GABBY JANICE User manual

JANICE CHEST
ASSEMBLY INSTRUCTION
HARDWARE : TOOLS NOT REQUIRED :
Page 1 of 3
HARDWARE INCLUDE:
1. 1 -Anti Tip Kit
A. 2 -Small Screw
B. 2- Large Screw
C. 2-Bracket
D. 1-Retention Belt
1 Anti Tip Kit
1 Set
Screwdriver

JANICE CHEST
ASSEMBLY INSTRUCTION
- Re-Tighten the bolt from inside of the drawers using Philip Screwdriver (not included). This can
to be done and check periodically to make sure the drawer pull are always tight.
- If the floor is uneven adjust the levelers located at the underside of the Leg, to do this lift Up
the side that need to be elevated to provide access to the levelers, turn the leveler until
adequate contact with the floor.
Page 2 of 3
STEP 1
Drawer
STEP 2
Leveler

JANICE CHEST
ASSEMBLY INSTRUCTION
Attach the Brackets (C) horizontally to the top of the back of the Chest using the Small Screws (A).
Screw the remaining Brackets (C) vertically 1 inch below the brackets attached to the Chest
using the large screws (B). The Large Screws (B) should be screwed into a stud in the wall. Align the
Brackets vertically and string in the Retention Belt (D). Confirm Strap is securely laced and locked.
Page 3 of 3
STEP 3
A
D
C
B
Wall