Frizzlife SP99 User manual

Model: SP99
OWNER'S MANUAL
Certified by IAPMO R&T according to
NSF/ANSI 42 & 53 for Material Safety,
Structural Integrity, Chlorine, Lead,
Particulate Class I, Cyst and VOC remove.

The system conforms to NSF/ANSI 42&53 for the specific performance claims
verified and substantiated by test data.



Thank you for purchasing the Frizzlife 3-Stage Under Sink Water Filtration System.
When maintained properly, this unit will provide you with years of service.
WARNING:
Model: SP99
FRIZZLIFE INC. www.frizzlife.com
Page 1
Search "Frizzlife SP99 installation" on www.youtube.com
Find the installation video
DIAGRAM
Register to get 150% warranty
1. Email us your order ID and full name at [email protected].
2. Scan the QR code to register.
Please read the manual carefully before proceeding with installation
Water Pressure
Regulator
F

1. Please flush water for 10 minutes before use.
2. The spent adsorption media will not be regenerated and used.
3. Systems certified for cyst reduction may be used on disinfected waters that
may contain filterable cysts.
4. Do not use with water that is micro biologically unsafe or of unknown quality
without adequate disinfection before or after the system.
5. Testing was performed under standard laboratory conditions, actual performance
may vary.
6. For cold water use only.
7. This filter must be protected from freezing, which can cause cracking of the filter
and water leakage.
8. Do not allow children under 3 years of age to have access to small parts during
the installation of this product.
9. This installation must comply with all applicable state and local regulations.
10. Do not use this system on water containing greater than 10 mg/L nitrate nitrogen
without pretreatment to remove the nitrate. The water supply must be analyzed for
nitrate nitrogen andnitrite nitrogen before the installation of the system.” Failure to
observe these instructions could produce water that exceeds the drinking water
standard for nitrate;
11. Do not use this system on water containing hardness greater than 50 mg/L
(3 grains per gallon) without pretreatment to remove hardness.
Model: SP99
FRIZZLIFE INC. www.frizzlife.com
Page 2
Please take the system and all the components out of the box. Inspect the system
carefully, make sure nothing is damaged during shipping. If any part is cracked or
broken, please do not proceed with the installation and contact FRIZZLIFE for an
exchange or diagnosis.
BEFORE INSTALLATION
PRECAUTIONS
YOU NEED TO KNOW
Cut the 1/4” tube into two sections in proper length. Make sure cut them evenly.

To remove tubing, you need to pull out the blue clip, push in the collet, and pull out
the tubing. To connect the tubing, you need to pull out the blue clip and push in
the water tube and put back the blue clip.


Water flow rate: 1.5GPM
Max. temperature: 38 C/100.4 F
Max. working pressure: 80psi
Min. working pressure: 20psi
Min. temperature: 4 C/39.2 F
Replacement filter model: M3001, M3002, M3003
Capacity: 1000 gallon
Model: SP99
FRIZZLIFE INC. www.frizzlife.com
Page 3
INSTALLATION OF THE FILTER SYSTEM
Remark:
We don’ t suggest to mount the machine if your sink is too
narrow to work with.
Warning: When using the wrench to tighten，be sure not too loose
or too tight in case of breaking the tubing.
1. Set the sticker provided in the package on the plate to
mark the spots for two screws.
2.Use an electric screwdriver to fasten the srews to
mount the system after following steps are finished.
STEP 1: INSTALL THE SYSTEM ONTO A WOODEN PLATE
TECHNICAL DATA

Model: SP99
FRIZZLIFE INC. www.frizzlife.com
Page 4
STEP 4: CONNECT THE 3 WAY FEED WATER VALVE
STEP 5: CONNECT THE WATER SUPPLY(COLD WATER ONLY)
1. Attached the Water Pressure Regulator
to the 'Supply' end of the system.
2. Seal the connection with a bigger blue clip.
3. Make sure the arrow on the regulator
is set upwards.
Load the inlet tubing
through the nut
Install with the cold water supply
Connect the adapter and make
sure the rubber O ring is loaded

 

Push and squeeze the
tubing to the very end


STEP 2: INSTALL THE WATER PRESSURE REGULATOR
Please cut the 1/4" tubing into two sections( 1. Inlet tubing;
2. Outlet tubing) in proper length based on your need. Please
cut the tubing evenly, otherwise may result in water leakage.
STEP 3: CUT THE TUBING

Model: SP99
FRIZZLIFE INC. www.frizzlife.com
Page 5
1. Connect the other end of 1/4" supply tubing to the water pressure regulator at the
“Supply” end. Make sure the tubing hits the bottom of the fitting. Seal the connection
with a smaller blue clip.
2. Connect the “Filtered” end with the outlet blue tubing the same way.
Cut the tubing evenly 
Make sure the tubing hits very end.

