GABBY HAVANA User manual

HARDWARE INCLUDE :
1. 8 –washer
2. 8 –nuts
PARTS INCLUDE :
A. 1 –Top
B. 4 –Leg
HAVANA CONSOLE TABLE
ASSEMBLY INSTRUCTION
PARTS INCLUDE :
1. 1 - Top
2. 2 - Pedestal
3. 1 - Stretcher
HARDWARE INCLUDE :
A. 2 –Short Allen Bolt
B. 4 –Long Allen Bolt
C. 6 –Spring Washer
D. 4 –Flat Washer
E. 1 –Allen Key
F. 1- Anti Tip Kit
I. 2- Small Screw
II. 2- Large Screw
III. 1- Bracket
IV. 1- Retention Belt
PARTS:
HARDWARE:
Date: 5-03-2019 Page 1 of 3
1. 1 pc
Top
2. 2 pcs
Pedestal
E. 1 pc
Allen Key
D. 4 pcs
Flat Washer
B. JCBC M6 x 25mm 4 pcs
Long Allen Bolt
Side Shelf Base
A. JCBC M6 x 15mm 2 pcs
Short Allen Bolt
C. 6 pcs
Spring Washer
F. 1 set
Anti Tip Kit
3. 1 pc
Stretcher

Step
HAVANA CONSOLE TABLE
ASSEMBLY INSTRUCTION
- Put the two Pedestal side up down on a clean padded surface to avoid scratches.
- Insert both end of the stretcher into the metal pin of the pedestal.
- Insert the Bolt (A) with lock washer into the threaded metal pin and tighten with the Allen Key (E).
- Put the Top upside down on a clean padded surface to avoid scratches.
- Reverse the Pedestal and insert the tenon into the mortise of the top.
- Insert the Bolts (B) with complete washers into the female insert nut of the top and tighten with the
Allen Key. Page 2 of 3
Step. 1
E
D
C
B
Step. 2
A
C
E

__
HAVANA CONSOLE TABLE
ASSEMBLY INSTRUCTION
- If the floor is uneven adjust the levelers located at the underside of the pedestal, to do this lift Up
the side that need to be elevated to provide access to the levelers, turn the leveler until
adequate contact with the floor.
- Attach the Brackets (C) horizontally to the top of the back of the Table using the Small Screws (A).
Screw the remaining Brackets (C) vertically 1 inch below the brackets attached to the Table using
the large screws (B). The Large Screws (B) should be screwed into a stud in the wall. Align the
Brackets vertically and string in the Retention Belt (D). Confirm Strap is securely laced and locked.
I
II
IV
III
Step. 3
Step. 4