Fulleon SQG3-23 User manual

0359-CPR-00438
3. Connection Details
1. Mounting Base 2. Sounder/ Beacon Assembly
Table 1. Specification
Technical Data 25-12947-A September 2014
Supply Voltage (Conventional) 18~35 Vdc
Cable Size/type 0.5~2.5mm / FIRETUF, FP200 or MICC
Current (High Volume) 11mA
Current (Low Volume) 8.7mA
Sound Output (High Volume) 90 +/- 3dB(A)
Sound Output (Low Volume) 80 +/- 3dB(A)
Operating Temperature -10 to +55ºC (95%RH)
Material ABS FR Plastic
Environmental Category Type A= IP21C
Tones 3, See section 4.
Flash Rate 0.5Hz (
Not applicable to FXN5023S )
Feature Value Feature Value
SQG3-23 Base Sounder VAD
Compliance EN54-3; EN54-23:2010
14
OUT IN
SCREEN ZONE OUT ZONE IN
+VE -VE +VE -VE
ZONE IN
ZONE OUT
Screen must be continuous
along entire length of loop.
50
60
70
80
(i) Knock-out the required
fixing holes.
(ii) Fix to mounting surface
using two suitable screws.
(iii) Please ensure all cable
entry points are sealed
appropriately.
If the base deforms on an
uneven surface, loosen the
screws or move to a flatter
position.
Flash On Period 60ms
www.acornfiresecurity.com
www.acornfiresecurity.com

7. Dimensions6. Fitting Detector
5. VAD Coverage Area
4. Switch Position Meaning
Eaton is a registered trademark.
All other trademarks are property
of their respective owners.
Technical Data 25-12947-A
September 2014
1, Sounder On/Off (AV version only)
2, Volume Hi (Off)/Low (On)
3, Tones
4, Tones
5, Mode: On = N/A* Off = Conventional
*Switch 5 must be set to ‘Off’ in order to operate
Continuous: 3=On, 4=On (910Hz)
Bell: 3=On, 4=Off (1440 Hz)
Alternating: 3=Off, 4=On (610 / 910 Hz)
{
30mm
Ø114mm
1 2 3 4 5
1
On
Off
Cross-section
View (metres)
Wall mounted 3D
View
Cross Section Plain
Product
SQG3-23
0.45
0.80
0.90
1.70
1.40
0.90
Dimensions in metres
Use M4 Screw to attach
the detector to the sounder.
Length to be determined by installer.
Base shown for illustration purposes only
www.acornfiresecurity.com
www.acornfiresecurity.com