GABBY CHURST SCH-170235 User manual

SCH-170235 CHURST CABINET
ASSEMBLY INSTRUCTION
HARDWARE :
Date: 28-7-2021 Page 1 of 3
HARDWARE INCLUDE :
1. 2- Anti Tip Kit
A. 4 -Small Screw
B. 4- Large Screw
C. 4-Bracket
D. 2-Retention Belt
1. Anti Tip Kit
2 Set

SCH-170235 CHURST CABINET
ASSEMBLY INSTRUCTION
-To remove adjustable shelves, remove screw from shelf support, then carefully lift shelves up and
out of the case.To reposition adjustable shelves, insert Stem of shelf supports into Holes
in End Panel, as shown. Rest the shelf on the shelf supports, and reinstall screws
-If the floor is uneven adjust the levelers located at the underside of the Base, to do this lift Up
the side that need to be elevated to provide access to the levelers, turn the leveler until
adequate contact with the floor. Page 2 of 3
Step 1
Shelf
Screwdriver
Screw
Hole
Shelf Supports
Step 2
Leveler

Attach Brackets (C) horizontally to the top of the back of the Cabinet using the Small Screws
(A).Screw the remaining Brackets (C) horizontally 1 inch below the brackets attached to the Cabinet
using the large screws (B).The Large Screws (B) should be screwed into a stud in the wall. Align the
Brackets and string in Retention Belt (D). Confirm Strap is securely laced and locked.
Page 3 of 3
SCH-170235 CHURST CABINET
ASSEMBLY INSTRUCTION
Step 3
B
D
A
C
WALL