Fisher-Price Smart Bounce & Spin Pony N0446 User manual

N0446
www.fisher-price.com
Smart Bounce &
Spin Pony™
TV is not included.

2
Safety Tips
• Always sit on the seat.
• Only one (1) rider at a time.
• The receiver is not a toy. Adult set-up is required
for TV connect mode.
Notes
• Please keep this owner's manual for future
reference, as it contains important information.
• Requires three “AAA” (LR03) and three “C” (LR14)
alkaline batteries for operation. Batteries are
not included.
• For children ages 12-36 months who are able to
get on and off unassisted.
• Weight limit: 44 lbs (20 kg).
• This product is intended for use indoors on
carpeted surfaces.
• Bright sunlight or incandescent light may affect
the range between the pony and the receiver.
Try dimming the light in the room.
• Adult assembly is required. Tool required for
assembly: Phillips screwdriver (not included).
Care
• Wipe with a clean cloth dampened with a mild
soap and water solution. Do not use bleach.
Do not use harsh or abrasive cleaners. Do
not immerse.
• This product has no consumer serviceable parts.
Do not take this product apart.
• Periodically check this product for wear and
damage and replace any cracked part.
Consumer Information
FCC Statement (United States Only)
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harm-
ful interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Note: Changes or modifications not expressly
approved by the manufacturer responsible for com-
pliance could void the user’s authority to operate the
equipment. This device complies with Part 15 of the
FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference and (2) this device must accept any
interference received, including interference that
may cause undesired operation.

3
3 Grow-with-Me Levels!
Give learning a whole new spin and bounce! Set up the wireless TV connection and let baby control
on-screen activities, with images responding to baby’s movements. Exciting animation, music, sounds,
friendly characters, tons of sing-along songs, and a long trail of exciting things to learn.
12M+ Level 1 - Action/Reaction
With every bounce or spin of the roller, baby makes something happen! Hear songs, learn about animals
and their sounds, first words, greetings and more.
18M+ Level 2 - Learn & Play
As baby grows, so does the learning! Discover letters, numbers, shapes and colors in a fun and
engaging way.
24M+ Level 3 - Active Learning
Lots of games, lots of active learning! For example: make the pony “jump fences” as you count along and
collect rewards.
5 learning sites to choose
from on each level!
• A to Z Zoo
• Count & Grow Farm
• Colorful Home
• Shapes at Shore
• Opposites Playground

4
Parts
6 Feet
6 Base Pieces
Receiver
(Not a Toy)
Handlebar
Cap
Pony
Note: Tighten or loosen all screws with
a Phillips screwdriver.
Do not over-tighten the screws.
#8 x 7 /8” (2.2 cm) Screw - 8
This product contains small parts in its
unassembled state. Adult assembly
is required. Take extra care during
unpacking and assembly.
CAUTION

5
Assembly
• Position the pony upside-down.
• Fit the tube end of a foot into one of the holes
inside the post.
• Assemble the other five feet into the post.
• Fit the cap into the center of the post.
• Insert four screws into the cap and tighten.
1
2
Foot Cap

6
• Turn the assembly upright.
• Fit and “snap” each base piece between the
spaces in the feet.
Hint: The base pieces are designed to be
assembled to any of the openings between
the feet and is a one-time assembly.
Assembly
3
• While sliding the ends of the handlebar into the
indents on each side of the pony’s head, fit the
handlebar post into the slot in the top of the
pony’s head.
4
Base Piece Handlebar

7
Battery Safety Information
In exceptional circumstances, batteries may leak
fluids that can cause a chemical burn injury or ruin
your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of
different types: alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of non-use.
Always remove exhausted batteries from the
product. Dispose of batteries safely. Do not dis-
pose of this product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
• Insert two screws into each end of the handlebar
and tighten.
Assembly
5

8
Battery Installation
• Locate the battery compartment door on the back
of the handlebar.
• Loosen the screws in the battery compartment
door. Remove the battery compartment door.
• Insert three “AAA” (LR03) alkaline batteries.
• Replace the battery compartment door and
tighten the screws.
Protect the environment by not disposing
of this product with household waste
(2002/96/EC). Check your local authority
for recycling advice and facilities.
• Locate the battery compartment door on the
bottom of the receiver.
• Loosen the screw in the battery compartment
door. Remove the battery compartment door.
• Insert three “C” (LR14) alkaline batteries.
• Replace the battery compartment door and
tighten the screw.
Hint: When receiver battery power is weak, you will
see a low battery symbol on your TV screen.
When function is erratic or stops, it’s time for an adult to change the batteries!
We recommend using alkaline batteries for longer battery life.
1.5V x 3
1.5V x 3
"AAA" (LR03)
"AAA" (LR03)
1.5V x 3
1.5V x 3
"C" (LR14)
"C" (LR14)

9
• Power/Mode Switch – Slide this switch to
TV Connect , Stand Alone or Off .
PonyReceiver
TV Connect Mode
• Power Switch – Slide the switch to on or off .
• Backward Button – Press to scroll backward
on screen.
• Forward Button – Press to scroll forward
on screen.
• Select Button – Press to make a selection
on screen.
Back View
Backward Button Forward Button
Power
Switch
Backward
Button
Select
Button Forward
Button L.E.D.
Front View
Power/Mode
Switch
Volume
Switch
• Backward Button – Press to scroll backward
on screen.
• Forward Button – Press to scroll forward
on screen.

10
Adult Set-Up
(TV Connect Mode)
IMPORTANT! Your TV or VCR/DVD must have audio
and video input jacks.
• Plug the audio-video pins on the receiver into the
matching colored input jacks on your TV or VCR/DVD
(yellow for “Video In” and white for “Left Audio In”).
• Place the pony in front of the receiver.
- The pony should be at least 3 but no more than
15 feet from the receiver.
- Make sure the receiver is placed flat, either
on ground level or no more than 5 feet off of
the ground.
- Make sure the receiver is centered in front of
the pony.
- Make sure there is a clear path between the
pony and the receiver.
• Turn your TV or VCR/DVD power on.
• Slide the power switch on the receiver to On .
Slide the power/mode switch on the pony to
TV Connect .
Hint: The L.E.D. on the receiver should always be on
and will flash when there is a wireless connection to
the pony. When baby spins on the pony, there will be
a 160° range of wireless connection.
• To find the picture on your TV screen, set your TV’s or
VCR’s/DVD’s mode selector to INPUT or VIDEO IN.
• To adjust sound in TV Connect Mode, use your TV or
VCR/DVD volume control.
TV
INPUT
AUDIO IN
LEFT
VIDEO IN OR
White
Yellow
TV
VCR/DVD
5 Feet
3–15 Feet