Frizzlife TW10 User manual

(Ver. 03/2022)
OWNER’S MANUAL
Direct Connect Under Sink Water Filtration System

CONTENT
1. BEFORE INSTALLATION
2. PRODUCT INTRODUCTION
3.SAMPLE CONNECTION
4. INSTALLATION STEPS
5. REPLACEMENT FILTER
6. FILTER REPLACEMENT INSTRUCTION
7. MULTI-USAGE
9. FREQUENTLY ASKED QUESTIONS
8. PERFORMANCE DATA
10. LIMITED PRODUCT WARRANTY
01
02
03
02
05
05
06
06
07
07
11. WARRANTY REGISTRATION 08
If you have problems during the purchase or installation
process, please contact our customer service.
Receive first-hand promiton info and be
the first one getting exclusive benefits.
@Frizzlife
www.frizzlife.com [email protected]
FOLLOW US

Register to activate your warranty with Frizzlife.
Find the Installation Video
1. BEFORE INSTALLATION
Email us your order ID and full name at
[email protected]
Scan the QR code to register
Search “Frizzlife TW Series Installation” on www.youtube.com
Inspect Box
Please take out the system and all the components from the box. Inspect
them carefully according to “Product Introduction”, and make sure nothing in
missing or damaged during shipping. If any parts are cracked or broken,
please do not proceed with installation, and contact Frizzlife for an exchange
or diagnosis.
Do not use it with water that is microbiologically unsafe or of unknown
quality without adequate disinfection.
Technical Parameters
Model No. DW10 DW15 DW20
Flow Rate
Replacement Period 3-6M, 8-12M, 12-18M
SED10R, CP10R, CB10R
4.7*15.7*14.6 in 4.7*15.7*19 in 4.7*15.7*21 in
SED15R, CP15R, CB15R SED20R, CP20R, CB20R
4-8M, 12-18M, 16-24M 8-12M, 16-24M, 24-36M
Replacement Filter
Dimension
Working Pressure
Operational Temp
Applicable Water Soure
2 GPM @ 60 psi
Municipal Water
Min.20psi, Max. 80psi
Min.39ºF,Max 100ºF
Precautions
For cold water use only.
Do not freeze the filter, as this case cause cracking and water leakage.
Do not allow children under 3 years of age to have access to small parts
duringthe installation of this product.
Testing was performed under standard laboratory conditions, actual
performance may vary.
This installation must comply with all applicable state and local regulations.
Please flush water for 15 minutes for the first time usage.
01

3. SAMPLE CONNECTION
2. PRODUCT INTRODUCTION
TW10/TW15/TW20 Filter System
with Filter Loaded
1
2Wrench
3
3/8” inlet hose
4
6
3/8”-1/2” Converter set
7
8
Mounting Screws
53/8” Outlet hoses ×2
Plumber Tape
1
5
6 7 89
2
3
4
Inlet hose
Existing faucet hose
Hot Cold Filter system
System Holder ×2
9Spring Wires for Holder ×6
02

4. INSTALLATION STEPS
Step 1: Mount the system or set the system on the ground by using the
holders.
Option 1: Mount the system (onto a wooden plate)
Option 2: Set the system on the ground
03
Note:
Note:
Please always use plumber tape on threaded connection parts
to ensure a watertight seal.
Leave at least 2 inches higher than the ground for easier filter
replacement.
1. Find the proper place to mount up the
system.
1. Setup the holder on flat ground.
2. Insert the long side end of the wire into the upper hold of the holder.
Insert the other end into the base hole.
3. Make sure all the spring wires of the holder
stretch out steadily.
4. Set the system on the holders.
2. Srew off the cartridges.
3. Mount up the filter heads using the
provided screws.（Please use at least 6
screws to fasten the system.)
4. Scew back the cartridges.
Step 2: Connect the water hose
1. Connect the inlet hose to the
“lnlet” port.
Inlet hose

04
Note: If your angle valve is 1/2”, please install the converter
provided firstly.
Step 4: Connect to the main faucet
IF ANGLE VALVE OUTLET IS 3/8”
3/8” Comp(9/16” thread)
IF ANGLE VALVE OUTLET IS 1/2”
1/2” thread
connect one part of the
adaptor to the angle valve
connect the other part of
adaptor to the outlet port
1.Connect the existing faucet hose to “Outlet”
port of the system
If your existing faucet hose is not long
enough, please select and use the proper
outlet hose provided to finish connection.
Step 5: Check for leaks
1. Turn on the water supply valve to check
for leaks
2. Flush the system for 15 minutes before use
1/2” 1/2” to 3/8” 3/8” to 1/2”
Faucet hose
Step 3: Connect the water supply
(COLD WATER ONLY)
1. Shut off the water supply
2. Remove the feed water hose from
the angle valve
3. Connect the inlet hose to the feed
water valve
1
23

