Frico PA1508 User manual

PA1508
.... 9
SE .... 12 GB
Original instructions
.... 14
NO .... 17 DE .... 20 ES
.... 23
FR .... 26 IT .... 29 NL .... 32 PL .... 35 RU

PA1508
2
Introduktionssidorna består huvudsakligen av bilder. För översättning av de
engelska texter som används, se respektive språksidor.
SE
The introduction pages consist mainly of pictures. For translation of the
English texts used, see the respective language pages.
GB
Introduksjonssidene består hovedsakelig av bilder. For oversettelse av de
engelske tekstene, se de respektive språksidene.
NO
Les pages de présentation contiennent principalement des images. Pour la
traduction des textes en anglais, consultez la page correspondante à la langue
souhaitée.
FR
Die Einleitungsseiten bestehen hauptsächlich aus Bildern. Für die Übersetzung
der verwendetenTexte in englischer Sprache, siehe die entsprechenden
Sprachseiten.
DE
Las páginas introductorias contienen básicamente imágenes. Consulte la
traducción de los textos en inglés que las acompañan en las páginas del
idioma correspondiente.
ES
De inleidende pagina's bevatten hoofdzakelijk afbeeldingen.Voor een vertaling
van de gebruikte Engelse teksten, zie de pagina's van de resp. taal.
NL
Le pagine introduttive contengono prevalentemente immagini. Per le
traduzioni dei testi scritti in inglese, vedere le pagine nelle diverse lingue.
IT
Początkowe strony zawierają głównie rysunki. Tłumaczenie wykorzystanych
tekstów angielskich znajduje się na odpowiednich stronach językowych.
PL
RU Страницы в начале Инструкции состоят в основном из рисунков, схем и
таблиц. Перевод встречающегося там текста приведен в разделе RU.

PA1508
3
Dimensions
390
55
55
390
PA1508E02 / PA1508E03
PA1508E05
67
7025
25
154
167
790

PA1508
4
A
B
Mounting and installation
Fig. 1: Mounting bracket
Fig. 2: Open the unit
PH2
PH2
300 300
730
Ø 5.5 (3x) A14.5
5
683

PA1508
5
Minimum distance
Fig. 3: Minimum distance
100
50
50
50
25
A
Flammable material A 500

PA1508
6
PA1508E02
PA1508E03
NL
1000W1000W
500W 500W
1
2
0
3
OFF
+ 2kW
+ 3kW
1234
°C °C
°C
1234
M
Hi
Lo
+ 2kW
PA1508E03
Com
PA1508E02
NL
Hi
Lo
1000W1000W
500W 500W
1
2
0
3
OFF
+ 1kW
+ 2kW
1234
°C °C
°C
1234
MM
a
a
Hi
Lo
+ 2kW

PA1508
7
PA1508E05
NL
750W 750W
1500W1500W
°C °C
°C
OFF
+4,5kW
+ 3kW
1234
d
a
+ 3kW
12
34
ad
1
2
0
3
PA1508E05
M
Hi
Lo
Com

PA1508
8
Technical specifications
3Electrical heat - PA1508
*1) ∆t = temperature rise of passing air at maximum heat output and lowest/highest airflow.
*2) Sound power (LWA) measurements according to ISO 27327-2: 2014, Installation type E.
*3) Sound pressure (LpA). Conditions: Distance to the unit 5 metres. Directional factor: 2. Equivalent
absorption area: 200 m². At lowest/highest airflow.
Protection class: IP20
CE compliant.
Type Output
step
[kW]
Airflow
[m3/h]
∆t*1
[°C]
Sound
power*2
[dB(A)]
Sound
pressure*3
[dB(A)]
Voltage
[V]
Amperage
(heat)
[A]
Length
[mm]
Weight
[kg]
PA1508E02 1/2 270/400 22/15 66 39/50 230V~ 8,7 790 7,5
PA1508E03 2/3 270/400 34/23 66 39/50 230V~ 13,0 790 7,5
PA1508E05 3/4,5 270/400 51/34 66 39/50 230V~ 19,6 790 7,5

