FujiFilm ApeosPort-VII 4021 User manual

Prepared by Customer Training Team
© FUJIFILM Business Innovation Hong Kong Limited
ApeosPort®- VII 5021 / 4021
Quick Reference Notes –DAILY CARE
簡易操作 - 日常保養

CONTENTS
目錄
1Clear Paper Jam 夾紙排解....................................................................................................1
1.1 Duplex Automatic Document Feeder / 自動雙面送稿裝置 .............................................1
1.2 Tray 1 and Tray 5/ 紙盤 1及紙盤 5................................................................................2
1.3 Fusing Unit/ 熔著部組件.................................................................................................3
2Replacing Toner 更換碳粉匣.................................................................................................4

Page 1 of 4
1 CLEAR PAPER JAM 夾紙排解
1.1 DUPLEX AUTOMATIC DOCUMENT FEEDER /自動雙面送稿裝置
1. Open the document feeder left cover
until it stops.
1. 向上拉起自動送稿裝置左蓋把手，將左蓋
完全打開。
2. If the orginal is not caught in the entry
of the document feeder, pull out the
orginal.
2. 若原稿並未卡在送稿裝置的入口，將原稿
抽出。
3. Make Sure that the orginal is not torn,
wrinkled or folded, and then load the
orginal again following the instructions
displayed on the touch screen.
3. 確定原稿是否未撕破、起皺或摺疊，再依
照觸控式顯示面板中的指示重新方入原
稿。

Page 2 of 4
1.2 TRAY 1AND TRAY 5/ 紙盤 1及紙盤 5
1. Remove any paper from the Tray 5.
2. Pull Tray 5 out of the main unit.
3. Pull Tray 1 out of the main unit.
4. Remove any paper jammed in the
device interior.
5. Insert Tray 1 and Tray 5 into the main
unit completely.
1. 移除紙盤 5上面的紙張。
2. 把紙盤 5從機身拉出。
3. 把紙盤 1從機身拉出。
4. 把裝置內的卡紙移除。
5. 把紙盤 1及紙盤 5正確插入機身內。

Page 3 of 4
1.3 FUSING UNIT/熔著部組件
1. Lift the rear door release and pull open
the door.
2. Open the green tab of the fusing unit.
3. Remove any jammed paper.
1. 提起後蓋拉桿，拉開後蓋。
2. 打開定影組件的綠色把手。
3. 取出任何卡住的紙張。

Page 4 of 4
2 REPLACING TONER 更換碳粉匣
1. Make sure that the device is not
operating, and open the front door.
2. Pull out the toner cartridge slowly.
3. Shake the new toner cartridge gently.
4. Hold the cartridge with the arrow facing
up, and insert the cartridge slowly.
5. Close the front door.
1. 先確定裝置已經停止運作，然後開啟前蓋。
2. 慢慢拉出碳粉卡匣。
3. 輕輕搖晃新碳粉卡匣。
4. 把碳粉卡匣的箭咀標誌向上，然後慢慢地插
入卡匣。
5. 關上前蓋。

Customer Support Center
2513-2513
This document includes Fuji Xerox product(s), licensed from Xerox Corporation. The distributor of the product(s) is FUJIFILM Business Innovation Corp.
Xerox, Xerox and Design, as well as Fuji Xerox and Design are registered trademarks or trademarks of Xerox Corporation in Japan and/or other countries.
FUJIFILM and FUJIFILM logo are registered trademarks or trademarks of FUJIFILM Corporation.
ApeosPort and DocuWorks are registered trademarks or trademarks of FUJIFILM Business Innovation Corp.