Garland INT10G10SP1 User manual

User Guide
RegenTAP: Dual Breakout | INT10G10SP1 | 4.22.1
This document describes the front panel, LED indications, interfaces, rear panel, installation procedure
for the INT10G10SP1. The unit supports two span applications in a single chassis.
Front Panel
LED Indications
PS2 Power Supply 2 LED
PS1 Power Supply 1 LED
SYS System LED
Up Arrows SFP Ports 1-9 Link/Activity LEDs
Down Arrows SFP Ports 2-10 Link/Activity LEDs
Interfaces
Port 1 Network Port Ingress Span Port 3 / Port 5 / Port 7 / Port 9
Port 3 Span Port Ingress Port 1
Port 5 Span Port Ingress Port 1
Port 7 Span Port Ingress Port 1
Port 9 Span Port Ingress Port 1
Port 2 Network Port Ingress Span Port 4 / Port 6 / Port 8 / Port 10
Port 4 Span Port Ingress Port 2
Port 6 Span Port Ingress Port 2
Port 8 Span Port Ingress Port 2
Port 10 Span Port Ingress Port 2
Garland Technology | 716.242.8500 | garlandtechnology.com/support
Copyright © 2022 Garland Technology, LLC. All rights reserved. 1

User Guide
RegenTAP: Dual Breakout | INT10G10SP1 | 4.22.1
Rear Panel
PS 1 Fan 1
Fan 2 PS 2
Installation Procedure
1. Connect power cables to PS1 and PS2 on the rear panel and plug into available power sources.
2. Verify that the PS1 LED and PS2 LED on the faceplate are illuminated.
3. Verify that the SYS LED on the faceplate is illuminated.
4. Connect the network ports for span1 and/or span2 to the desired sources.
5. Verify the link LEDs are illuminated indicating link.
6. Verify the activity LEDs are flashing indicating traffic.
7. Insert 10G SFPs into the desired monitor ports. This step can be done prior to power on if desired.
8. Connect the span ports for span1 and/or span2 to the desired source.
9. Verify the link LEDs are illuminated indicating link.
10. Verify the activity LEDs are flashing indicating traffic.
Garland Technology | 716.242.8500 | garlandtechnology.com/support
Copyright © 2022 Garland Technology, LLC. All rights reserved. 2