GABBY GLENWOOD SCH-168200 User manual

SCH-168200 GLENWOOD NIGHTSTAND - BLACK
ASSEMBLY INSTRUCTION
HARDWARE :
PARTS :
Date: 08-01-2021 Page 1 of 4
F 4 Pcs
Feet
D 1 Pc
Body
HARDWARE INCLUDE :
A. 3- Bolt
B. 3- Shim Flat Washer
C. 1- Anti Tip Kit
I. 2 -Small Screw
II. 2- Large Screw
III. 2-Bracket
IV. 1-Retention Belt
PARTS INCLUDE :
D-1 – Body
E-1 – Back Splash
F-4 – Feet
E 1 Pc
Back Splash
A 3 Pcs
Bolt
( Tools Not Included)
Screw Driver
B 3 Pcs
Shim Flat Washer
C 1 Set
Anti Tip Kit

SCH-168200 GLENWOOD NIGHTSTAND - BLACK
ASSEMBLY INSTRUCTION
- Place the Nightstand on its back . Insert each Feet (F) into the given female receiving slots and
turn the Bun Feet clockwise into place.
- If the floor is uneven adjust the levelers located at the underside of the Feet, to do this lift Up
the side that need to be elevated to provide access to the levelers, turn the leveler until
adequate contact with the floor.
Page 2 of 4
Allen key
Step 1
Body
Feet
Option 1 – Without Back Splash
Step 2

Attach the Brackets (III) horizontally to the top of the back of the Nightstand using the Small Screws
(I).Screw the remaining Brackets (III) vertically 1 inch below the brackets attached to the Nightstand
using the large screws (II).The Large Screws (II) should be screwed into a stud in the wall. Align the
Brackets vertically and string in the Retention Belt (IV). Confirm Strap is securely laced and locked.
Page 3 of 4
SCH-168200 GLENWOOD NIGHTSTAND - BLACK
ASSEMBLY INSTRUCTION
III
II
I
IV
WALL
Step 3

SCH-168200 GLENWOOD NIGHTSTAND - BLACK
ASSEMBLY INSTRUCTION
Page 4 of 4
Attach the Brackets (III) horizontally to the top of the back of the Nightstand using the Small Screws
(I).Screw the remaining Brackets (III) vertically 1 inch below the brackets attached to the Nightstand
using the large screws (II).The Large Screws (II) should be screwed into a stud in the wall. Align the
Brackets vertically and string in the Retention Belt (IV). Confirm Strap is securely laced and locked.
Option 2 – With Back Splash
Step 4
AB
III
II
I
IV
WALL
Step 5
Shim Flat Washer behind plywood backing
-Insert the bolt (A) into the female receiving slots thru the hole of the plywood backing and thru the
Flat Washer Shim (B) then tighten with the Phillip screw driver.