Fisher-Price GeoTrax N0142 User manual

www.fisher-price.com
www.fisher-price.com
N0142
N0142

Visit www.fisher-price.com
to see the entire world
of GeoTrax®accessories!
Please keep this instruction sheet for future reference, as it contains important information.
Requires six “AAA” (LR03) (not included) for operation.
Adult assembly is required.
Tool required for battery replacement: Phillips screwdriver (not included).
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2008 Mattel, Inc. All Right Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA N0142pr-0920

Assembled Parts
Air Track with Support
Air Track with Tabs
Terminal Base
4 Air Tracks
Security GateLoading Station
Main Tower Traffic Control Top
Trestle PostTrestle Base
3

Battery Installation
Airplane
Locate the battery compartment on the back of the airplane.
Loosen the screw in the battery compartment door with
a Phillips screwdriver. Lower the battery compartment door
and insert three “AAA” (LR03) alkaline batteries.
Close the battery compartment door and tighten the screw
with a Phillips screwdriver. Do not over-tighten.
•
•
•
Remote Controller
Locate the battery compartment on the bottom of the
remote controller.
Loosen the screw in the battery compartment door with
a Phillips screwdriver. Remove the battery compartment door
and insert three “AAA” (LR03) alkaline batteries.
Replace the battery compartment door and tighten the screw
with a Phillips screwdriver. Do not over-tighten.
•
•
•
IMPORTANT! Under normal use conditions, the batteries in the vehicle will require replacement more often than the batteries in the
remote controller.
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted batteries from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be charged under adult supervision.
1,5V x 6
“AAA” (LR03)
We recommend the use of alkaline batteries for
longer battery life.
Protect the environment by not disposing of this product
with household waste (2002/96/EC). Check your local
authority for recycling advice and facilities (Europe only).
4

Air Track
Air Track
with Support
with Support
A
B
Position the air track with support above the terminal base assembly.
First, “snap” the ends of the support into the slots in the loading
station A.
Then, fit the tabs on the track into the slots in the terminal
base B.
•
•
•
6
Connect the trestle base to the trestle post.
Lift the terminal base and lower to “snap” onto the trestle assembly,
as shown.
•
•
5
Assembly
Traffic Control Top
Traffic Control Top
Main Tower
Main Tower
Terminal Base
Terminal Base
“Snap” the main tower into the terminal base.•“Snap” the traffic control top into the main tower.
“Snap” the free end of the air track into the slots in the top of the
control tower
•
•
1 2
Trestle Assembly
Trestle Assembly
Trestle Base
Trestle Base
Trestle Post
Trestle Post
5

Air Tracks
Air Tracks
Air Tracks
Air Tracks
A
A
B
C
C
B
Slide to attach an air track to each free end of the track on
the base assembly A.
Fit an air track onto each end of the track assembly B.
Attach the remaining ends of the air track C.
•
•
•
Fit the track with tabs into the slots in the terminal and the
trestle assembly. Push down to “snap” in place.
•
Track with Tabs
Track with Tabs
7 8
Security Gate
Security Gate
“Snap” the security gate into the slots in the terminal base.•
3
Fit the loading station onto the terminal base.•
Loading Station
Loading Station
4
6

Ready Button
Ready Button
Stop Button
Stop Button
Go Button
Go Button
Up, up and away!
Fit the airplane onto the track.
Press the ready button on top of the airplane to turn it on. It’s ready for take-off!
Press the go button on the remote controller to start the airplane.
Press the stop button on the remote controller to stop the airplane.
Note: The airplane will go into sleep mode after five minutes of inactivity. Press the ready button on top of the airplane to wake it up.
Then press the go button on the remote controller to start the airplane.
This toy works best if you have a clear path between the remote controller and the vehicle. Point the remote controller at the airplane.
The maximum range of the remote controller is about 12 feet.
•
•
•
•
•
7

Care
Wipe the toy with a clean, damp cloth. Do not immerse. Do not drop this toy on a hard surface.
This toy has no consumer serviceable parts. Do not take this toy apart.
•
•
Troubleshooting
FCC Statement
(United States Only)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user's authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation.
•
•
•
SYMPTOM SOLUTION
Airplane does not
respond to the
remote controller
Battery power in the remote controller may be weak. Replace all three batteries in the remote controller
with fresh, alkaline batteries.
You may be beyond the maximum range of the remote controller which is about 12 feet.
You may not have a clear path between the remote controller and the airplane. This toy works best
when there are no obstructions between the airplane and the remote controller.
Bright sunlight or fluorescent lights may affect the range of the remote controller. Try dimming the room
you are playing in.
The airplane may have shut off. If you do not operate the remote controller for a few minutes, the airplane
shuts off automatically and the ready light turns off. Press the ready button on the airplane, and operate
the remote controller to restart.
Airplane moves slowly Battery power in the airplane may be weak. Replace all three batteries in the vehicle with fresh,
alkaline batteries.
The wheels on the airplane may be dirty. Wipe them with a clean cloth.
8