GABBY RHETT User manual

HARDWARE INCLUDE :
1. 8 –washer
2. 8 –nuts
PARTS INCLUDE :
A. 1 –Top
B. 4 –Leg
RHETT CABINET DOUBLE
ASSEMBLY INSTRUCTION
PARTS INCLUDE :
1. 1-Body Rhett Cabinet
2. 4-Adj. Shelf
HARDWARE INCLUDE :
A. 16 - Metal Supports
B. 16 - Screw JP.
C. 2- Anti Tip Kit
I. 4- Small Screw
II. 4- Large Screw
III. 2- Bracket
IV. 2- Retention Belt
D. 1 - L Screwdriver
PARTS:
HARDWARE:
Date: 26-10-2018 Page 1 of 4
1. 2 Set
Body Rhett Cabinet
2. 4 pcs
Adj. Shelf
( Tools Not Included)
Screwdriver
C. 2 Set
Anti Tip Kit
B. 16 pcs
Screw JP.
Side Shelf Base
A. 16 pcs
Metal Shelf Supports
D. 1 Pc
L Screwdriver

Step
RHETT CABINET DOUBLE
ASSEMBLY INSTRUCTION
- Remove Adjustable shelves from the body.
- To Install adjustable shelves, insert stem of shelf supports into holes in end panel, as shown. Rest
the shelf on the shelf supports, and screw. e shelf on the shelf supports, and reinstall screws
Page 2 of 4
Remove
Adjustable Shelf Left
Remove
Adjustable Shelf Right
STEP 1
STEP 2
STEP 2

__
RHETT CABINET DOUBLE
ASSEMBLY INSTRUCTION
-To Reposition adjustable shelves, un-screw the shelves from shelf supports, then carefully lift shelves
up and out of the case. Inserts stem of shelf supports into holes in end panel, as shown. Rest the shelf
on the shelf supports, and reinstall screws.
- If the floor is uneven remove the bottom drawer and adjust the leveler with a slotted L Screwdriver
through the hole of the base, (please see sketch) turn the leveler until adequate contact with the
floor.
Page 3 of 4
STEP 3
STEP 4
Drawer Stopper

RHETT CABINET DOUBLE
ASSEMBLY INSTRUCTION
Attach 2 Brackets (III) horizontally to the top corners of the Unit using the Small Screws (I).
Screw the remaining Brackets (III) into the wall vertically 1 inch below the previously installed brackets
using the Large Screws (II). The Large Screws (II) should be screwed into a stud in the wall. Align the
brackets vertically and string in the Retention Belt (IV). Confirm Strap is securely laced and locked.
Page 4 of 4
STEP 5
II
IV