GABBY EVEREST SCH-170215 User manual

SCH-170215 EVEREST DRESSER
ASSEMBLY INSTRUCTION
HARDWARE :
PARTS :
Date: 17-9-2021 Page 1 of 3
HARDWARE INCLUDE:
A. 2 - Anti Tip Kit
I. 4 -Small Screw
II. 4- Large Screw
III. 4-Bracket
IV. 2-Retention Belt
PARTS INCLUDE:
B. 1- Body
C. 6- Feet
A. 2 Set
Anti Tip Kit
B. 1 Pc
Body
C. 6 Pcs
Feet

SCH-170215 EVEREST DRESSER
ASSEMBLY INSTRUCTION
- Place the Dresser on its back . Insert each Feet (B) into the given female receiving slots and
turn the Feet clockwise into place.
- If the floor is uneven adjust the levelers located at the underside of the Base, to do this lift Up
the side that need to be elevated to provide access to the levelers, turn the leveler until
adequate contact with the floor.
STEP 2
Leveler
Page 2 of 3
Body
Feet
STEP 1

SCH-170215 EVEREST DRESSER
ASSEMBLY INSTRUCTION
Attach Brackets (III) horizontally to the top of the back of the Dresser using the Small Screws
(I).Screw the remaining Brackets (III) horizontally 1 inch below the brackets attached to the
Dresser using the large screws (II).The Large Screws (II) should be screwed into a stud in the
wall. Align the Brackets and string in Retention Belt (IV). Confirm Strap is securely laced and
locked.
Page 3 of 3
STEP 3
I
IV
II
III