Fisher-Price Go baby Go K8844 User manual

Please keep this instruction sheet for future reference, as it contains important information.
Adult assembly is required.
Requires three “AA” batteries for operation (included).
Tool required for assembly: Phillips screwdriver (not included).
K8844
www.fisher-price.com

Head
Track 2
Base
#6 x 1 1/2” - 1
#6 x 3/4"- 16
Screws Shown Actual Size
Note: Tighten and loosen all screws
with a Phillips screwdriver.
Do not over-tighten.
2
Not Shown: label sheet.
This product contains small parts. For assembly
by an adult. Take extra care during
unpacking and assembly.
CAUTION
Parts
Assembly
Track 1
Center Tube
(2 Halves) Base
3 Balls
4 Feet
Foot
• Place the base upside down on a flat surface.
• Fit a foot into the grooved areas in the base.
• Insert four #6 x 3/4” screws into each foot and tighten.
• Turn the toy upright.
1
Fasteners

Center Tube
Piece
• Fit the center tube pieces together. Squeeze them to “snap”
into place.
Center Tube
Piece
2
3
• Insert and “snap” the center tube into the slots in the top of
the base.
Note: The center tube only fits in one way.
PUSH
• Position track 1 with the grooved side up.
• Fit track 1 onto the center tube. Turn it clockwise until it
reaches the base.
• Insert and “snap” the tab on the end of track 1 into the slot
in the base.
Center Tube
Track 1
Base Slot
Tab
3
4
• Position track 2 with the grooved side up. Slide track 2 onto
the center tube.
• Turn track 2 clockwise until it meets track 1. Insert and “snap”
the tab on the end of track 2 into the slot in track 1. Be sure
the small tab on the end of track 2 fits into the slot in track 1.
Track 2
Track 1
Center
Tube
5
Slot
SlotSlot
Small Tab
Small TabSmall Tab
Assembly Assembly

• Insert the #6 x 1 1/2” screw through the hole in track 2 and
into the center tube. Tighten the screw.
Track 2
#6 x 1 1/2”
Screw
6
4
• Fit the head onto the center tube, as shown.
• Press down on the head to “snap” it into place. Pull up on the
head to be sure it is secure.
Center Tube
Head
7
• Wash your hands before applying the labels.
• Make sure the areas where the labels will be applied are
clean and dry. Wipe this product with a clean, soft, dry cloth
to remove any dust or oils.
• For best results, do not attempt to apply a label more
than once.
• Apply the labels as shown in the illustrations above.
Proper label application will help to keep the labels
looking their best!
Decoration
1
Assembly
123
2
3

5
• Locate the power/volume switch on the back of the head.
• Slide the volume switch to either on with high volume ;
on with low volume or off .
• Place a ball in the giraffe’s mouth for fun sounds and music.
Watch the ball spiral down!
• Press the button on the head for music and lights.
Press
Lights and Sounds Fun!
For best performance, we recommend replacing the
batteries that came with this toy with three, new alka-
line “AA” (LR6) batteries.
• Locate the battery compartment on the back of the
giraffe’s head.
• Loosen the screws in the battery compartment door and
remove the door. Remove the exhausted batteries from the
battery compartment. Properly discard the exhausted batteries.
• Insert three, “AA” (LR6) alkaline batteries.
Hint: We recommend using alkaline batteries for longer
battery life.
• Replace the battery compartment door and tighten the screws.
• When sounds or lights from this toy become faint or stop, it’s
time for an adult to change the batteries!
1.5V x 3
“AA” (LR6)
Battery Replacement
• Protect the environment by not disposing of this
product with household waste (2002/96/EC).
Check your local authority for recycling advice and
facilities (Europe only).

Battery Safety Information
In exceptional circumstances, batteries may leak fluids that
can cause a chemical burn injury or ruin your toy. To avoid
battery leakage:
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always
remove exhausted batteries from the toy. Dispose of batteries
safely. Do not dispose of product in a fire. The batteries
inside inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging.
• If removable, rechargeable batteries are used, they are
only to be charged under adult supervision.
Wipe this toy with a clean cloth dampened with a mild soap
and water solution. Do not immerse this toy.
Care
United States Only
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential instal-
lation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV technician
for help.
Note: Changes or modifications not expressly approved by
the manufacturer responsible for compliance could void the
user's authority to operate the equipment.
FCC Statement
Consumer Information
Visit us on line at www.service.fisher-price.com.
Call Fisher-Price®Consumer Relations, toll-free at
1-800-432-5437, 8 AM - 6 PM EST Monday through Friday
and 11 AM-5 PM EST Saturday. Hearing-impaired consumers
using TTY/TDD equipment, please call 1-800-382-7470.
Write to us at: Fisher-Price®Consumer Relations, 636 Girard
Avenue, East Aurora, New York 14052.
For countries outside the United States:
CANADA: Questions? 1-800-432-5437. Mattel Canada Inc., 6155 Freemont
Blvd.,Mississauga, Ontario L5R 3W2; www.service.mattel.com.
GREAT BRITAIN: Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB.
Helpline: 01628 500303; www.service.mattel.com/uk
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870,
Richmond,Victoria 3121 Australia. Consumer Advisory Service 1300 135 312.
NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City,
Tsimshatsui, HK, China.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. PRINTED IN CHINA
©2006 Mattel, Inc. All Right Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. K8844pr-0920