Fisher-Price FYL42 User manual

You
rock!
FYL42
fisher-price.com
Press my belly to hear
music, sounds and phrases.
My face lights up too!
Keep these instructions for future reference,
as they contain important information.
Requires three AA batteries (included).
Batteries included are for demonstration purposes only.

REPLACE BATTERIES
•Pull the electronics unit out for
better access to the battery
compartment.
•Loosen the screw in the battery
compartment door and remove
the door. Remove the exhausted
batteries and properly dispose.
•Insert three, new AA (LR6)
alkaline batteries into the battery
compartment.
•Open the fasteners on the back of
the toy.
Battery Safety Information
In exceptional circumstances,
batteries may leak fluids that can
cause a chemical burn injury or ruin
your product. To avoid
battery leakage:
•Do not mix old and new batteries
or batteries of different types:
alkaline, standard (carbon-zinc)
or rechargeable.
•Insert batteries as indicated inside
the battery compartment.
•Remove batteries during long
periods of non-use. Always remove
exhausted batteries from the
product. Dispose of batteries safely.
Do not dispose of this product
in a fire. The batteries inside may
explode or leak.
•Never short-circuit the battery terminals.
•Use only batteries of the same or
equivalent type, as recommended.
•Do not charge non-rechargeable
batteries.
•Remove rechargeable batteries
from the product before charging.
•If removable, rechargeable batteries
are used, they are only to be
charged under adult supervision.
Note: Only adults should replace
batteries. Tool required: Phillips
screwdriver (not included).
For longer life, use alkaline batteries.
1,5V x 3
AA (LR6)
•Replace the battery compartment
door and tighten the screw. Do not
over-tighten.
•Replace the electronics unit back
inside the toy. Make sure the button
is facing the front of the toy.
•Close the fasteners.
•When sounds and lights become
faint or stop, it’s time for an adult to
replace the batteries.

•Open the fasteners on the back of
the toy.
•Slide the power-volume switch ON
with low volume , ON with high
volume or OFF.
•Close the fasteners.
•If this toy begins to operate
erratically, you may need to reset the
electronics. Slide the power-volume
switch off and back on.
CAREPOWER ON!
Protect the environment
by not disposing of this
product or any batteries
with household waste. This
symbol indicates that this
product shall not be treated as
household waste. Check your
local authority for recycling
advice and facilities.
•The toy is machine washable
without the electronics unit. Do
not immerse the electronics unit.
Open the fasteners on the back
of the toy and pull to remove the
electronics unit.
•Machine wash cold on the gentle
cycle. Do not use bleach. Tumble
dry on low heat.
•Replace the electronics unit back
inside the toy. Make sure the button
is facing the front of the toy.
•Close the fasteners.

CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following
two conditions: (1) this device may not
cause interference, and (2) this device
must accept any interference, including
interference that may cause undesired
operation of the device.
L’utilisation de ce dispositif est
autorisée seulement aux conditions
suivantes : (1) il ne doit pas produire de
brouillage et (2) il doit pouvoir tolérer
tout brouillage radioélectrique reçu,
même si ce brouillage est susceptible
de compromettre son fonctionnement.
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation.This equipment generates
uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications.However, there is no
guarantee that interference will not occur
in a particular installation.If this equipment
does cause harmful interference to radio
or television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the
equipment and receiver.
•Consult the dealer or an experienced
radio/TV technician for help.
NOTE: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could void
the user’s authority to operate
the equipment.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
©2018 Mattel.
PRINTED IN CHINA FYL42-0970-DOM
UNITED STATES: 1-800-432-5437.
Fisher-Price, Inc., 636 Girard Avenue,
East Aurora, NY 14052.
GREAT BRITAIN: Mattel UK Ltd,
Vanwall Business Park,
Maidenhead SL6 4UB.
Helpline: 01628 500303;
www.service.mattel.com/uk.
Mattel Europa B.V., Gondel 1, 1186 MJ
Amstelveen, Nederland.
CANADA: 1-800-432-5437.
Mattel Canada Inc., 6155 Freemont
Blvd., Mississauga, Ontario L5R 3W2.
AUSTRALIA: Mattel Australia Pty. Ltd.,
658 Church Street, Locked Bag #870,
Richmond, Victoria 3121 Australia.
Consumer Advisory Service
1300 135 312.
NEW ZEALAND: 16-18 William
Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd., Room
503-09, North Tower, World Finance
Centre, Harbour City, Tsimshatsui, HK,
China. Tel.: [phone].
MALAYSIA: Diimport & Diedarkan
Oleh: Mattel Southeast Asia Pte. Ltd.,
No 19-1, Tower 3 Avenue 7, Bangsar
South City, No 8, Jalan Kerinchi, 59200
Kuala Lumpur, Malaysia.
Tel: [phone].
SOUTH AFRICA: Mattel South Africa
(PTY) LTD, Oce 102 I3, 30 Melrose
Boulevard, Johannesburg 2196.