PA1508
12
GB
Electrical installation
The installation, which should be preceded
by an omnipolar switch with a contact
separation of at least 3 mm, should only
be wired by a competent electrician and in
accordance with the latest edition of IEE
wiring regulations.
Units with 2-3 kW are supplied with a 1,8
m cable and plug. The socket for PA1508E03
must be fused for 16 A.
The PA1508E05 must be permanently
connected to a fused mains supply using a
cable of a minimum 4 mm2section.
See wiring diagrams.
Assembly and operating instructions
General Instructions
Read these instructions carefully before
installation and use. Keep this manual for
future reference.
The product may only be used as set out in
the assembly and operating instructions. The
guarantee is only valid if the product is used
in the manner intended and in accordance
with the instructions.
Application
PA1508 is primarily intended for small
openings such as kiosk and service hatches
and cashier benches where a long, narrow air
flow is required. This creates a temperature
separating air barrier that prevents cold air
from pushing in and hot air from flowing out.
PA1508 also gives additional heat and in this
way also improves the working environment.
Protection class: IP20.
Operation
Air is drawn in at the top of the unit and
blown out downwards so that it shields the
opening and minimizes heat loss. To achieve
the optimum curtain effect the unit must
extend the full width of the opening.
The efficiency of the air curtain depends
on the air temperature, pressure differences
across the opening and any wind pressure.
NOTE! Negative pressure in the building
considerably reduces the efficiency of the air
curtain. The ventilation should therefore be
balanced.
Mounting
The air curtain is installed horizontally with
the supply air grille facing downwards as
close to the opening as possible. Minimum
distance from outlet to floor is 1800 mm. For
other minimum distances, see fig. 3. Bracket
is supplied for wall or ceiling mounting. The
unit can be tilted for optimum output.
1.Fit the bracket on the wall or on the ceiling.
2.Guide the unit onto the bracket through the
opening at the rear or on top.
3.The unit is secured by guiding the slot in the
bracket over the screw (PH2) inside the unit
and then tightening the screw from outside
of the unit.
See Fig. 1-3.
Controls
The air curtain has a built-in thermostat for
heat and switch to set the fan and heating
steps.
Control settings:
1
1
1
0
OFF
Low speed - 2/3 kW
High speed - 2/3 kW
High speed - 3/4,5 kW
PA1508E02
1
1
0
PA1508E03/PA1508E05
OFF
Low speed - 1 kW
Low speed - 2 kW
High speed - 2 kW
1

PA1508
13
GB
Start-up (E)
When the unit is used for the first time or
after a long period of disuse, smoke or odour
may result from dust or dirt that has collected
on the element. This is completely normal
and disappears after a short time.
Maintenance
Since fan motors and other components are
maintenance free, no maintenance other than
cleaning is necessary. The level of cleaning
can vary depending on local conditions.
Undertake cleaning at least twice a year. Inlet
and exhaust grilles, impeller and elements
can be vacuum cleaned or wiped using a
damp cloth. Use a brush when vacuuming
to prevent damaging sensitive parts. Avoid
the use of strong alkaline or acidic cleaning
agents.
Service, repairs and maintenance
For all service, repair and maintenance first
carry out the following:
1.Disconnect the power supply.
2.Loosen the screws on the intake grille and
remove grille.
3.Lift the front.
See Fig.2.
Overheating
The air curtain unit with electric heater is
equipped with an overheat protector. If it is
deployed due to overheating, reset as follows:
1.Disconnect the electricity with the fully
isolated switch.
2.Allow the electrical coil to cool.
3.Determine the cause of overheating and
rectify the fault.
4.Once the overheat protector has cooled down
the unit can be started again.
Trouble shooting
If the fans are not working or do not blow properly,
check the following:
• The functions and settings of the built-in
control system.
• That the intake grille is not dirty.
If there is no heat, check the following:
• The functions, internal sensor and settings
of the built-in control system.
For units with electrical heating, also check the fol-
lowing:
• Power supply to electric heater coil; check
fuses and circuit-breaker (if any).
• That the overheat protection for the motors
has not been deployed.
If the fault cannot be rectified, please contact
a qualified service technician.
Safety
• For all installations of electrically heated
products should a residual current circuit
breaker 300 mA for fire protection be used.
• Keep the areas around the air intake
and exhaust grilles free from possible
obstructions!
• The unit may have hot surfaces during
operation and when cooling down!
• The unit must not be fully or partially
covered with clothing, or similar
materials, as overheating can result in a
fire risk! (E)
• This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or
mental capabilities or lack of experience
and knowledge if they have been given
supervision or instruction concerning
use of the appliance in a safe way and
understand the hazards involved. Children
shall not play with the appliance. Cleaning
and user maintenance shall not be made
by children without supervision.