GABBY EMBER User manual

EMBER DESK
ASSEMBLY INSTRUCTION
HARDWARE :
Date: 11-05-2019 Page 1 of 2
HARDWARE INCLUDE:
1. 2 - Anti Tip Kit
A. 4 -Small Screw
B. 4- Large Screw
C. 4-Bracket
D. 2-Retention Belt
1 Anti Tip Kit
2 Set

EMBER DESK
ASSEMBLY INSTRUCTION
- If the floor is uneven adjust the levelers located at the underside of the Leg, to do this lift Up
the side that need to be elevated to provide access to the levelers, turn the leveler until
adequate contact with the floor.
Attach the Brackets (C) horizontally to the top of the back of the Desk using the Small Screws (A).
Screw the remaining Brackets (C) vertically 1 inch below the brackets attached to the Desk using
the large screws (B). The Large Screws (B) should be screwed into a stud in the wall. Align the
Brackets vertically and string in the Retention Belt (D). Confirm Strap is securely laced and locked.
Page 2 of 2
STEP 2
STEP 1
Leveler
D
C
B
A
Wall