Fisher-Price Ocean Wonders Aquarium 79667 User manual

Assembly
Note: The toys on the mobile shown on this instruction sheet may be different from those on your product.
IMPORTANT! Before each use or assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp
edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price® for replacement parts and instructions if needed.
Never substitute parts.
79667, B0639
Instructions
•Loosen and remove the screw and lock nut from the
motorized frame tube.Throw away the screw and lock nut.
•Press the button on the motorized frame tube and remove
the seat.
1
•Press the buttons on the back of the motorized frame while
pushing the legs inward.
Button Button
2
•Lay the swing on it’s side.
•Press the buttons in the motorized frame tubes.
•Remove the motorized frame.Throw away the
motorized frame.
Motorized
Frame Tube
Buttons
Press Button
3
•While pressing the upper button on the right leg, fit it into
the tube in the new motorized frame. Make sure the upper
button on the right leg “snaps” into the hole in the tube.
•Repeat this procedure to assemble the left leg to the new
motorized frame.
•When the legs are assembled correctly to the tubes in the
motorized frame, you should not see the red dots.
Tube
Hole
Red Dot
New Motorized Frame
Button
4

Assembly
•Stand the assembly upright.
•Pull the legs out so that the buttons “snap” into the holes in
the motorized frame.
•When standing behind the product, all four feet should be
flat upon the floor. And, check for an Lmarking on the left
foot and an Rmarking on the right foot.
•If the feet are not flat upon the floor, or the left and right feet
have been reversed, remove both lower legs from the upper
legs. Replace them onto the opposite upper leg.
Feet
Feet
Button Button
LR
5
PRINTED IN CHINA 79667a-0922
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2004 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
Motorized
Frame Tube
Hole
•Press the button on the seat tube and slide the seat tube
into the motorized frame tube. Make sure the button on
the seat tube “snaps”into the larger hole in the motorized
frame tube.
Press Button
6
7
M5 x 30mm Screw
BOTH SHOWN ACTUAL SIZE
Rounded
Side
•Insert the new screw
into the smaller hole in
the motorized frame tube.
Hint: You may need to tap the screw with a hammer or twist the
screw to completely insert it through the hole.
•Attach the lock nut, rounded side facing out, to the screw.
•Tighten the screw with a Phillips screwdriver.
M5 Lock Nut