Frizzlife SK99 User manual

Model: SK99
OWNER'S MANUAL
Certified by IAPMO R&T according to
NSF/ANSI 42 & 53 for Material Safety,
Structural Integrity, Chlorine, Lead,
Particulate Class I, Cyst and VOC remove.

The system conforms to NSF/ANSI 42&53 for the specific performance claims
verified and substantiated by test data.
Cer�fied by IAPMO R&T according to NSF/ANSI 42 & 53
for Material Safety, Structural Integrity, Chlorine,
Par�culate Class I, Lead, Cyst and VOC remove.
Thank you for purchasing the Frizzlife 3-Stage Under Sink Water Filtration System.
When maintained properly, this unit will provide you with years of service.
WARNING:
Please read the manual carefully before proceeding with installation
Model: SK99
FRIZZLIFE INC. www.frizzlife.com
Page 1
Search "Frizzlife SK99 installation" on www.youtube.com
Find the installation video
Register to get 150% warranty
1. Email us your order ID and full name at [email protected].
2. Scan the QR code to register.
Inlet hose
Water pressure
regulator Outlet hose
3/8”-1/2”converter
Housing with
cartridge inside
DIAGRAM

Water flow rate: 1.5GPM
Max. temperature: 38 C/100.4 F
Max. working pressure: 80psi
Min. working pressure: 20psi
Min. temperature: 4 C/39.2 F
Replacement filter model: M3001, M3002, M3003
Capacity: 1000 gallon
1. Please flush water for 10 minutes before use.
2. The spent adsorption media will not be regenerated and used.
3. Systems certified for cyst reduction may be used on disinfected waters that
may contain filterable cysts.
4. Do not use with water that is micro biologically unsafe or of unknown quality
without adequate disinfection before or after the system.
5. Testing was performed under standard laboratory conditions, actual performance
may vary.
6. For cold water use only.
7. This filter must be protected from freezing, which can cause cracking of the filter
and water leakage.
8. Do not allow children under 3 years of age to have access to small parts during
the installation of this product.
9. This installation must comply with all applicable state and local regulations.
10. Do not use this system on water containing greater than 10 mg/L nitrate nitrogen
without pretreatment to remove the nitrate. The water supply must be analyzed for
nitrate nitrogen andnitrite nitrogen before the installation of the system.” Failure to
observe these instructions could produce water that exceeds the drinking water
standard for nitrate;
11. Do not use this system on water containing hardness greater than 50 mg/L
(3 grains per gallon) without pretreatment to remove hardness.
Model: SK99
FRIZZLIFE INC. www.frizzlife.com
Page 2
Please take the system and all the components out of the box. Inspect the system
carefully, make sure nothing is damaged during shipping. If any part is cracked or
broken, please do not proceed with the installation and contact FRIZZLIFE for an
exchange or diagnosis.
Inspect the system:
BEFORE INSTALLATION
PRECAUTIONS
TECHNICAL DATA

Model: SK99
FRIZZLIFE INC. www.frizzlife.com
Page 3
IF ANGLE VALVE OUTLET IS 3/8”
3/8” Comp (9/16” thread) 1/2” thread
IF ANGLE VALVE OUTLET IS 1/2”
IF YOUR VALVE IS 1/2”
Water pressure regulator
INSTALLATION OF THE FILTER SYSTEM

STEP 1: connect one part of the adaptor to the angle valve
STEP 2: connect another part of the adaptor to the outlet hose
Model: SK99
FRIZZLIFE INC. www.frizzlife.com
Page 4
Remark: We don’ t suggest to mount the machine if your sink is too
narrow to work with
1. Set the sticker provided in the package on the plate to mark the spots for two screws.
1. Attached the Water Pressure Regulator to the 'Supply' end of the system.
2. Seal the connection with blue clip.
3. Make sure the arrow on the regulator is set upwards.
Connect the inlet water hose
to the water pressure regulator
at the "Supply" end.
Connect the outlet water hose Hose installation complete
2. Use an electric screwdriver to fasten the screws. Mount the system after following
steps being accomplished.
STEP 1: INSTALL THE SYSTEM ONTO A WOODEN PLATE
STEP 3: CONNECT THE FILTER SYSTEM
STEP 2: INSTALL THE WATER PRESSURE REGULATOR

