Fisher-Price Shake 'n Go Flyers User manual

Please keep this instruction sheet for future reference,
as it contains important information.
Requires three "AA" batteries (included).
Adult assembly is required (for battery replacement).
Tool required for battery replacement:
Phillips screwdriver (not included).
Planes shown in illustrations may be different
than the plane included with your toy.
www.fisher-price.com
®

For best performance, we recommend
replacing the batteries that came with
this toy with three, new alkaline “AA”
(LR6) batteries.
• Locate the battery compartment door
on the side of the launcher.
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.
• Remove the exhausted batteries and
throw them away.
• Insert three, new "AA" (LR6)
alkaline batteries.
Hint: We recommend using alkaline
batteries for longer battery life.
• Replace the battery compartment door
and tighten the screw with a Phillips
screwdriver. Do not over-tighten.
• If the toy begins to operate erratically,
you may need to reset the electronics.
Slide the on/off switch on the toy off
and then back on.
• When sounds or lights become faint
or stop, it’s time for an adult to change
the batteries!
Battery Safety Information
In exceptional circumstances,
batteries may leak fluids that can cause
a chemical burn injury or ruin your toy.
To avoid battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or recharge-
able (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the toy. Dispose of
batteries safely. Do not dispose of the
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable batteries from
the toy before charging.
• If removable, rechargeable batteries
are used, they are only to be charged
under adult supervision.
1.5V x 3
"AA" (LR6)
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
Battery Replacement

Shake It, Then Launch It!
• Locate the power switch on the side
of the launcher.
• Slide the switch to to turn the
launcher on.
• Shake the launcher for lights and
sound effects.
• As you shake the launcher, the plane
moves back to prepare for launch.
The more you shake, the further the
plane will fly.
Tip: Shake four or five times for
maximum distance and the light on
the back of the launcher glows. Shaking
more than this does not increase
the distance.
• Gently slide the plane into the groove
on the end of the launcher until you
feel a click.
• The launcher starts up and
automatically locks the plane in place.
IMPORTANT! Do not pull the plane back
all the way.
• Squeeze the trigger to launch the plane.
• Only use projectiles supplied with this
toy. Do not launch at people or animals
or at point blank range.
Tip: You can make minor repairs to
your airplane using adhesive tape.
Do not use glue.
CAUTION
Please keep small parts such as
plastic tabs out of children’s reach.
Throw the plastic tab away.
Note: A plastic tab was attached to the toy
for in-store demonstration purposes. While
the tab may have already been removed,
check the toy to be sure. If the plastic tab
is still attached, pull and remove the tab
from the toy. Throw the plastic tab away.
2
3
4
1

Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2008 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA K7362c-0920
Care
• Wipe this toy with a clean cloth
dampened with a mild soap and water
solution. Do not immerse this toy.
• This toy has no consumer serviceable
parts. Do not take this toy apart.
Consumer Information
United States Only
This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and,
if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the
receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could
void the user’s authority to operate
the equipment.
This device complies with Part 15 of the
FCC Rules.
Operation is subject to the following two
conditions: (1) this device may not cause
harmful interference and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
FCC Statement