Fisher-Price DHC45 User manual

7
Keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required. No tools needed for assembly.
Requires three AA batteries (included) for operation.
Batteries included are for demonstration purposes only.
Tool required for battery replacement: Phillips screwdriver (not included).
DHC45
fisher-price.com
Stand & Explore Sit & Play

2
Battery Replacement Battery Safety Information
• For longer life, use alkaline batteries.
• Locate the battery compartment on the bottom
of the toy.
• Loosen the screw in the battery compartment
door with a Phillips screwdriver and remove
the door.
• Remove the exhausted batteries and dispose
of them properly.
• Insert three, new AA (LR6) alkaline batteries.
• Replace the battery compartment door and
tighten the screw.
• If this toy begins to operate erratically you
may need to reset the electronics. Slide the
power/volume switch off and back on.
• When sounds or lights from this toy become
faint or stop, it’s time for an adult to change
the batteries.
In exceptional circumstances, batteries may
leak fluids that can cause a chemical burn injury
or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries
of different types: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted batteries
from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The
batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are used,
they are only to be charged under
adult supervision.
1,5V x 3
AA (LR6)

3
Assembly for Stand & Explore
Disassembly for Sit & Play
Place the table
top face down on
a flat surface.
Store the legs in a safe place
for future use (Stand & Cruise).
Insert the legs into the
sockets in the table
top. Push to "snap"
each leg in place.
2
1
Pull each leg release
Pull each leg release
tab and remove the legs
tab and remove the legs
from the table top.
from the table top.

4
Around the Town Play!
• Slide the power/volume switch to ON with
low volume , ON with high volume
or OFF .
Press a button or
bat the roller Open or close the
barn door
Open the door or
flip the light switch
Press the phone button
Press a key
• Slide the Smart StagesTM mode switch to:
Explore – 6M+ Press a button, flip
a switch, open or close the doors, or bat
the roller to discover numbers, colors,
and more with Puppy and Sis.
Encourage – 12M+ Baby enjoys bilingual
fun in this mode with each press, flip,
bat or open and close. Find objects when
Puppy asks for a verbal reward.
Pretend – 18M+ Listen for fun ideas for
pretend play.

5
Consumer Information
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
NOTE: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept
any interference, including interference that
may cause undesired operation of the device.
L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes : (1) il ne
doit pas produire de brouillage et (2) il doit
pouvoir tolérer tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible de
compromettre son fonctionnement.

6
Consumer Information
• Protect the environment by not disposing of this product with household waste (2012/19/EU).
Check your local authority for recycling advice and facilities.
• Wipe this toy with a clean cloth dampened with a mild soap and water solution.
Do not immerse this toy.
• This toy has no consumer serviceable parts. Do not take this toy apart.
©2015 Mattel. All Rights Reserved.
PRINTED IN CHINA
DHC45-0970-G1
1100943118-DOM
CO
N
SU
MER
ASS
I
S
T
A
N
CE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.