Fisher-Price Geo Trax W3599 User manual

1
www.fisher-price.com
W3599
Vehicles shown in photographs and illustrations may be different
than the vehicles included with your toy.
Please keep this instruction sheet for future reference,
as it contains important information.
Requires two "AAA" batteries (included) for vehicles.
Requires six "AAA" (LR03) alkaline batteries (not included)
for remote control vehicle and remote controller.
Adult assembly is required.
Required Tool: Phillips screwdriver (not included).

2
Assembled Parts
Easy Rail TrackPlatformGarage
Bridge TrackGarage BaseMinion Track
Dumpster GuardrailShort Straight Track4 Long Straight Tracks
Short Ramp Track
Long Ramp Track 4 Curved Tracks
3 mm x 12 mm Screw - 4
Tighten and loosen all screws with
a Phillips screwdriver. Do not over-tighten.
SHOWN ACTUAL SIZE

3
2 Flags
2 Village Buildings
2 Supports
C Track
Race Banner
Assembled Parts
Tower Platform
Tower Top
Tower Base
2 Tower Sides
CAUTION
This product includes small parts
in an unassembled state.
Adult assembly is required.

4
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn
injury or ruin your toy. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted batteries from
the toy. Dispose of batteries safely. Do not dispose of this product in a fire. The batteries
inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging.
• If removable, rechargeable batteries are used, they are only to be charged under
adult supervision.
Mater and Professor Z
• Loosen the screws in each battery
compartment door and remove them.
• Insert one "AAA" (LR03) alkaline battery
in each battery compartment.
• Replace each battery compartment door and
tighten the screws.
• If these vehicles begin to operate erratically,
you may need to reset the electronics.
Remove the batteries and reinstall them.
Battery Replacement
1,5V x 2
“AAA” (LR03)
For best performance, we recommend
replacing the batteries that came with this
toy with new, alkaline batteries.

5
Battery Installation
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for recycling
advice and facilities.
1,5V x 6
“AAA” (LR03)
Remote Controller
• Locate the battery compartment on the back
of the remote controller.
• Loosen the screw in the battery compartment
door. Remove the battery compartment door
and insert three “AAA” (LR03) alkaline batteries.
• Replace the battery compartment door and
tighten the screw.
• If the remote controller begins to operate
erratically, you may need to reset the
electronics. Remove the batteries and
reinstall them.
IMPORTANT! Under normal use conditions, the batteries in the remote control
vehicle will require replacement more often than the batteries in the remote
controller. For additional information, refer to the troubleshooting section.
McQueen
• Loosen the screws in the bottom of
the vehicle. Lift the top of the vehicle
off of the chassis to access the
battery compartment. Insert three
“AAA” (LR03) alkaline batteries.
• Replace the top of the vehicle and
tighten the screw.
• If the vehicle begins to operate
erratically, you may need to reset
the electronics. Remove the batteries
and reinstall them.
We recommend the use of alkaline batteries for longer battery life.

6
Consumer Information
CONSUMER ASSISTANCE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
FCC Statement (United States Only)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer responsible for
compliance could void the user’s authority to operate the equipment. This device complies with
Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful
interference and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Care
• Wipe this toy with a clean cloth dampened with a mild soap and water solution. Do not immerse.
• The battery powered vehicles and the remote controller have no consumer serviceable parts.
Do not take them apart.
PRINTED IN CHINA W3599a-0920
Fisher Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2011 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc., unless otherwise indicated.
© Disney/Pixar; Pacer™; Gremlin™

7
• Turn the C track upright.
• Fit the village buildings onto the tabs on the
track, as shown.
• Fit the flags and race banner into the sockets
on the C track.
4
5
Race Banner
Village Buildings
Flag
Assembly
• Fit the tabs on the dumpster into the slots in
the minion base. Push to "snap" in place.
• Fit the the easy rail track onto the
garage base.
• Then, fit the tabs on the garage into the slots
in the garage base. Push to "snap" in place.
• Fit both supports onto the C track.
Hint: The supports are designed to fit one way.
If a support not seem to fit, try the other support!
1
2
3
Dumpster
Minion Track
Garage
Garage Base
Easy Rail
Track
C Track
Supports
Flag

8
Assembly
• Fit the end of the C track onto the end of the
bridge track.
• Slide the platform onto the track assembly.
6
7
• Fit the guard rail onto a curved track,
as shown.
8
Bridge Track
Guardrail
Curved Track
Platform
• Fit both sides of the tower together.
9
Tower Sides

9
Assembly
• Insert four 3 mm x 12 mm screws into the
tower. Tighten the screws.
10
• Fit the top of the tower onto the assembly.
Push to "snap" in place.
Tower Top
11
• Fit the tabs on the bottom of the tower into
the slots in the tower base. Push to "snap"
the tower in place.
• Next, t the tabs on the platform into the
openings on the side of the tower base.
Push to "snap" in place.
Tower Base
Platform
12
• Track pieces easily snap together.
13

10
Try These Fun Layouts!
Curved
Track
Easy Rail Track
Assembly
Tower Assembly
Curved
Track
Curved
Track
Long Straight Tracks
Short Straight Track
Short Ramp
Track
Curved Track
with Guardrail
C Track
Assembly
Long Ramp
Track
Minion Track
Assembly
Curved
Track
Curved
Track
Easy Rail Track
Assembly
Tower Assembly
Curved
Track
Short Straight Track
Short Ramp
Track
Curved Track
with Guardrail
C Track
Assembly
Long Ramp
Track
Minion Track
Assembly
Long Straight Tracks
Long Straight Track

11
Curved
Track
Let's Go!
Hint: We do not recommend using the vehicle
on carpets. For best performance, use on hard,
flat surfaces.
• Point the remote controller toward the
vehicle and push the stick forward. The
vehicle moves forward.
• Pull the stick all the way back and the
vehicle travels in reverse. Release the stick
to stop.
• Turn the camera to change the track. Watch
the vehicle drive over or off the track!
1
2
3
FORWARD
STOP
REVERSE
2
3
1
• Press the power button on top of the vehicle.
The ready light turns on.
POWER BUTTON
READY LIGHT
• Drive a car through the tower or turn the
camera to switch the track and watch it
crash through the gate!
• Push down on Mater or Professor Z to hear
fun phrases and sounds!
Curved
Track

12
ICES-003
NMB-003
• This Class B digital apparatus complies with Canadian ICES-003.
• Operation is subject to the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference received, including interference that
may cause undesired operation.
• Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
• L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes : (1) il ne doit pas
produire de brouillage et (2) l’utilisateur du dispositif doit être prêt à accepter tout brouillage
radioélectrique reçu, même si ce brouillage est susceptible de compromettre le fonctionnement
du dispositif.
Troubleshooting
PROBLEM SOLUTION
Remote control vehicle
drives slowly
Battery power in the vehicle may be weak. Replace all three
batteries in the vehicle with new, alkaline batteries.
The wheels on the vehicle may be dirty. Wipe them with
a clean cloth.
Remote control vehicle
does not respond to
the remote controller
Battery power in the remote controller may be weak. Replace all
three batteries in the remote controller with new, alkaline batteries.
You may be beyond the maximum range of the remote controller
which is about 12 feet (3,6 m).
You may not have a clear path between the remote controller
and the vehicle. This toy works best when there are no
obstructions between the vehicle and the remote controller.
Bright sunlight or fluorescent lights may affect the range of the
remote controller. Try dimming the room you are playing in.
The vehicle may have shut off. If you do not operate the remote
controller for a few minutes, the vehicle shuts off automatically
and the ready light turns off. Press the power button on the
vehicle, and operate the remote controller to restart.