Front Runner SSDS802 User manual

ENG
Rear Seat Deck Completion Set
SSDS802_REV_A01 © COPYRIGHT 2018 FRONT RUNNER VEHICLE OUTFITTERS 1
SSDS802
Mercedes Benz Gelandewagen
Thank you for purchasing a Front Runner Rear Seat Deck Completion Set.
Before you start, take a moment to familiarize yourself with the Fitting Instructions and the components received.
Refer to Page 2 for a list of all the components, quantities and tools required.
READ ME !
IMPORTANT WARNING!
IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD
RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT
RUNNER PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR AND
DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND PRECAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO
INSTALLATION OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY
FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.
NOTE: Front Runner will not be responsible for any damage caused by the failure to install the product according to these instructions.
Please call us if you have any questions about the installation of this product.

SSDS802_REV_A01 © COPYRIGHT 2018 FRONT RUNNER VEHICLE OUTFITTERS 2
IN THE BOX
FIGURE 1.1
1 1 X Deck LH
2 1 X Deck RH
3 14 X Button Head M6x12
4 18 X Spring Washer M6
5 2 X Flat Washer M6x19x1ss
6 1 X Pump Mounting Plate
7 4 X Nyloc Nut M5
8 2 X Nyloc Nut M6
9 2 X Electrical and Pluming Plate
10 6 X Channel Nut M6
11 2 X Z-Bracket
12 16 X Counter Sunk Screw M8x70
13 12 X Button Head M6x30
14 16 X Spacer OD 19 x ID 12.5 x 24 H
15 4 X Stand Off Floor Bracket
16 8 X Cage Nut M6
17 4 X Turn Nut M6
18 4 X Flat Washer M5
19 22 X Flat Washer M6
IN THE BOX
TOOLS NEEDED
9.5mm
5mm
IN THE BOX
8
12
2
13
3
5
15
17
16
9
4
3
5
8
4
10
10
11
20
4
3
13
4
20
18
4
5
1
6
4
7
9
1GET ORGANIZED
Here is what you are looking at for SSDS802
5mm
4mm 8MM
10MM

SSDS802_REV_A01 © COPYRIGHT 2018 FRONT RUNNER VEHICLE OUTFITTERS
3
FIT AND SECURE
2
2.2
2.3
2.4
2.1
2.1
2.2
2.3
Loosen the rear panel of the drawer and
slide 4 channel nuts (item 10) into the
bottom extrusion and 2 channel nuts into
the top extrusion. Tighten the rear panel
again after you are done.
Secure items 6 and 11 to the drawer using
the channel nuts and the fasteners shown
in 2.2.
Secure item 9 to the rear left and rear
right side of the drawer. To do this
you need to loosen the corner of the drawer
deck. Place item 9 in position and drill
a 6mm through the bottom hole of item 9
into the drawers side panel. Secure
with the fasteners shown.
4MM
6MM
10MM
4MM
10
4
3
5
4
19
6
11
3
19
8
3
59
Remove Corner Screw To Fit
Bottom For Drawer Shown

SSDS802_REV_A01 © COPYRIGHT 2018 FRONT RUNNER VEHICLE OUTFITTERS
4
FIT AND SECURE
2
2.2
2.3
2.4
2.1
2.4
2.5
2.6
Fix item 16 to item 1 with the fasteners
shown in 2.4. Repeat this on item 1.
Fit Item 1 and 2 to the drawer using the
fasteners shown. Use items 12 and 14
to align the deck with the existing seat
holes. Mark the holes in item 15 on the
vehicles floor. Remove the item 1 & 2 and
drill a 9.5mm hole on each of the marks
you have made.
Place item 17 in each of the holes you have
drilled, and use item 13 to set the turn nut
in place.
Do this by turning the screw in a few turns
and pulling it up toward you.
Remove the screw.
4MM
4MM
5MM
9.5MM
12
16
13
5
18
12
14
Mark holes on floor.
52
15
1
Take care when drilling through the floor
as the exhaust and fuel tank are beneath.
2

COMPLETION
3
3.1
Congratulations! You did it. Take a step back and admire your work!
SSDS802_REV_A01 © COPYRIGHT 2018 FRONT RUNNER VEHICLE OUTFITTERS
4
FIT AND SECURE
2
2.4
2.1
2.7
Refit the deck with the the fasteners shown
and fully tighten.
4MM
5MM
3
12
14
13
19
4
INSTALL OTHER VEHICLE AND RACK ACCESSORIES
4
Now's the time to visit your favorite Front Runner Dealer in person or online.
Be sure to tag us. We love to see our gear in action! #FrontRunnerOutfitters #BornToRoam
Share your adventures on: