Fisher-Price H8227 User manual

H8227
Instructions
Ball Toss
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “AA” batteries (included).
Adult assembly is required for battery installation.
Tool required for battery installation: Phillips screwdriver (not included).
www.fisher-price.com
TM

CAUTION
Please keep small parts
such as plastic tabs out of
childrenʼs reach. Throw the
plastic tab away.
Note: A plastic tab is attached to the toy
for in-store demonstration purposes.
While the tab may have already been
removed, check the bottom of the toy
to be sure. If the plastic tab is still
attached, pull and remove the tab from
the toy. Throw the plastic tab away.
Assembly
1
Base Extension
• Fit the base extension to the toy,
as shown.
• Insert three screws into the bottom
of the toy. Tighten the screws with
a Phillips screwdriver. Do not
over-tighten.
2
#6 x 1/2” Screws – 3
Shown Actual Size
Bottom View
CAUTION
This toy contains small parts
in its unassembled state.
Adult assembly is required.

In exceptional circumstances, batteries
may leak fluids that can cause a
chemical burn injury or ruin your
product. To avoid battery leakage:
• Do not mix old and new batteries
or batteries of different types:
alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium).
• Insert batteries as indicated inside
the battery compartment.
• Remove batteries during long
periods of non-use. Always remove
exhausted batteries from the
product. Dispose of batteries safely.
Do not dispose of product in a fire.
The batteries inside may explode
or leak.
• Never short-circuit the bat-
tery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable batteries from
the product before charging.
• If removable, rechargeable batteries
are used, they are only to be
charged under adult supervision.
Battery Replacement
• Locate the battery compartment on
bottom of the toy.
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.
• Insert three “AA” (LR6) alkaline
batteries, as indicated inside the
battery compartment.
Hint: We recommend using
alkaline batteries for longer life.
• Replace the battery compartment
door and tighten the screws with
a Phillips screwdriver. Do not
over-tighten.
• When sounds or lights become faint
or stop, it’s time for an adult
to change the batteries!
For best performance, we recommend
replacing the batteries that came
with this toy with three, new alkaline
“AA” (LR6) batteries.
Shown Actual Size
Battery Safety
Information
Battery
Compartment
Door
Battery
Compartment
Door
Bottom View
1.5V x 3
“AA” (LR6)

Fun Lights and Music!
• Locate the power/volume switch on side
of the toy.
• Slide the switch to on with low volume ;
on with high volume or off o .
• Drop balls into the hoop for fun lights
and music.
Hint: If your child is not actively playing
with this toy, it turns off automatically
(sleep mode). To “wake up” the toy,
simply tap it.
Power/Volume Switch

Two Ways to Play!
• When baby starts to crawl, lift to
remove the hoop from the base.
Flip the base over and replace
the hoop.
• Now baby can crawl and chase
the balls as they roll off in
all directions.
• Wipe this toy with a clean cloth
dampened with a mild soap and
water solution. Do not immerse
this toy.
• This toy has no consumer
serviceable parts. Do not take this
toy apart.
Care

Consumer Information
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user’s authority to operate
the equipment.
FCC Note (United States Only)
Visit us on line at www.service.fisher-price.com.
Call Fisher-Price® Consumer Relations, toll-free at 1-800-432-5437,
8 AM - 6 PM EST Monday through Friday. Hearing-impaired
consumers using TTY/TDD equipment, please call 1-800-382-7470.
Write to us at: Fisher-Price® Consumer Relations, 636 Girard Avenue,
East Aurora, New York 14052.
Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A. H8227a-0920
©2005 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA
For countries outside the United States:
CANADA: Questions? 1-800-432-5437. Mattel Canada Inc., 6155 Freemont Blvd.,Mississauga, Ontario L5R 3W2;
www.service.mattel.com.
GREAT BRITAIN: Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500303;
www.service.mattel.com/uk
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond,Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City,Tsimshatsui, HK, China.