Fluke TL1000-MC4 Original instructions

TL1000-MC4
Test Lead s
Safety Information
To register your product, or to view, print, or download the latest
manual or manual supplement go to our website: www.fluke.com.
Contact Fluke
Fluke Corporation operates worldwide. For local contact
information, go to our website: www.fluke.com.
[phone] [e-mail]
A Warning identifies hazardous conditions and procedures that
are dangerous to the user. A Caution identifies conditions and
procedures that can cause damage to the Product or the
equipment under test.
XW Warning
To prevent possible electrical shock, fire, or personal
injury:
Read all safety information before you use the
Product.
Use the Product only as specified, or the protection
supplied by the Product can be compromised.
Carefully read all instructions.
Do not use the Product if it is altered or damaged.
Comply with local and national safety codes. Use
personal protective equipment (approved rubber
gloves, face protection, and flame-resistant clothes)
to prevent shock and arc blast injury where hazardous
live conductors are exposed.
Use Product-approved measurement category (CAT),
voltage, and amperage rated accessories (probes,
test leads, and adapters) for all measurements.
Fluke Corporation
P.O. Box 9090
Everett WA 98206-9090
U.S.A.
Fluke Europe B.V.
P.O. Box 1186
5602 BD Eindhoven
The Netherlands
PN 5339320 (English) August 2022
©2022 Fluke Corporation. All rights reserved. Specifications are
subject to change without notice. All Product names are trademarks of
their respective companies.

Do not touch voltages >30 V ac rms, 42 V ac peak, or
60 V dc.
Do not use the Product around explosive gas, vapor,
or in damp or wet environments.
Do not exceed the Measurement Category (CAT)
rating of the lowest rated individual component of a
Product, probe, or accessory.
Do not use test leads if they are damaged. Examine the
test leads for damaged insulation, exposed metal, or if
the wear indicator (if present) shows. Check test lead
continuity.
Do not disconnect the test leads when under load.
Symbols
The table below is a list of the symbols that can be used on the
Product or in this document.
Maintenance
Clean with a soft towel moistened with water and mild detergent.
DO NOT IMMERSE in liquid.
Product Disposal
Dispose of the Product in a professional and environmentally
appropriate manner:
Put the Product in the electrical waste.
Symbol Description
»Consult user documentation.
WWARNING. RISK OF DANGER.
XWARNING. HAZARDOUS VOLTAGE. Risk of electric
shock.
TDouble insulated
PConforms to European Union directives.
½
Measurement Category III is applicable to test and
measuring circuits connected to the distribution
part of the building’s low-voltage MAINS installation.
~
This product complies with the WEEE Directive and
its marking requirements. The affixed label indicates
that you must not discard this electrical/electronic
product in domestic household waste. Do not
dispose of this product as unsorted municipal
waste. For information about take-back and
recycling programs available in your country, see
the Fluke website.

Specifications
Safety............................................IEC 61010-031, CAT III 1500 V, 20 A
Pollution Degree 2
Operating and Storage
Temperature................................-20 °C to 50 °C (-4 °F to 122 °F)
Humidity .......................................<95 % RH, up to 35 °C (95 °F)
<40 % RH, 35 °C to 50 °C
(95 °F to 122 °F)
Altitude .........................................2000 m
LIMITED WARRANTY
This Fluke product will be free from defects in material and
workmanship for 1 year from the date of purchase. This warranty
does not cover fuses, disposable batteries, or damage from
accident, neglect, misuse, alteration, contamination, or abnormal
conditions of operation or handling. Resellers are not authorized
to extend any other warranty on Fluke’s behalf. To obtain service
during the warranty period, contact your nearest Fluke authorized
service center to obtain return authorization information, then
send the product to that Service Center with a description of the
problem.
THIS WARRANTY IS YOUR ONLY REMEDY. NO OTHER
WARRANTIES, SUCH AS FITNESS FOR A PARTICULAR PURPOSE,
ARE EXPRESSED OR IMPLIED. FLUKE IS NOT LIABLE FOR ANY
SPECIAL, INDIRECT, INCIDENTAL OR CONSEQUENTIAL
DAMAGES OR LOSSES, ARISING FROM ANY CAUSE OR THEORY.
Since some states or countries do not allow the exclusion or
limitation of an implied warranty or of incidental or consequential
damages, this limitation of liability may not apply to you.
11/99