DOWN TO TURN OFF
TRY-ME MODE
s
instruction
s
s
he
h
et for future
re
f
fe
re
nc
e,
o
ntains importa
nt
nt
i
i
nformation.
SWIT
L
L
L
SLIDE SWI
TC
CH
F
F
F
F
F
F
T
T
T
T
T
T
T
T
T
T
W
W
N TO T
URN
N
O
OF
F
F
F
F
Y
TR
TRY
-ME
MO
O
D
DE
E

2
Consumer Information
• Protect the environment by not disposing of this
product with household waste (2002/96/EC).
Check your local authority for recycling advice
and facilities.
Care
• These toys are surface washable only. Wipe with
a clean cloth dampened with a mild soap and water
solution. Do not immerse.
• These toys do not have consumer serviceable parts.
Do not take these toys apart.
©2014 Mattel. All Rights Reserved.
PRINTED IN CHINA CGM17pr-0920
FCC Statement (United States Only)
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in
a particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
Note: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
•
P
p
C
a
C
a
•
T
a
s
•
T
D

3
Battery Replacement
• For longer life, use alkaline batteries.
• For the puppy, open the fasteners on the back of
the toy to access the battery compartment.
• Loosen the screw in each battery compartment
door with a Phillips screwdriver and remove
each door.
• Remove the exhausted batteries and dispose of
them properly.
• Insert three, new AA (LR6) alkaline batteries in the
table and in the puppy.
• Replace the battery compartment doors and tighten
each screw. Do not over-tighten the screws.
• If either toy begins to operate erratically you may
need to reset the electronics. For the table, slide the
power/mode switch off and then back on. For the
puppy, slide the power/volume switch off and then
back on.
• When sounds/lights from these toys become faint
or stop, it’s time for an adult to change
the batteries.
1,5V x 6
AA (LR6)
Battery Safety Information
In exceptional circumstances, batteries may leak
fluids that can cause a chemical burn injury or ruin
your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of
different types: alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of non-
use. Always remove exhausted batteries from
the product. Dispose of batteries safely. Do not
dispose of this product in a fire. The batteries
inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• If removable, rechargeable batteries are used, they
are only to be charged under adult supervision.
ICES-003
This Class B digital apparatus complies with
Canadian ICES-003. Operation is subject to the
following two conditions: (1) this device may not
cause harmful interference and (2) this device
must accept any interference received, including
interference that may cause undesired operation.
NMB-003
Cet appareil numérique de la classe B est conforme
à la norme NMB-003 du Canada. L’utilisation de ce
dispositif est autorisée seulement aux conditions
suivantes : (1) il ne doit pas produire de brouillage
et (2) l’utilisateur du dispositif doit être prêt à
accepter tout brouillage radioélectrique reçu, même
si ce brouillage est susceptible de compromettre le
fonctionnement du dispositif.
Puppy
Table

4
Table Assembly for Stand & Cruise
Table Disassembly for Sit & Play
Insert the legs into the
sockets in the table top.
Push to "snap" each leg
in place.
Place the table
top face down on
a flat surface.
Store the legs in a safe
place for future use
(Stand & Cruise).
2
1
Pull each leg
Pull each leg
release tab and
release tab and
remove the legs
remove the legs
from the table top.
from the table top.

5
Table has four modes of play!
• Slide the power/mode switch to:
Learning - Learn letters, numbers, shapes
and animals!
Bilingual - Learn in English and Spanish!
Music - Hear fun songs and musical tunes!
Imagination - Hear lots of fun sounds!
OFF
• Slide the volume switch (on bottom of toy) to:
low, medium or high volume.
Press a button
Press a button or
lift the handset
Turn a page
Press a key

6
Puppy has two interactive play modes!
Press for fun
Press for fun
phrases and
phrases and
a special song!
a special song!
Press to turn on and
start learning mode;
press again for music
mode; press once
more to turn off.
Press for fun
Press for fun
learning songs!
learning songs!
PRESS
PRESS
PRESS
Press for more
songs and
fun sounds!
Learning Mode
• Learn about parts of the body and colors.
Music Mode
• Listen to fun songs, sounds and phrases!
Open the fasteners on the back of the toy. Slide the power/volume to ON with low
volume ON with high volume or OFF . Close the fasteners on the back of the toy.