Fisher-Price DHW03 User manual

DHW03
fisher-price.com
Keep this instruction sheet for future reference,
as it contains important information.
Requires three C (LR14) alkaline batteries (not included) for operation.
Adult assembly is required.
Tool required: Phillips screwdriver (not included).
Wipe this toy with a clean, damp cloth. Do not immerse.
This toy has no consumer serviceable parts. Do not take this toy apart.
Drop a ball in the top or
Drop a ball in the top or
bottom of Dino to see
bottom of Dino to see
it bounce around, pop
it bounce around, pop
out the sides or roll out
out the sides or roll out
Dino’s mouth!
Dino’s mouth!
Roll a ball down
Roll a ball down
the tail ramp!
the tail ramp!
Spin the roller for bouncing
Spin the roller for bouncing
action and fun music!
action and fun music!
Slide the power/volume switch
to ON with low volume, ON
with high volume or OFF.

4
• Insert the M4,5 x 17 mm screw in the
hole in the base and tighten with a Phillips
screwdriver. Do not over-tighten.
Assembly
Upper Body
Base
1
2
• “Snap” the upper body onto the base.
• Slide the post through the hole in the
upper body.
• Push to “snap” the bottom of the post into
the hole in the base.
Post
M4,5 x 17 mm screw
SHOWN ACTUAL SIZE
3
• Fit the head onto the body assembly.
Head

Battery
Installation
• For longer life, use alkaline batteries.
• Loosen the screw in the battery compartment
door and remove the door.
• Insert three C (LR14)) alkaline batteries.
• Replace the battery compartment door and
tighten the screw.
• If this product begins to operate erratically,
you may need to reset the electronics. Slide
the power/volume switch off and back on.
• When sounds/motion become faint or stop,
it’s time for an adult to change the batteries.
• Protect the environment by not
disposing of this product with
household waste (2012/19/EU).
Check your local authority for
recycling advice and facilities.
1,5V x 3
C (LR14)
Battery Safety
Information
In exceptional circumstances, batteries may
leak fluids that can cause a chemical burn
injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or batteries
of different types: alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted batteries
from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The
batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.

©2016 Mattel. All Rights Reserved. DHW03-0970
PRINTED IN CHINA 1100972712-DOM
Consumer Information
CO
N
SU
MER
ASS
I
S
T
A
N
CE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
NOTE: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept
any interference, including interference that
may cause undesired operation of the device.
L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes : (1) il ne
doit pas produire de brouillage et (2) il doit
pouvoir tolérer tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible de
compromettre son fonctionnement.