Fisher-Price G2809 Learning Home User manual

G2809
Instructions
Please keep this instruction sheet
for future reference, as it contains
important information.
Requires three LR14 (“C”) alkaline
batteries (not included).
Adult assembly is required.
Tool required for assembly:
Phillips screwdriver (not included).
Learning Home™
www.fisher-price.com

Parts
CAUTION
This product contains small parts
in its unassembled state.
Adult assembly is required.
3 Pieces of Mail
#6 x 1.3 cm (1/2") Screw (Black) – 6 #6 x 2 cm (3/4") Screw – 32
Fasteners Shown Actual Size
Note: Tighten or loosen all screws with a Phillips screwdriver.
Do not over-tighten the screws.
Parts Not Shown
4 Shape Sorter Blocks
3 Balls
Label Sheet
Base End (with Book)
Base End (with Roller)
Base Center (with Door Mat)
2 Rainspout Halves
Clock
Door
Handle Half (with 3 Holes)
Handle Half
House Number Assembly
Shaper Sorter Half (with Shapes)
Shaper Sorter Half (plain)
Wall (with Flowerpot) Wall (with Mailbox)
Door Knob (with Hole)
2
Door Knob

Assembly
•Fit the base centrer (with mat) onto both base ends,
as shown.
Base Centre
Base End
Base End
1
•Turn the base assembly over and insert six #6 x 2 cm (3/4")
screws through the base and into the base ends. Tighten
the screws.
•Turn the base assembly over.
#6 x 2 cm (3/4") Screw
2
3
•Fit the peg on the bottom of the door into the small hole in the
base assembly .
•While holding the door in place, fit the wall with the flowerpot
into the base assembly, as shown .
Door
Flowerpot
1
2
1
2
3
Bottom View

•Press both walls firmly toward the centre, to "snap"
them together.
Assembly
5
6
7
Bottom View
•Lay the house assembly down so the bottom is facing you.
•Insert four #6 x 2 cm (3/4") screws into each base end to
secure the walls. Tighten the screws.
IMPORTANT: Please be sure these eight screws are
fully tightened.
•Turn the house assembly upright.
Large Connector
Socket
•Position the house assembly so that the side with the radio is
facing you.
•Locate the large connector near the top.
•Insert and "snap" the large connector into the socket,
as shown.
PRESS PRESS
#6 x 2 cm (3/4") Screw
4
4
•Insert the wall with the mailbox into the base assembly.
Mailbox

Assembly
9
•Turn the house around so that the side with the radio is
facing you.
•Insert four #6 x 2 cm (3/4") screws into the four holes above
the door. Tighten the screws to secure the house number
assembly.
•Turn the house around so that the side with the flowerpot is
facing you.
•Locate the small connector near the top of the house.
•Insert and "snap" the small connector into the socket,
as shown.
•Fit the house number assembly into the opening near the top
of the house.
8
Flowerpot
House Number
Assembly
Radio
#6 x 2 cm (3/4") Screw
Socket
Small Connector
5

Assembly
13
Handle
•Turn the house around.
•Insert three #6 x 2 cm (3/4") screws into the handle and tighten
the screws.
10
•Fit the clock into the round opening near the top of the house.
•Insert four #6 x 2 cm (3/4") screws into the four holes in the
clock. Tighten the screws.
Clock
11
12
•Locate the handle half with three holes.
•Fit the handle half into the house above the clock.
Handle Half
(with three holes)
Handle Half (Plain)
•Turn the house around.
•Fit the other handle half into the house above the house
numbers.
6
#6 x 2 cm (3/4") Screw
#6 x 2 cm (3/4") Screw

