Fisher-Price RESCUE HEROES User manual

J4513
J4513J4513
TM
Figure sold separately and subject to availability.
www.rescueheroes.com

2
• Please keep this instruction sheet
for future reference, as it contains
important information.
• Requires three "AAA" (LR03) alkaline
batteries (not included).
• Adult assembly is required.
• Tool needed for battery installation:
Phillips screwdriver (not included).
• Wipe the toy with a clean cloth
dampened with a mild soap and
water solution.
• Do not immerse the toy.
CONSUMER INFORMATION
Visit us on line at
www.service.fisher-price.com
Call our Consumer Relations Department,
toll-free at 1-800-432-5437, 9 AM - 7 PM
EST Monday through Friday and 11 AM - 5 PM
EST Saturday. Hearing-impaired consumers
using TTY/TDD equipment, please call
1-800-382-7470. Write to us at:
Fisher-Price® Consumer Relations
636 Girard Avenue
East Aurora, New York 14052
For countries outside the United States:
CANADA: Questions? 1-800-432-5437. Mattel Canada
Inc., 6155 Freemont Blvd.,Mississauga, Ontario L5R 3W2;
www.service.mattel.com.
GREAT BRITAIN: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303;
www.service.mattel.com/uk.
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond,Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
NEW ZEALAND: 16-18 William Pickering Drive,
Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower,
World Finance Centre, Harbour City, Tsimshatsui, HK, China.

3
ASSEMBLY
Blades
Note: Tighten and loosen all screws
with a Phillips screwdriver. Do not
over-tighten screws.
• Fit the pegs on the bottom of the
helicopter through the holes in the
landing gear as shown.
• Insert the four screws through the
holes on the bottom of the landing
gear. Tighten the screws.
• Fit the blades onto the post on the
top of the helicopter.
• Insert a Phillips screwdriver into the
hole in the top side of the blades
and tighten the screw.
Post
Hole
Screw (Inside)
#4 x 3/8" (1.9 cm) Screw
Shown Actual Size
This toy contains small parts
in its unassembled state.
Adult assembly is required.
CAUTION

4
• Make sure the areas where the labels
will be applied are clean and dry.
Wipe this product with a clean,
soft, dry cloth to remove any dust
or oils.
• For best results, do not attempt to
apply a label more than once.
• Apply the labels as shown in
the illustration.
3
2
1
5
7
(6 opposite
side)
8
(9 opposite
side)
10
(11 opposite
side)
4
1
LABEL
DECORATION
United States Only
This equipment has been tested and found
to comply with the limits for a Class
B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the
receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could void the
user's authority to operate the equipment.
FCC Statement

5
BATTERY
INSTALLATION
• Locate the battery compartment door
on the underside of the copter.
• Loosen the screw in the battery
compartment door. Remove the battery
compartment door.
• Insert three, new "AAA" (LR03)
alkaline batteries.
• Replace the battery compartment
door and tighten the screw.
• When lights or sounds become faint
or stop, it's time for an adult to
change the batteries!
In exceptional circumstances, batteries
may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside
the battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from
the product before charging.
• If removeable, rechargeable batteries
are used, they are only to be charged
under adult supervision.
BATTERY SAFETY
INFORMATION
1.5V x 3
"AAA" (LR03)
For best results, use only alkaline batteries.
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).

6
TO THE RESCUE
Use only projectiles supplied with
this toy. Do not launch at people
or animals or at point blank range.
• Push the water missiles into the water
blasters until they “click” in place.
• Push the button at the back of the water
blaster to launch a missile.
Squeeze this button to
pop up the water blasters
Squeeze this button
to rotate the
helicopter blades
Slide any Rescue Heroes™figure
into the connector in the cockpit
Press this button
for lights and
siren sounds
Store back packs here
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. PRINTED IN CHINA
©2007 Mattel, Inc. All Right Reserved. ®and ™ designate U.S. trademarks of Mattel, Inc. J4513pr-0920
PUSH