Fisher-Price Classical Chorus 74120 User manual

Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required.
Requires four “C” (LR14) alkaline batteries for the mobile and two “AA” (LR6)
alkaline batteries for the remote control. (Batteries not included)
Tool required for battery installation:
Phillips screwdriver (not included).
Classical Chorus™
Mobile
Classical Chorus
with remote control
with remote control
Mobile
Classical Chorus
with remote control
with remote controlwith remote control
Classical Chorus
Mobile
Mobile
D
i
s
c
o
v
e
r
w
h
a
t
’
s
p
o
s
s
i
b
l
e
™
…
w
w
w
.
f
i
s
h
e
r
-
p
r
i
c
e
.
c
o
m
Product Number: 74120

Parts
2
2
•Acrib mobile is intended for visual stimulation and not to be grasped by a child.
•Always attach by provided fastener (clamp) tightly to a crib or playpen
according to the instructions. Check frequently.
•Do not add additional strings or straps to attach to a crib or playpen.
IMPORTANT!
•Possible entanglement injury, keep out of baby’s reach.
•Remove mobile from crib or playpen when baby begins
to push up on hands and knees.
CAUTION
Clamp
Spiral Upper
Arm
Remote Control
#6 x 1/2"Screw -1
Shown Actual Size
Star Retainer
3 Soft Toys
Lower Arm

Mobile Features
3
Song Select Button – Choose from
seven tunes or no music (lights only).
Light Select Button – Choose from:
1Twinkling lights around baby's room
2Glowing star light gently fading in
and out
3Both lights
4No lights (music only)
Start Button – Starts or restarts
music and soothing lights.
Power/Volume Switch – Choose
high volume ; low volume
or power off .

Remote Control Features
4
Button - Press to restart or pause the mobile once the mobile has been
turned on.
LED Signal Indicator - Lights when the button is pressed to let you know
the remote control has transmitted a signal to the mobile.
Transmitter Window - Remote control transmits a signal to the receiver
dome on the mobile.
Handle - Flips up so you can hang the remote control on a doorknob.
It snaps around the bottom of the remote control when not in use.
Front View
1
1
2
3
4
4
2
3

Mobile
•Locate the battery compartment
door on the mobile’s lower arm.
•Loosen the screws in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.
•Insert four “C” (LR14) alkaline
batteries, as indicated inside
the battery compartment.
Hint: We recommend using alkaline
batteries for longer battery life.
•Replace the battery compartment
door and tighten the screws with
a Phillips screwdriver. Do not
over-tighten.
IMPORTANT! Under normal use
conditions, the batteries in the mobile
will require replacement more often
than the batteries in the remote
control. When sounds or light become
faint, it’s time for an adult to replace
the batteries in the mobile lower arm.
Remote Control
•Locate the battery compartment door
on the back of the remote control.
•Loosen the screw in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.
•Insert two “AA” (LR6) alkaline
batteries, as indicated inside the
battery compartment.
Hint: We recommend using alkaline
batteries for longer battery life.
•Replace the battery compartment
door and tighten the screw with
a Phillips screwdriver. Do not
over-tighten.
IMPORTANT! If the mobile does not
respond to the remote control, it does
not mean that the battery power in
the remote control is low. Replace the
batteries in the remote control if the
LED signal indicator on the remote
control is dim when the button is
pressed. If the LED signal indicator does
not light after installing new batteries
in the remote control, check the
orientation of the batteries in the
battery compartment to make sure
they are properly installed.
Battery Installation
5
Lower Arm Remote Control
Back View
Battery
Compartment
Door
Battery
Compartment
Door

•Do not mix old and new batteries.
•Do not mix different types of batteries: alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium).
•Remove the batteries during long periods of non-use. Always remove
exhausted batteries from the toy. Battery leakage and corrosion can
damage this toy. Dispose of batteries safely.
•Do not dispose of batteries in a fire.The batteries may explode or leak.
•Never short circuit the battery terminals.
•Non-rechargeable batteries are not to be recharged.
•Only batteries of the same or equivalent type as recommended in the
“Battery Installation” instructions are to be used.
•If removable rechargeable batteries are used, they are only to be charged
under adult supervision.
•Rechargeable batteries are to be removed from the toy before they
are charged.
•If you use a battery charger, it should be examined regularly for damage to
the cord, plug, enclosure and other parts. Do not use a damaged battery
charger until it has been properly repaired.
Battery Tips
6
1.5V x 2
“AA” (LR6)
Shown Actual Size
1.5V x 4
“C” (LR14)
Shown Actual Size +
-
-
+

• Fit the post on the upper arm into the hole in the lower arm as shown.
Assembly
7
Upper Arm Post
Lower Arm
Hole
•Insert the star retainer into the hole in the lower arm on the side opposite
the battery compartment as shown.
•Insert the #6 x
1/2"
screw into the hole on the other side of the lower arm as
shown.Tighten the screw with a Phillips screwdriver. Do not over-tighten.
Star Retainer
#6 x 1/2" Screw
Shown Actual Size
1
2

Threaded Peg
Crib Top Rail
Clamp
•Note the spiral has a wide clamp on one end and a narrow clamp on the
other end.
•“Snap” the wide clamp of the spiral onto the post above the star on the
upper arm as shown.
•“Snap” the narrow clamp of the spiral onto the post below the star on the
upper arm as shown.
•Fit the mobile against the crib top rail so that the threaded peg extends
out of the crib.
•Fit the clamp onto the threaded peg and turn the clamp clockwise to
secure the mobile to the crib. Do not over-tighten the clamp.
Assembly
8
Upper Arm
Wide Clamp
3
4
Narrow Clamp
Spiral

•Locate the power/volume switch on mobile.
•The switch has three positions: off ; on with low
volume and on with high volume .
•Slide the power/volume switch to the off position
when not in use.
•Locate the light select button on the mobile.
•Press the button to choose four different light modes:
1Twinkling lights around baby's room
2Glowing star light gently fading in and out
3Both lights
4No lights (music only)
•Each time you press the light select button the
mobile will switch to the next of the four modes
until it returns back again to the first.
•Locate the song select button on the mobile.
•Press the button to choose from seven different
tunes or no music (lights only).
•Each time you press the song select button the
mobile will switch to the next of the selections
until it returns back again to the first.
•Locate the start button on the mobile.
•Press the start button to activate the mobile.
•The mobile will play for about six minutes.
•To restart or pause the mobile, press the button on
the remote control or the start button on the mobile.
Notes:
-The remote control will activate the mobile from
one foot to as far as 20 feet away.
-After approximately two hours without activation,
the receiver shuts down. Press the start button on
the mobile to restart the mobile and reactivate
the remote.
Use
9
Power/Volume Switch
Light Select Button
Song Select Button
Start Button
Start
Button
Remote Control

Use
10
IMPORTANT!
•In the unlikely event that use of the remote interferes with normal use of
other remote controlled equipment, such as televisions and stereos, or use
of other electric or battery powered appliances interfere with operation of
the mobile, do not use both appliances at the same time.
•For best performance between the mobile and the remote, avoid using the
remote in areas of bright light.
In bright natural or artificial light, you may notice loss of range. Move the
mobile or otherwise reduce the amount of light to improve performance.
•When using the remote, make sure that the arrow on the mobile’s dome is
pointing towards the transmitter window on the remote. For best results,
the path between the transmitter window on the remote and the dome
on the mobile are in a direct line and free of obstacles. Rotate the
mobile dome so that the arrow points to the area from which you’re
most likely to use the remote. For example, if you’ll most often be using
the remote from the doorway of the nursery, make sure that the arrow on
the mobile dome is pointing towards the doorway and that the path
between the mobile dome and the doorway is free from obstructions.
Mobile Dome