GABBY BURNETTE SCH-155290 User manual

No Part Descrip�on Qty
A
B
C
D
Flat Washer 8 pcs
8 pcs
4 pcs
1 pc
Parts Include :
No Descrip�on Qty
1Top and Panel
Side Panel
1 pc
2 pcs
KD Bolts 50 mm
Allen Key #4
Wood Stretcher 2 pcs
2
3
Spring Washer
Hardware Include :
Page 1 of 2
Date 20-07-2019
How to Assembly :
Require two persons to perform this assembly process.
STEP 1 :

Place KD Bolt M6 x 50 mm (C) with Flat Washer (A) and Spring Washer (B)
as per Detail 1, then use provided Allen Key #4 (E) to tighten the bolts at

STEP 2 :

soft cloth to prevent unecessary scratches. Carefuly place the assembled base
to the Table Top. Locate the connection holes at the base to the Table Top Apron.
Place the KD Bolt M6 x 35 mm (D) with Flat Washer (A) and Spring Washer (B)
as per Detail 2, then secure and tighten bolts with Allen Key (E). Carefully turn
KD Bolts 35 mm 4 pcs
E
False Tennon 4 pcs4
A
B
C
E
2
3
3
A
B
D
E
1
4
2
4
4
Detail 1
Detail 1
Detail 2
Detail 2


Page 2 of 2
Date 20-07-2019
STEP 3 :
To unflip the extension top parts, make sure the the support bar has been pulled to its maximum
lenght. Using the extension table top parts without the support bar may cause breakage on the table
hinge. To make sure the exten�on table part are stable, please adjust the leveller at the end of
support bar.
STEP 4 :
If the floor is uneven, please use the levelers located at the underside of the Leg, to do this lift up
the table side that needs to be adjusted, turn the leveler until adequate contact with the floor as
shown in Detail 4.
Detail 3
Detail 3
Detail 4
Detail 4