Shut off the water supply
Connect the outlet hose to
the faucet hose Connection complete
Remove the existing water hose Connect the inlet hose to
angle stop valve
Turn on the water supply
STEP 4: CONNECT THE WATER SUPPLY (COLD WATER ONLY)
Model: SK99
FRIZZLIFE INC. www.frizzlife.com
Page 5
CARTRIDGE REPLACEMENT
1. Turn on the water supply and check for leaks.
2.Flush the system for 10 minutes before use.
STEP 5: CHECK FOR LEAKS AND FLUSH THE FILTER
STEP 1: Shut off the water supply(Important!!);
STEP 2: Twist off the housing;
STEP 3: Using wrench to unscrew the housing body;
STEP 4: Take out the old cartridge and load with new one,
then install back the same way.

LIMITED WARRANTY
Substance
Influent challenge
concentration (mg/L)
Maximum permissible product
water concentration (mg/L)
Chlorine
Particulate, Class I
Particles 0.5 to <1µm
Lead
Cyst
2.0 mg/L ± 10%
>10,000 particles/mL
0.15 ± 10%
Min. 50,000/L
≥50%
≥85%
0.010
99.95%
TTHM（as chloroform）0.45 ± 20% 0.080
WARNING: PLEASE KEEP THE WRENCH ALWAYS !
Shut off the water supply
Take out the inside filter
cartridge
Replace with a new filter
cartridge and screw back in
Turn the housing counter
clockwise，remove the housing
Use the wrench to srew off the
bottom cap
Please shut off the water supply first then change the filter
PERFORMANCE DATA
TROUBLE SHOOTING
1.Leaks at the threaded connection: if once the system leaks after installation,
please use plumber tapes properly on the threaded fitting to prevent leakage.
Model: SK99
FRIZZLIFE INC. www.frizzlife.com
Page 6

Model: SK99
FRIZZLIFE INC. www.frizzlife.com
Page 7
2.PPM is not dropping while tested by TDS meter: Frizzlife SK99 has a unique
technology that removes 99.99% of contaminants while leaving all the essential
minerals in water such as Calcium,Potassium,Sodium,Magnesium ect.
All healthy water has a certain level of total dissolved solids.they are essential
minerals.The TDS meters are not an effective way to measure the water quality,
the water without TDS is normally produced by reverse osmosis system.
LIMITED WARRANTY
1. Frizzlife is not liable for anything that we deem as abuse of the units, including but not
limited to, misuse of product outside of intended use, equipment modifications,
unauthorized repairs, improper installation, damage from freezing, hot water,
fire or other acts of God outside of Frizzlife control.
TWO YEAR LIMITED FRIZZLIFE WARRANTY
The Frizzlife SK99 under sink water filter units are warranted to the original
purchaser.
To be free of defects in material and workmanship by Frizzlife INC, Frizzlife
will replace or repair components of the unit that Frizzlife has deemed to be
broken within the limits of the warranty without charge. The customer is not
responsible for any freight involved with shipping the item back for inspection
and shipment of replacement items. Frizzlife is not liable for cost of removal,
installation, transportation or any other charges in connection with a warranty
claim.
SK99 3-Stage Under Sink Water Filter System
This warranty will be void if defects occur due to failure to observe the
following conditions:
Incoming water to the the system cannot exceed 100°F.
Do not use outdoors or in a location that is subjected to direct sunlight or freezing.
This warranty will not be effective unless and until the Frizzlife is shown to have
been used in accordance with the installation and maintenance instructions
accompanying the product.
2. Filter Cartridges are considered as disposable items, thus are not covered
by warranty.
3. Customer is responsible for proper operation, which includes complete and
continual leak inspection.

Model: SK99
FRIZZLIFE INC. www.frizzlife.com
Page 8
To receive warranty service, please contact Frizzlife at [email protected]
There are no other warranties which extend beyond what is described above.
Most of the unit components are made of plastic and eventually can break or
crack from stress.
1. Email us your order ID and full name at [email protected]
2. Scan the QR code below to register
150% Extended Warranty