Fulleon ASSERTA User manual

WARNING : On some tones the output level can exceed 120dB(A) @ 1m.
: Consult the relevant or appropriate health and safety regulations for guidelines.
Tones Table overleaf.
: Do not remove cover, refer servicing to qualified personnel.
: High voltage present within this equipment.
NOTE : Polar dispersion information available in the technical manual. (Ref:M03-003)
25-5643 Iss A
Dimensions
Ensure that guide
ribs are aligned.
(Top & Bottom)
2. Fixing Details
Mounting bracket.
(Optional extra)
NOTE: Ensure that the IP
integrity is maintained during
gland fitting.
(Take care not to disturb the
electronics while drilling.
Remove PCB if required)
Specification
Current Consumption
Construction
Operating Temperature
Tones
Operation
Operating Voltage Range
Sound Output @ 1m
Industrial Sounder (115Vac/230Vac)
0-80mA@115Vac
42 see table overleaf
-25°C to +75°C
ABS /PC Plastic Case
115Vac/230Vac 50/60Hz
Continuous
See table overleaf
168mm
168mm
155mm
1. Installation
3. Connection Detail
Knockout or drill required cable gland holes, and fix required
Fix base to wall in 4 positions.
115Vac/230Vac 110dB(A) 4. Sounder Settings
1. Volume Control
3. Switch 2 (Stage1 tone selection)
4. Switch 3 (Stage 2 tone selection)
1 42 3 5 6
OPEN
1 2 43
OPEN
5. Sounder Assembly
1. Plug the 5 way ribbon cable into the base header.
2. Ensure that the top indicator on the base is aligned with the
top indicator on the sounder, and push the sounder onto
3. Secure the sounder to the base using the bolts provided.
the base.
ASSERTA
Turn dial clockwise to increase volume.
(nominal 20dB Range)
2. Switch 1 (Time out setting)
OPEN
6532 41
See table overleaf.
See table overleaf.
(Stage 3 Tone is dependent on the setting of switch 2)
BIT 123X
111X
110X
100X
101X
Minutes
5
10
15
20
30010X
000X
001X ∞ 40
BIT 123X
011X
Minutes
25
Switch 1 bit 4 is to select voice (0)/ no voice (1). (Where fitted)
0 = Open
1 = Closed
1
2
3
4
cable glands.
0°
90°
Ingress Protection IP66
117mm
148mm
Stage 2
Stage 1
Stage 3
COM
L
N
L
N
0-40mA@230Vac
Maximum Power 9W
42 see table overleaf
115Vac/230Vac 50/60Hz
115Vac/230Vac 120dB(A)
ABS /PC Plastic Case
-25°C to +75°C
IP66
0-65mA@230Vac
0-130mA@115Vac
See table overleaf
Continuous
15W
NOTE: A readily accessible
disconnect device must be
incorporated in the mains
supply wiring to this unit.
Fuse 80mA Anti surge, 20mm 80mA Anti surge, 20mm
Hole positions for additional cable entries.
Knock outs for cable entries.
(Top & Bottom)
Set switch to correct
requirement for installation.
(115Vac or 230Vac)

Industrial Sounder Tones Table
A37 011011 A40 011000
010110 010111
A42 A41
011001 011010
A39 A38
A8 111000
A22 101010 A33 011111
011100 011101 011110
A35 A36 A34
100000 100001 100010
A31 A32 A30 A26 100110
100011 100100 100101
A28 A29 A27
100111 101000 101001
A24 A25 A23 A15 110001
101011 101100 101101
A21 A20 A19
110000 101110 101111A17
A18 A16 A11 110101
110100 110010 110011A13
A14 A12
110111 110110A10
A9 A4 111100
111011 111010 111001
A6 A7 A5
111111 111110 111101
A2 A3 A1
CODE
123456
No
A14
NF C 48-265Sweep 1400 to 1600 Sweep up 1s, sweep down 0.5s
Sweep up & down over 3s 0.7s On, 0.3 Off Steady Steady Sweep for 0.85s, 1s delay, repeat
500 to 1200
422 to 775Sweep
Continuous Continuous
Sweep
Intermittent
370 470 720
NFPA Whoop Air Horn (USA) German ind alarm Horn (USA) Siren A14
A14
A3 A3
A14
1HzSweep 1200 to 500 DIN/PFEER (PAPA) 3X500ms pulses followed by 1.5s silence then repeat 3X500ms pulses followed by 1.5s silence then repeat 2Hz (250ms-250ms)(Symphoni tones) 2Hz (250ms-250ms)(Squashni Micro tones) 3X500ms pulses followed by 1.5s silence then repeat
Intermittent 2850 4Hz (150ms On/100ms Off)
50Hz 50Hz Steady 1Hz Steady 1Hz (500ms-500ms) pulsed @ 0.625s 2Hz (250ms-250ms) Sweep 3.75s followed by 0.25s gap
300 to 1200
1000 & 2000
500 to 1200
Continuous
Alternating
Intermittent
Sweep
Alternating
Sweep
Continuous
Bell 420
510 &610
Bell
800 to 970
2400 to 2850
990 & 650 800 & 970
Intermittent
Continuous
Alternating Alternating
Sweep Sweep
Intermittent
2850 4000
970
2Hz (250ms-250ms) 0.5Hz (1s On/1s Off) 1Hz (500ms-500ms) 0.5Hz (1s On/1s Off) Steady 100ms-400ms 0.8Hz (250ms On/1s Off) 3.3Hz (150ms On/150ms Off) Steady 0.5Hz (1s On/1s Off) 1HZ (500ms-500ms) 0.05Hz (6.5s On/13s Off) 0.28Hz (1.8s On/1.8s Off)
Alternating 554 & 440
554 & 440
Continuous
Alternating
Intermittent Intermittent Intermittent Intermittent
660 660 660 660 660
2400 & 2850
800 & 970Alternating
Intermittent Intermittent
Continuous
Alternating
Intermittent
970 970
2850
970
Australian evac Australian alert Bell/US Temporal ISO 8201/US Temporal ISO 8201/US Temporal See attached for waveform details Singapore Swedish (Air raid) PFEER - Toxic gas Swedish (Turn out) Swedish (All clear) Swedish (Pre-mess) Swedish (Local warning) France NFS 32 S 32-001 Swedish PFEER alert
3s sweep, 0.5s silence, then repeat (rep)
TONE
Pattern 7Hz 7Hz (7/s) 1Hz (1/s) Steady 2Hz (250ms-250ms) 1Hz
800 & 970 800 & 970 800 & 970
2400 to 2850
500 to 1200
2400 to 2850
Continuous
Sweep
Slow Whoop
Sweep Sweep Sweep
Alternating
2850
FrequenciesDescription
Slow Whoop Netherlands Use
A14
A4
A14 A14
A4
A14
A8
A14 A14 A14
A1
A19
A4
A14
A4
A14
A4 A6 A4
A14 A14 A14
A3 A4
A14 A14 A14 A14 A14
STAGE 3
A14 A14
A9 A4
A14 A14
A4
118110
104 104 109
113 118 114
109 108 109 108 107 111 110 111 107 109 109 101
117 117 116 117 115 118 118 117 116 118 117 105 120112
107 109 106 109 105 106 106 107 106 106 106 106
118 112 110 110 117 115 116 115 115 114 115 115
109 108 107 109 108 108 111 111 105 103 106 112
119 117 118 112 117 118 113 109 119 110 111 120
111
115Vac/230Vac LP
dB(A)@1m
Stage 1 & 2
dB(A)@1m
120
115Vac/230Vac HP