5. REPLACEMENT FILTER
6. FILTER REPLACEMENT INSTRUCTION
Step 1: Twist the cartridge housing(s) clockwise
Step 2: Using the wrench to unscrew
the housing body
Step 3: Take out the old cartridge and
load with new one, then install back in
the same way
Step 4: Flush the new cartridge for 15
minutes before starting to use
The Frizzlife Under Sink Water Filter System requires care and cleaning after a
period of time. It is recommended to change the cartridge according to
corresponding time intervals in the table below. If the system has been work-
ing properly and the filtered water output is slowing down, it may be time to
change the filter cartridge.
3-6M, 8-12M, 12-18M
4-8M, 12-18M, 16-24M
8-12M, 16-24M, 24-36M
System Model No.
TW10
TW15
TW20
SED10R, CP10R, CB10R
SED15R, CP15R, CB15R
SED20R, CP20R, CB20R
Replacement Filter No. Filtration Capacity
05
Note: All the service life of the filter cartridge listed are based on
actual laboratory test and the provided water. The actual service life
of filter cartridge depends on source water quality and daily water
usage.
Note:
With the ATUO Shut off design of the system, you do not need
to shut off the water supply when doing the replacement.
Change

7. MULTI-USAGE
8. PERFORMANCE DATA
The TW Series system can be connected to your refrigerator / ice maker by
utilizing Frizzlife IMC-2 connection (not included).
Simply search “Frizzlife IMC-2”
on Amazon or scan the QR code
below to purchase.
≥50％
≥85％
0.010
99.95％
Substance
Chlorine
Particulate, Class I
Particles 0.5 to ＜1μm
Lead
Cyst
2.0 mg/L ± 10 ％
At least 10,000 particles/ml
0.15 ± 10 ％
Min. 50,000/L
Influent challenge
concentration (mg/L)
Maximum permissible
product water
concentration (mg/L)
06

10. LIMITED PRODUCT WARRANTY
9. FREQUENTLY ASKED QUESTIONS
Q: What should I do if water leaks after installation?
The Frizzlife TW Series Under Sink Water Filtration System are warranted to the original
purchaser. To be free of defects in material and workmanship by FRIZZLIFE INC, FRIZZLIFE
will replace or repair components of the unit that Frizzlife has deemed to be broken within
the limits of the warranty without charge. The customer is not responsible for any freight
involved with shipping the item back for inspection and shipment of replacement for items.
Frizzlife is not liable for cost of removal, installation, transportation or any other charges in
connection with a warranty claim.
Customer must register their systems with Frizzlife within 90 days of purchase in order to
obtain a warranty. Warranty will discontinue after the unit is removed from the location
where it was originally installed. Warranty begins on the date of delivery of product to
the customer.
07
A: If once installed the system should leak, please shut off water supply firstly. If
the leaking occurs at the thread, please wrap plumber tape on the external thread.
Please contact Frizzlife customer service team for solutions if the water leakage
persists.
Q: Why TDS does not drop after filtration?
A: TDS is not a professional way to test the water quality. TDS means total
dissolved solids, for example if you put a very little salt(NaCl) into the water and test
the TDS, and you will find the result is dramatically high. Same thing, if your water is
full of minerals, the TDS is very high too. The TW Series doesn't remove any of the
minerals from water, but only stops harmful contaminants like heavy metals (Lead,
Mercury, Cadmium) and over 90% of VOCs and Cysts, and it removes greatly the
chlorine (99%) from water. Therefore, it is the reason why TDS you get is not that low
as you expect.
Warrantor: FRIZZLIFE INCTW10/TW15/TW20 Under Sink Water Filter System
ONE YEAR LIMITED FRIZZLIFE WARRANTY
As a condition of this Limited Warranty, the owner must ensure that periodic
maintenance of the system is performed as described in the literature enclosed with
the system. Should your unit develop a defect or otherwise fail to perform in
accordance with this warranty, you should contact the retailer from whom the product
was originally purchased.
Owner’s Warranty Responsibility:

11. WARRANTY REGISTRATION
08
1. Frizzlife is not liable for anything that we deem as abuse of the units, including
but not limited to, misuse of product outside of intended use, equipment
modifications,unauthorized repairs, improper installation, damage from freezing,
hot water, fire or other acts of God outside of Frizzlife control.
This warranty will be void if defects occur due to failure to observe the
following conditions:
Incoming water to the the system cannot exceed 100°F.
Do not use outdoors or in a location that is subjected to direct sunlight or freezing.
This warranty will not be effective unless and until the Frizzlife is shown to have
been used in accordance with the installation and maintenance instructions
accompanying the product.
2. Filter Cartridges are considered as disposable items, thus are not covered by
warranty.
3. Customer is responsible for proper operation, which includes complete and
continual leak inspection.
Most of the unit components are made of plastic and eventually can break
or crack from stress.
There are no other warranties which extend beyond what is described above.
150% EXTENDED WARRANTY
1.Email us you order ID and full name at
[email protected] within 90 days.
2.Scan the QR code below to register
If you have any questions, any suggestions, or you need any assistance, please free
to contact us anytime at [email protected].
Your satisfaction is always our top priority!