STEP 6: CONNECT THE FILTER SYSTEM
STEP 7: INSTALL THE FAUCET
STEP 8: CHECK FOR LEAKS AND FLUSH THE FILTER
Mount the faucet to your sink top
Connect the faucet with the 1/4” quick fitting
Turn on all the water supply and check if there’ s any leaks on the connection
Flush the filter for 10 minutes before use
Connect the other end of 1/4” outlet blue tubing from the “FILTERED” into the 1/4” fitting.
1.95 5

Model: SP99
FRIZZLIFE INC. www.frizzlife.com
Page 6
CARTRIDGE REPLACEMENT


cartridge

cartridge and screw back in
Check for leaks
Turn the housing counter
clockwise，remove the housing


STEP 1: Shut off the water supply(Important!!);
STEP 2: Twist off the housing;
STEP 3: Using wrench to unscrew the housing body;
STEP 4: Take out the old cartridge and load with new one,
then install back the same way.
1
34
56
2
PERFORMANCE DATA
TROUBLE SHOOTING
1.Leaks at the threaded connection: if once the system leaks after installation,
please use plumber tapes properly on the threaded fitting to prevent leakage.
LIMITED WARRANTY
Substance
Influent challenge
concentration (mg/L)
Maximum permissible product
water concentration (mg/L)
Chlorine
Particulate, Class I
Particles 0.5 to <1µm
Lead
Cyst
2.0 mg/L ± 10%
>10,000 particles/mL
0.15 ± 10%
Min. 50,000/L
50%
85%
0.010
99.95%
TTHM（as chloroform）0.45 ± 20% 0.080

Model: SP99
FRIZZLIFE INC. www.frizzlife.com
Page 7
2.PPM is not dropping while tested by TDS meter: Frizzlife SP99 has a unique
technology that removes 99.99% of contaminants while leaving all the essential
minerals in water such as Calcium,Potassium,Sodium,Magnesium ect.
All healthy water has a certain level of total dissolved solids.they are essential
minerals.The TDS meters are not an effective way to measure the water quality,
the water without TDS is normally produced by reverse osmosis system.
LIMITED WARRANTY
1. Frizzlife is not liable for anything that we deem as abuse of the units, including but not
limited to, misuse of product outside of intended use, equipment modifications,
unauthorized repairs, improper installation, damage from freezing, hot water,
fire or other acts of God outside of Frizzlife control.
TWO YEAR LIMITED FRIZZLIFE WARRANTY
The Frizzlife SP99 under sink water filter units are warranted to the original
purchaser.
To be free of defects in material and workmanship by Frizzlife INC, Frizzlife
will replace or repair components of the unit that Frizzlife has deemed to be
broken within the limits of the warranty without charge. The customer is not
responsible for any freight involved with shipping the item back for inspection
and shipment of replacement items. Frizzlife is not liable for cost of removal,
installation, transportation or any other charges in connection with a warranty
claim.
SP99 3-Stage Under Sink Water Filter System
This warranty will be void if defects occur due to failure to observe the
following conditions:
Incoming water to the the system cannot exceed 100°F.
Do not use outdoors or in a location that is subjected to direct sunlight or freezing.
This warranty will not be effective unless and until the Frizzlife is shown to have
been used in accordance with the installation and maintenance instructions
accompanying the product.
2. Filter Cartridges are considered as disposable items, thus are not covered
by warranty.
3. Customer is responsible for proper operation, which includes complete and
continual leak inspection.

Model: SP99
FRIZZLIFE INC. www.frizzlife.com
Page 8
To receive warranty service, please contact Frizzlife at [email protected]
There are no other warranties which extend beyond what is described above.
Most of the unit components are made of plastic and eventually can break or
crack from stress.
1. Email us your order ID and full name at [email protected]
2. Scan the QR code below to register
150% Extended Warranty