Assembly
15 17
•Turn the house around.
•Fit the other shape sorter half into the opening on the other
side of the door.
•Insert four #6 x 2 cm (3/4") screws into the shape sorter and
tighten the screws.
Shaper Sorter Half
•Position a rainspout half with the wide end facing up. Fit it to
the side of the house near the window.
•While holding the rainspout half in position, insert three,
black #6 x 1.3 cm (1/2") screws into the rainspout half. Tighten
the screws.
Rainspout Half
14
Shaper Sorter Half (with shapes)
•Position the house with the house numbers facing you.
•Fit the shape sorter half with the shapes into the opening
in the door.
#6 x 2 cm (3/4") Screw
#6 x 1.3 cm (1/2") Screw (Black)
7
16
•Insert the doorknob with the hole into the hole in the back of
the door.
•Insert the other doorknob into the matching hole on the front
of the door.
•Insert a #6 x 2 cm (3/4") screw into the doorknob and tighten
the screw.
#6 x 2 cm (3/4") Screw

Assembly Battery Installation
Battery Compartment Door
•Locate the battery compartment below the mailbox.
•Loosen the screws in the battery compartment door. Remove
the battery compartment door.
•Insert three LR14 ("C") alkaline batteries, as indicated inside the
battery compartment.
Hint: We recommend using alkaline batteries for
longer life.
•Replace the battery compartment door and tighten the screws.
•When lights or sounds from this toy become faint or stop,
it’s time for an adult to change the batteries!
Battery Safety Information
Batteries may leak fluids that can cause a chemical burn injury
or ruin your toy. To avoid battery leakage:
•Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
•Insert batteries as indicated inside the battery compartment.
•Remove batteries during long periods of non-use. Always
remove exhausted batteries from the toy. Dispose of batteries
safely. Do not dispose of batteries in a fire. The batteries may
explode or leak.
•Never short-circuit the battery terminals.
•Use only batteries of the same or equivalent type,
as recommended.
•Do not charge non-rechargeable batteries.
•Remove rechargeable batteries from the toy before charging.
•If removable, rechargeable batteries are used, they are only to
be charged under adult supervision.
1.5V x 3
LR14 (“C”)
Shown Actual Size
8
18
•Attach the other rainspout half to the front of the house.
•Insert two #6 x 2 cm (3/4") screws into the holes near the top of
the rainspout assembly. Tighten the screws to secure the
rainspout halves.
#6 x 2 cm (3/4") Screw
Rainspout

Label Decorations
9
•Apply the labels as shown in the illustrations.
•For best results, wash your hands before applying the labels and make sure the areas to which
the labels will be applied are clean and dry. Avoid repositioning a label once it has been applied.
Back View
Front View
8
15
13
14
910
11 12
56
7
1234

10
2 interactive play modes Turn House Numbers
Open D
Music fun
Learning time
Turn the house
numbers
Drop a ball down
the rainspout
Open and close
the window
Open the door
Press the doorbell
Open the postbox
Flip the light switch
Spin the sun
and moon dial
Turn the
clock hands
Press the ABC
radio button
Press the 1-2-3
radio button
Press the rainbow
radio button
Press the opposites
radio button
Hear the number you chose
Hear chimes count out that number
Hear the balls counted as you drop each
one followed by a fun tune
Hear the Itsy-Bitsy-Spider song or a fun
sound effect
Learn up and down
Hear sounds from "outside" the window
or a fun song
Learn open, closed, hello and goodbye
Hear one of several songs – close the door
and the music stops
Hear chimes and a warm greeting as the
house light turns on
Hear chimes and a short ditty as the house
light turns on
Learn about posting mail, open, closed or hear
the A-B-C song
Hear the A-B-C song
Learn about on and off as the house light turns
on and off
Turn the house light on and hear a fun tune
Learn about nighttime and daytime with fun
sound effects
Hear a daytime or nighttime song
Hear a fun counting song or hear tick tocks
Hear Hickory Dickory Dock or other fun
clock sounds
Hear the A-B-C song
Hear one of several fun songs
Hear a fun counting song
Hear any of several enjoyable tunes
Hear a learning song about colors and shapes
Hear one of several fun songs
Hear a learning song about opposites
Hear any of several enjoyable tunes
MODE SWITCH
•Locate the mode switch on
the "radio."
•Slide the mode switch to either
learning mode , music
mode or off O.
•When your child is finished
playing with this toy, slide the
mode switch to the off Oposition.
IMPORTANT! Low battery power m
including irregular sound/lights an
Replace all batteries with alkaline